Question about Honda CR-V

1 Answer

On the dashboard of my hunda cr-v, 2002 model, when i turn on the engine the letters SRS come on, stay for a few seconds and go off. I do not remember seeing this before. as i have no manul and bought the car 2 months ago, I would like to know what SRS means. please and thank you

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 404 Answers

SRS-seatbelt response system, is a part of your airbag system and braking system, once you hit brakes very hard SRS makes sure that the belt is getting tight, in case of collision seatbelt gets stiff and the airbag blows up. SRS light coming on and staying for few seconds is fine as computer is checking the system, once it stays on or flashes you need top go to a garage as you might get a surprise blow in the face by the airbag.

Posted on Aug 26, 2010

Testimonial: "ta so much"

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Engine light on & dashboard light says trans fluid


Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, TCM, SRS and BCM faults and others) as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Legend of Abbreviations. ABS Antilock brake system.TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module

Oct 22, 2012 | Cars & Trucks

1 Answer

Reset SRS indicator light


Unfortunately, the only way you can clear codes on a post 1996 car is to have a scanner. You can either get the error cleared at a local shop where most of the time they will do it for free. If not, you should be able to buy a hand scanner from a local parts store like NAPA. Unfortunately, the latter solution is pricey.

Jul 22, 2008 | 2002 Honda CR-V

1 Answer

How do I get my 2002 Acura RSX SRS dash light off?


check for bad fuse under the hood or dash

Jul 24, 2012 | 2002 Acura RSX

1 Answer

Srs light


Contrary to popular belief, the dashboard SRS light CAN be reset without the need for a Rover dealer! All that is needed is a paperclip.
  1. Directly under the steering wheel, just under the bottom of the dashboard and above the pedals, there should be a wide grey connector.
  2. A few inches towards the driver's door from this, there should be a horizontal 2-pin yellow connector (with nothing connected to it).
  3. Bend the paperclip into a u-shape, and push the ends into the 2-pin yellow connector (shorting the pins).
  4. Turn on the ignition, and the SRS light should illuminate for a few seconds and then go out.
  5. Now pull out the paperclip (but not completely out), breaking the link.
  6. After a couple more seconds, the SRS light should illuminate again.
  7. Now push the paperclip back in, making the link again.
  8. After a couple of seconds, the SRS light should blink twice.
  9. Remove the paperclip, and then switch off the ignition.

That resets the SRS system and next time you start the car, the lamp should be off.

The above all needs to be carried out fairly quickly as you only get a few seconds between each step.

Note:
Because you can't see the yellow connector and the SRS light at the same time, it's really a two-person job.

Important:
Obviously this only applies if there is no fault! If there is a fault, the light will illuminate again and will therefore need to be looked at by a Rover dealer.

This procedure is pretty tricky, but it is 100% correct.

Nov 01, 2017 | 1998 Rover 400

3 Answers

What does the red light on the bord with letters SRS means? It stays on for few seconds after I start the car (Honda accord 1995). Thank you


srs means secondary restraint system. e.g air bags and things like that. when it stays on for a few seconds its because it is doing a systems check. if the light stays on all the time then there is a problem. hope i helped.

Jan 28, 2010 | 1995 Honda Accord

1 Answer

'02 S60, A warning stays on


you need to take it to volvo dealer to reset the light srs detects low battery voltage and turns on the light

Aug 17, 2009 | 2002 Volvo S60

2 Answers

SRS light stays on


The Supplemental Restraint System (SRS) is definitely something you want working. Those airbags can be a lifesaver in an accident. Take it back to the Dealer and tell them it wasn't broke before they worked on you car, it's broke now after they worked on it, and stress how much of a Liability this might be. Okay, okay... just ask them to fix it because you would like to have it in case you are involved in an accident. My Civic's Service Repair Manual (from Honda), says Take it To Your Dealer (see below)
===========================================
All SRS electrical wiring harnesses are covered with yellow insulation. Related components are located in the steering column, front console, dashboard, dashboard lower panel, and in the dashboard above the glove box.
Do not use electrical equipment on these circuits.

-WARNING
To avoid rendering the SRS inoperative, which could lead to personal iniury or death in the event ol severe frontal collision, all SRS service work must be pertormed by an authorized Honda dealer

Jul 18, 2009 | 2002 Honda S2000

1 Answer

Honda crv 2000 computer reset


Ok,
1. ensure ignition off
2 . bridge the 2 pin connector, Put a piece of wire across both terminals
3.switch ignition on
4. SRS lamp should illuminate for 6 seconds
5.disconnect the bridge wire within 4 seconds of the warning lamp extinguishing
6.SRS lamp should illuminate 2 times, Codes erased
7.switch ignition off
8 Wait 10 seconds. switch ignition on and check SRS warning lamp operation.
hope this helps

Feb 18, 2009 | 2006 Honda CR-V

1 Answer

ABS SRS BRAKE LIGHTS


I watched a video on resetting the airbag indicator for HONDA civic. It seems a simple thing to do. have a look at the video. It may be helpful.

fr.truveo.com/How-to-Reset-SRS-Airbag-Indicator-Light/id/3118442620 - 85k -

Oct 21, 2008 | 2002 Honda CR-V

1 Answer

The SRS light stay on


SRS stands for supplemental restraint system. You have a problem with the airbag system. The seat belts have sensors to let air bag module know if they are buckled. Could be a bad buckle seat belt will work fine .This may be a common problem is why they said seatbelt problem

Sep 05, 2008 | 2002 Honda CR-V

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

301 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

78919 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...