Question about 1986 Toyota 4Runner

1 Answer

There is no power onthe fuel pump,all fuses good

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 220 Answers

Not sure where it is but more than likely a relay for the fuel pump is the problem. Check under the hood.

Posted on Aug 26, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My car will not start it cranks but will not turn on. So far I have changed the crank sensor I also have no spark to coil packs or spark plugs Fuel pump does not turn on when I turn the key. What is the...

Begin by checking fuses. Ignition, efi, fuel pump fuses. When key turned to on, do the warning lights and gauges work? That verifies switch has power and is sending power out. With key on, the coil primary wire to coil packs should have voltage.

No spark and no gas? Fuel pump fuse good? I think I would use a test light or multimeter to check that fuel pump fuse terminal has power to it with key on. If that's good, pull connector off at fuel tank and check for a voltage signal on fuel pump wire when the engine is cranking-if good signal, fuel pump needs taken out for replacement or inspection. If no signal check that fuel pump relay has power to it. With key off, pull the relay and check that one terminal has power to it-the feed wire for the pump. If no power signal at all, check maxi fuses or fusible links for a failure.

Sep 04, 2013 | Cars & Trucks

1 Answer

Where is fuel pump reset switch on 2002 chevy impala

There is no reset switch you either have a bad fuse ,relay which is under the hood in the fuse box which will be marked onthe cover,or the pump is shot which is in the fuel tank.

Apr 20, 2011 | 2002 Chevrolet Impala

3 Answers

No power to fuel pump car was running fine just quit repalced fuel pump no power to pump, car will start when spraying starting fluid in to intake, is there a fuse ? also replaced ECM, fuel filter,...

Check for 12 volts power at the fuel pump harness. If no power is going to the pump, check the fuel pump relay. Also, check the fuel pump inertia switch. Ford usually has it on either inside left or right rear trunk fenders.

Apr 09, 2010 | 1987 Ford Taurus

2 Answers

No voltage in ignition circuit or 5v reference wires. 95 Cutlass

Always picture in your mind how an automobile is wired up. Every single one of them would have a fuse box. Engineering rules the fuses must be as close as possible to the power source which is the battery. Now you have main fuses which may also be called fusible link. These big fuses carry along with them sub fuses which may power the ignition system, the fuel pump and vice versa. Some fuses will not have power in them unless the key is in the on position. Some would have twelve volts all the time, and some will have power in them only if a device is turned on, An example of that is the headlight fuse. All fuse in the fuse box have one thing in common. If for example you turn on the key and there is no power to the fuse that supply the ignition system then find a good size wire that supply 12volts only when the igntion key is on, and tap it somehow to that fuse. Make sure you are tapping to the right side of the fuse so that it still protect the circuit. In electrical troubleshooting you can do this instead of going crazy trying to find where the break in the wiring is. Does it even matter? No as long as there is a fuse to protect it, and makes the circuit work normally then it doesn't matter. Remember this is not mechanical stuff. Just stick to supplying power to the fuses, do not supply power anywhere else.

Nov 23, 2009 | 1995 Oldsmobile Cutlass Ciera

1 Answer

New relay an new fuel pump no fire goin to fuel pump

Check fuel pump fuse, remember fuse send power to relay and relay sends power to pump, Check power wires to pump and make sure FUEL PUMP FUSE IS GOOD if not replace and take care of this problem. Good luck and thanks for using FIX YA.

Mar 25, 2009 | 1990 Ford F150

2 Answers

1999 dodge ram 1500 pu

check the power wires onthe stereo and make sure they go to a power source other thanfuel system they should go to the 12 V. power source and the acc. line. if the stereo system has a amplifier it could be to close to something in the fuel electrical system and emf's (electro magnetic field) is messing with it try moving the amp to another location away from any wiring systems especially the computer brain. hope this helps.

Mar 21, 2009 | 1999 Dodge Ram

2 Answers

Won't start. Battery has full charge and fuses good

You have a switch onthe side of your trans..that lets your ecm know when you are in P or N., Or possible starter.

Jan 01, 2009 | 2001 Chevrolet Silverado 1500

2 Answers

No fuel??

Fill the fuel maybe?

Jun 22, 2008 | 1991 Suzuki Sidekick

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

106 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides