Question about 1998 Jeep Grand Cherokee
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
common problem with these roof racks check for loose bolts holding it on also there are inserts pressed into your roof under the roof rack these threaded insrts tend to come loose or get pulled out use silocone sealant around every bolt and insert.
Posted on Sep 19, 2009
it is located at the back of the engine on top of the transmission bell housing,the plug runs over to the passenger side of the engine bay and it comes out from behind the engine,you can actually get your hand on the sensor itself from under the hood on the drivers side,and i believe its a 13mm bolt holding it in,the new sensor will have a sticker on the end of it...leave it there,it is used for correct spacing between the sensor and the flywheel,hope this helps
Posted on Sep 23, 2009
Testimonial: "Everything was just like you said but as a not atleast for my jeep it is an 11mm not 13mm. Works great so far (keep fingers crossed) "
Review this links:
- WJ Section 24 Heating Air Conditioning ewj24 (page 32 and next)
- WJ Section 08w Wiring Diagrams ewj8w
* page 19 Index
* page 221 Blower Motor - Diagram 8W-42
- Blower Motor Repair
I hope help you with this (rated this help) Good luck.
Posted on Sep 30, 2009
First, if the noise is from the upper part of the engine and is more of a tapping than a knock, likely you have a problem in the valvetrain, most often a bad lifter or worn rocker arm. If the noise is low, deep inside, the noise is from a bearing. This is generally accompanied by lower than normal oil pressure. Regardless of the underlying cause, correcting the cause will not stop the knock. To do that correctly, the engine needs to be removed and all crankshaft bearings and the crankshaft itself need to be replaced (crank can sometimes be "undercut" and thicker bearing shells can be used depending upon the amount of wear.) If caught very early, sometimes only one bearing can be replaced in-car, but in 99% of all cases I have ever seen, most will fail again, sometimes more severely if done this way.
Posted on Dec 10, 2009
Tips for a great answer:
Sep 29, 2016 | 1999 Jeep Grand Cherokee Limited
Apr 25, 2015 | 1996 Jeep Grand Cherokee
Dec 01, 2014 | 2001 Jeep Grand Cherokee
Nov 26, 2013 | 1995 Jeep Grand Cherokee
Jan 16, 2013 | 2001 Jeep Grand Cherokee
Jul 06, 2012 | 2004 Jeep Grand Cherokee
Jan 04, 2010 | 1998 Jeep Grand Cherokee
Mar 30, 2009 | 2004 Jeep Grand Cherokee
Oct 23, 2008 | 1996 Jeep Grand Cherokee
50 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: