Question about Geo Metro

1 Answer

93 geo metro 3 cyl 5 speed standard will not start! No starter noise, the battery is full and there is a clicking coming from the major fuse box under the hood. Sometimes the clutch will not let the car start so we are thinking that the clutch safety switch is stuck. Where is this switch located? Please help asap

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Geo Master
  • 8,826 Answers

Adjustment procedure from AutoZone.com indicates iswitch is just in front of the pedal arm under dash. Recommend you pull the connector and place a shorting wire between the terminals in the connector to see if the car will start.


CLUTCH START SWITCH

  1. Apply the parking brake firmly and place the gear shift lever in N position.
  2. Disconnect the lead wire at the switch.
  3. Loosen the locknut and screw the switch out.
  4. Depress clutch pedal all the way to the floor and then return it back 0.4-1.1 in. along its travel from the floor.
  5. Connect an ohmmeter to the switch and slowly screw the switch in until the switch is ON . Hold the switch at this position and tighten the locknut to 8-11 ft. lbs. (10-15 Nm).
  6. Connect the lead wire.

Posted on Aug 25, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

93 Geo Storm 5 speed 1.6 engineProblems starting Change the ignition checked fuses starters good new battery Occasionally will still start with key but most of the time have to push


Replace the starter.This starter has contacts ,instead of starter brushes and they will do this over time but will check good on bench test.

Nov 01, 2014 | Cars & Trucks

1 Answer

I have a 1996 Geo Metro LSI car won't start, no clicking noise but lights come on


  • sure it won't crank the engine , starter motor just clicks !
  • try using jumper cables, and crank, off a running car.?
  • Fuses all good.? test them?
  • battery terminals clean, never green?
  • A/T transmission? did you wiggle shifter, as you crank it.?
  • a/T trans, did you try starting in neutral?
  • M/T trans did you press clutch pedal harder as you cranked it over? (repeat say 3 times, see if this makes it crank)
  • try a good battery from a good car? in your car.
  • charge your battery. using a battery charger..
  • Does hot wiring the starter solenoid , make it crank over?

Oct 26, 2014 | 1996 Geo Metro

1 Answer

My 93 Geo Metro 3 cylinder 1 liter 5 speed fluids


6 posts. same out word.
what fluid, gasoline, water, oil , what? from WHERE?

Sep 24, 2014 | 1993 Geo Metro

1 Answer

Geo jerking under acceleration


They come with a 3 or 4 cyl engine, but either way it would not take much to make it run rough.
Usually a miss-fire under load is ignition related.
Have you checked or replaced the plugs, cap, rotor, and wires ?
If not I would start with an inspection of that first.

Sep 14, 2012 | 1997 Geo Metro

1 Answer

Wher is all fuse boxes on 97 geo metro


zjlimited_506.gif

Fig. 2: Under dash fuse box location


zjlimited_507.gif



Fig. 3: Engine compartment fuse/relay box location



Hope helps (remember to rate and comment this answer).

Jul 21, 2011 | 1997 Geo Metro

3 Answers

97 Geo Metro will not start


it sounds like the battery charge battery and load test after you get it running check charging system

Aug 26, 2009 | 1997 Geo Metro

2 Answers

Battery drain


Have you tried removing various fuses?? That will give you an indication of where the trouble lies, there should be a drawing of what the fuse protects when you find the offending cicuit which should help iscolate the offending component. I bet you find it`s something that someone has added eg reversing sensors, Aircon clutch is a common culprit. Good luck, Ian

Aug 09, 2009 | 1994 Geo Metro

2 Answers

93 Geo Metro


As long as they are the same type of engine ( I believe they should both be 1.0L 3 cyl engines). Most parts for the Geo Metro from 1992 to 1994 interchange with out a problem.

Nov 10, 2008 | 1993 Geo Metro

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

298 people viewed this question

Ask a Question

Usually answered in minutes!

Top Geo Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Mike Gilbreath

Level 1 Expert

50 Answers

Are you a Geo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...