Question about 2001 Jaguar S-Type

1 Answer

How do you remove ignition coil from Jaguar S-Type.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jaguar Master
  • 17,970 Answers

3.0L EnginesHow do you remove ignition coil from Jaguar - e8397ec.jpg

Fig. Removing ignition coil plug-3.0L Engines

  1. Before servicing the vehicle, refer to the Precautions Section.
  2. For the right hand bank, remove or disconnect the following:
    Negative battery cable Intake manifold Electrical connector Ignition coil securing bolt Ignition coil
  3. For the left hand bank, remove or disconnect the following:
    Engine cover Electrical connector Ignition coil securing bolt Ignition coil
  4. To install, reverse removal procedure.

Hope helps (remember rated and comment this).

Posted on Aug 26, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replacing coil pack on jaguar s-type 4.0 engine


remove coil covers remove 8mm headed fixings run engine and lift coils one at time off the plugs slightly and listen! or easier get someone with a obd code reader but be carefull you get the right one has the cylinder numbering changed 2004 i think

Apr 17, 2013 | Jaguar S-Type Cars & Trucks

1 Answer

P0354 Ignition Coil D Primary/Secondary Circuit Malfunction This is what the scantool came up with on my 2001 Jaguar s-type 3.0 Car has been idling funny but will get cruising on the highway.


this code is saying you have a failing ignition coil..You will have to swap them and determine which one is failing...here is the procedure.. DTC P0354; RANDOM MISFIRE DETECTED, MISFIRE DETECTED, (CYLINDERS 1-8) IGNITION COIL PRIMARY CIRCUIT MALFUNCTION, (CYLINDERS 1-8)

G290076t1 : CHECK COIL FUNCTION BY SUBSTITUTION
  1. Swap the suspect coil for a known good unit.
  2. CLEAR the DTC. TEST the system for normal operation.
- Does the same DTC reoccur? The DTC will indicate if the same cylinder is misfiring. -> Yes
INSTALL a new coil. CLEAR the DTC. TEST the system for normal operation.

-> No

G290076t2 : CHECK THE IGNITION COIL SUPPLY VOLTAGE CIRCUIT
  1. Disconnect the relevant ignition coil electrical connector(s), (PI02 to PI09).
  2. Turn the ignition switch to the ON position.
  3. Make sure the ignition relay is energised.
  4. Measure the voltage between:
- Is the resistance greater than 5 ohms? -> Yes
REPAIR the high resistance circuit. CLEAR the DTCs. TEST the system for normal operation.

Sep 19, 2011 | 2001 Jaguar S-Type

1 Answer

X300 jaguar 1997 Battery is good crankshaft good ignition problem just a small fire one second


Go behind the ignition coil it uses a ignition module it is a GM type (made by GM) just replace it

Aug 21, 2011 | Jaguar XJ Cars & Trucks

1 Answer

2004 jaguar xj8 will not start. The engine turns over but will not start. The problem started when I checked the fuse to the gear-shift.


SOUND LIKE YOU REMOVE OR BLOWED THE IGNITION COIL FUSE BY MISTAKE. OR YOU HAVE PCM PROBLEMS.FOR THIS TYPE OF VECHICLE BEST TO CODE SCAN TO LKKO FOR ANY FAULT CODES.

Apr 12, 2011 | 2004 Jaguar X-Type

1 Answer

Engine missfire


Get your local garage to put a scanner on the car. The early s-type used to suffer from ignition coil faults. If a fault has been hinted towards a specific coil then swap to a different cylinder and see if the fault follows wich will indicate a coil fault.

Has the vehicle had its spark plugs changed? every 70.000 miles as they tend to fail if left unchanged. Intake manifold requires removing to replace bank 1 plugs.

Also check the small rubber elbow on the end of the plastic beather pipe wich runs throught the intake manifold branches. Elbow is located at the rear of the engine

Hope that helps

Feb 20, 2010 | 2000 Jaguar S-Type

3 Answers

Code po302 2002 jaguar s-type. rough idle.


P0302= # 2 cylinder misfire,
check plug,plug wire,injector or coil

Dec 26, 2009 | 2002 Jaguar S-Type

2 Answers

Missfire on number 3 coil on 2001 S type Jaguar 3.0 V6 Sport


Check the igniter module.
I assume you have a ecu code telling you #3 coil is missfiring ?
If so also check the crankshaft angle sensor .
If it is not an error code do a compression test and check the injector.
Hope this helps
Regards
George

Jul 08, 2009 | 2001 Jaguar S-Type

2 Answers

Remove Ignition Coils


look carefully must have a screw or a bolt somewhere

May 30, 2009 | 1998 Jaguar XJ8L

2 Answers

How do i put a coil in a 2001 jaguar s type


303-07A: Engine Ignition — 3.0L (4V) 2001 Lincoln LS Workshop Manual DESCRIPTION AND OPERATION Engine Ignition The electronic ignition (EI) system is a coil-on-plug (COP) ignition system.
---------------------------------------------------------------------------------------
SECTION 303-07B: Engine Ignition — 3.9L 2001 Lincoln LS Workshop Manual
DESCRIPTION AND OPERATION Engine Ignition The electronic ignition (EI) system is a coil-on-plug (COP) ignition system
-----------------------------------------------------------------------------
v-8
SECTION 303-07B: Engine Ignition — 3.9L 2001 Lincoln LS Workshop Manual
REMOVAL AND INSTALLATION Ignition Coil Removal
  1. Remove the air cleaner outlet tube. For additional information, refer to Section 303-12 .
  1. Remove the bolts and the ignition coil cover.
7b000cd.gif
  1. Disconnect the electrical connector from each ignition coil.
a1d93dd.gif
  1. Remove the ignition coils.
    1. Remove the bolts.
    1. Remove the ignition coils.
------------------------------------------------
v-6

SECTION 303-07A: Engine Ignition — 3.0L (4V) 2001 Lincoln LS Workshop Manual
REMOVAL AND INSTALLATION Ignition Coil Removal
  1. Remove the engine appearance cover.
  1. To access the RH bank ignition coils, remove the upper intake manifold. For additional information, refer to Section 303-01A .
  1. Disconnect the electrical connector from the ignition coils.
  1. Remove the bolts.
  1. Remove the ignition coils.
please rate as fixed if this helps.

Apr 28, 2009 | 2001 Jaguar S-Type

1 Answer

Where do I find the spark plugs on the Jaguar S Type 2L year 2000 engine.?


hey familyvanark,

Your spark plugs are located under your ignition coils. The first three are located on the passenger side underneath the three ignitions coils, im pretty sure the coils are held on my an 8mm bolt. The other three are on the driver side, and are located under the intake manifold, that big medal thing on the top on your engine and white in color. That HAS to come off to get to the other three spark plugs. Other than that take those three coils off and you'll see them.

Mar 14, 2009 | 2000 Jaguar S-Type

Not finding what you are looking for?
2001 Jaguar S-Type Logo

Related Topics:

325 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76109 Answers

SPEEDY CAR WORK SHOP...

Level 2 Expert

489 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...