Question about 1988 Toyota Corolla 4 Door

1 Answer

How to remove the window driver side of toyota corrola 1988

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Toyota Master
  • 17,970 Answers

Door Glass and Regulator - REMOVAL & INSTALLATION
Front Door

  1. Disconnect the negative battery cable.
  2. Remove the front door panel to gain access to the regulator assembly.
  3. Remove the service hole cover.
  4. Lower the regulator until the door glass is in the fully open position.
  5. Remove the two glass channel mount bolts.
  6. Pull the glass up and out of the door.
  7. Unbolt and remove the inside door panel frame if so equipped.
  8. If equipped with power windows, disconnect the electrical connector.
  9. Remove the equalizer arm bracket mounting bolts.
  10. Remove the window regulator mounting bolts and the regulator (with the power window motor attached) through the service hole.
To install:
  1. Coat all the window regulator sliding surfaces with multi-purpose grease.
  2. Place the regulator (with the power window motor) through the service hole and secure with the mounting bolts. tighten the bolts to 48 inch lbs. (5 Nm). Attach the power window harness if equipped.
  3. Place the door glass into the door cavity.
  4. Connect the glass to the regulator with the channel mount bolts.
  5. With the equalizer arm, raise the glass to the almost closed position and make sure that the leading and trailing edges of the glass are equally distant from the top of the glass channel. If not, adjust the equalizer arm to achieve an even fit.
  6. Install the service hole cover.
  7. Install the door panel and reconnect the negative battery cable. Check window and door for proper operation.

Hope helps (remember rated and comment this).

Posted on Aug 25, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

TOYOTA CORROLA 2003 CENTRAL LOCK doesnot allow to start


as a temp fix to get vehicle started try removing the central locking fuse from the fusebox lower dash drivers side, the cover/lid will give the fuse's location . The OBD codes will need to be read to find the sensor/switch causing the problem for a permenant repair, hope this helps keep me posted if you wish

May 12, 2014 | 2003 Toyota Corolla

1 Answer

Where is the assist kick panel on a 94 corrola


Apparently the "assist kick panel on a 94 corrola" is: bottom foot well on either passenger or driver side

May 13, 2011 | Toyota Corolla Cars & Trucks

1 Answer

What type of engine has EE 96 v toyota corrola wagon car. this was manufactured in 1988


Evey morning I have very difficult to start my vehcle.My vehicle id Toyota Corrola ee96.please send the answer to kosalakandy@gnail.com

Thanks

May 31, 2010 | 1988 Toyota Corolla 4 Door

1 Answer

1988 Pickup: 1988 toyota pickup wiper arm removal????...


Remove the cover located at windshield base with flatblade screw driver or other prying device. Remove retaining bolt, then while prying under wiper arm where it is attached to wiper motor shaft, wiggle wiper arm side to side and up & down. Don't be scared.

May 18, 2010 | 1988 Toyota Pickup

1 Answer

How do i open the truk of my 98 toyota corrola?


There is a lever to open the trunk next to the fuel door lever under the left front side of the driver seat.

If the lever is broken or missing, check if the back seats recline, allowing access to the trunk. Crawl in and pull the lever going to the lock cylinder.

If neither suggestion works, call a locksmith.

Dec 04, 2009 | 1998 Toyota Corolla

1 Answer

Need a FUSE BOX DIAGRAM 2005 TOYOTA CORROLA


DONT NEED COVER JUST TURN KEY ON USE TEST LIGHT TO CHECK FUSES IF YOU HAVE POWER ON ONE SIDE OF FUSE SHOULD BE ON OTHER SIDE IF NOT REMOVE AND INSPECT (PLEASE RATE THIS)

Apr 19, 2009 | 2005 Toyota Corolla

1 Answer

'88 toyota camry rear window stuck in down position


To get to the Window:

Remove Door Inside Handle:
remove screw, slide the handle forward.
Disconnect the control link and remove the handle.

Remove Door Trim with Inner WeatherStrip:
Remove the two screws from the armrest.
Insert a screwdriver between the trim retainers and the door panel to pry it loose.  Eight hidden fasteners. 1 top left side of door.
1 right side about same height as top of armrest. 1 (each side) about same height as bottom of armrest. 1 on each corner bottom. 1 bottom in middle.  1 on left side between bottom corner and the previous at about lower armrest height...

Remove Service Hole cover.
Remove Door Glass Run.

Remove Division Bar (upper window section divider):
Remove the two screws under the weatherstrip
Remove the bolt.
Pull out the division bar.

Remove the Window Glass:
Place the glass in the door cavity.
Remove the two glass channel mounting bolts.
Remove the window glass by pulling it upwards.

You now have access to the Power Window Regulator; possible replacement of motor etc.

What type of 'things' have you tried for fixing the window and restoring operation?

Jan 22, 2009 | 1988 Toyota Camry

1 Answer

Cambelt change


went and got a manaul

Jan 11, 2009 | 1988 Toyota Corolla 4 Door

1 Answer

Trying to remove driver side interior door panel on '88 Toyota PU


There is a cotter pin in the window crank, a pair of needle nosed pliers should be able to grab it

Dec 02, 2008 | 1988 Toyota Pickup

2 Answers

2003 corrola humming????


I just had the same thing fixed. It made it when I got up to speeds around 60 mph, but no lower. It was my caliper. Drivers side, front.

Aug 03, 2008 | 2003 Toyota Corolla

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

256 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...