Question about Toyota Celica

Open Question

Where is the airbag module/computer located on a 2000 toyota celica?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
robshow
  • 367 Answers

SOURCE: 2004 Kia Optima airbag computer module

Try this website you have to register but its free.

Just click the above link to go to kiatechinfo.com

Posted on Jan 19, 2009

Ad
  • 2 Answers

SOURCE: fuel pump for 2000 toyota celica

Yes, remove the rear seat cusion and then lift up the padding. Take the screws out of the cover and them you can access the top of the fuel tank and remove the pump and fuel level sending unit.
Very easy!

Posted on Mar 02, 2009

  • 1 Answer

SOURCE: 06 kia sportage airbag control module

If your refering to the light on top of the dash that says "psgr air bag not connected" here;s the deal.

The module is activated when someone sits in the seat. Turn the key on and the notification will light. Go around to the psgr side of the car and sit in the seat and the light should go out.

Posted on May 03, 2009

jj127
  • 37 Answers

SOURCE: 2000 Chevrolet Malibu LS airbag problems

The passenger side airbag is a lot easier then driver side. Take the glove box out and you will see two 10mm bolts holding it in place. When you open the passenger side front door, remove the panel on the side of the dash and you will see yellow connectors.The 1 closest to the front is attached to the air bag, it is clipped into the frame. Just pull it loose and take it out and your done. For the Driver side, it takes a skinny T27 to remove the two star bolts, then just disconnect the horn red clip and ground and install new airbag. The module is located under the passenger seat, underneath the carpet. Kinda stupid but thats where its at. You also need to replace the front impact sensor located behind the grille on the back side of the metal bar to each side. Follow the hood latch down. Also just to make sure, you know to disconnect the battery before you do all this. You don't want new airbags to accidentally deploy.

Posted on Jun 20, 2009

  • 4 Answers

SOURCE: 2000 toyota celica transmission replacement

trannies cheap, email me weep_wail@yahoo.com.sg

Posted on Oct 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the fuel cut off switch on a 2000 Toyota celica gt. 1.8 engine


Hello, there is no fuel cut off switch, the fuel pump is disabled if any of the airbags deploy.

Sep 23, 2017 | Toyota Cars & Trucks

1 Answer

LOCATION OF AIRBAG CONTROL MODULE THX


How To: Remove SRS Airbag Computer Control Module ...

? 5:12
https://www.youtube.com/watch?v=kPduYbtAYds
Jun 23, 2012 - Uploaded by Charley O'Neill
This video will show you how to locate and remove airbag control ... How To: Remove SRS Airbag Computer ...Missing: thx

how to know or diagnose airbag SRS air bag control module ...

? 4:55
www.youtube.com/watch?v=2MdTkmk4FiQ
Feb 3, 2010 - Uploaded by vehix411 http://karmanauto.com/product/honda-and-acura-airbag-module-reset- ... will show you how to reset and or ...

Oct 30, 2015 | 2007 Toyota Tacoma

1 Answer

I have a 94 toyota celica st that had airbags deployed before and had a wire fire now the wiring is fixed and now it won't start and shows a airbag light that stays on..


Apparently it wasn't fixed exactly correctly? I would take it back, and have them check it out, it all should be under warranty, hopefully?

Apr 01, 2015 | 1994 Toyota Celica

1 Answer

Where is the factory amp located on 2000 celica gts?


I dont think there is a factory amp in your car i might be wrong but, if it is aftermarket check under seats, or behind glove box beside computer... according to the wiring schematic i have it said different ...notice were is states location of amp and trigger.
2000 Toyota Celica Car Stereo Radio Wiring Diagram
Car Radio Constant 12v+ Wire: Blue/Yellow
Car Radio Switched 12v+ Wire: Gray
Car Radio Ground Wire: Brown
Car Radio Illumination Wire: N/A
Car Stereo Dimmer Wire: N/A
Car Stereo Antenna Trigger: Black
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Front Speakers Size: N/A
Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Pink
Left Front Speaker Negative Wire (-): Violet
Right Front Speaker Positive Wire (+): Light Green
Right Front Speaker Negative Wire (-): Blue
Rear Speakers Size: N/A
Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Black
Left Rear Speaker Negative Wire (-): Yellow
Right Rear Speaker Positive Wire (+): Red
Right Rear Speaker Negative Wire (-): White

Jan 06, 2011 | 2000 Toyota Celica

1 Answer

Airbag where can i find one in toronto


is it deployed becouse if it is you need the airbag and repair your airbag module go to http://www.vehix411.com for more airbag repair tips free

Feb 24, 2010 | 2000 Toyota ECHO

2 Answers

2000 toyota celica green light on dash board


mine shows that when my lights are on at night

Jan 01, 2010 | 2000 Toyota Celica

1 Answer

The airbag light stays on , the entire Sqib or airbag module was replaced and still no results if the spiral coil is replaced and it still dosent work, any onther problems could it be some one mention the...


even tho you replaced a part of the air bag system you may still have to clear the codes from the system. also..toyota's usually need the center control module replaced if a air bag event has occurred.

Oct 15, 2009 | 1990 Toyota Celica

2 Answers

2000 Chevrolet Malibu LS airbag problems


The passenger side airbag is a lot easier then driver side. Take the glove box out and you will see two 10mm bolts holding it in place. When you open the passenger side front door, remove the panel on the side of the dash and you will see yellow connectors.The 1 closest to the front is attached to the air bag, it is clipped into the frame. Just pull it loose and take it out and your done. For the Driver side, it takes a skinny T27 to remove the two star bolts, then just disconnect the horn red clip and ground and install new airbag. The module is located under the passenger seat, underneath the carpet. Kinda stupid but thats where its at. You also need to replace the front impact sensor located behind the grille on the back side of the metal bar to each side. Follow the hood latch down. Also just to make sure, you know to disconnect the battery before you do all this. You don't want new airbags to accidentally deploy.

May 13, 2009 | 2000 Chevrolet Malibu

2 Answers

Fuel pump for 2000 toyota celica


Yes, remove the rear seat cusion and then lift up the padding. Take the screws out of the cover and them you can access the top of the fuel tank and remove the pump and fuel level sending unit.
Very easy!

Dec 07, 2008 | 2000 Toyota Celica

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

99 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8499 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...