Question about BMW M5

1 Answer

I have 2 airflow meters on my BMW m5 2001 i cannot control the iddling,when i pull a plug of one airflow meter it works fine for a while

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 437 Answers

Also clean the icv (idle control valve) wouldn't hurt to replace the ccv or pcv valve.

Posted on Aug 26, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1979 bmw 528i starting problem


This vehicle uses a thermotime switch for the cold start valve,located on the radiator,but you say you have fuel pressure and volume so go to the Vane airflow meter, when the airflow meter sweeps open it gives more fuel. so you need to make sure the vane air flow meter can sweep without interruption.

Nov 12, 2012 | BMW Cars & Trucks

1 Answer

Wont run with the airflow meter pluged in , it also runs really lumpy on tick over but revs up fine. when you try and maintain a set speed it stutters. i need help its doing my fu##### head in...


Hi Steve, Problem is more than likely the AIr Flow Meter, is quite a comon fault and does allow the car to run while it is unpluged but you will use a lot more fuel!!

Aug 10, 2011 | BMW 318 Cars & Trucks

2 Answers

Can I repair airflow meter instead of replacing it


nope - if air mass is faulty then bes buy a new one ... or a tested 2nd hand one

Jan 13, 2010 | 2002 BMW 5 Series

1 Answer

When the airfloe meter goes on my bmw does any


your engine management wont necesseraly come on. i had the same problem with mt 2000 e46 model. take out your air flow meter from its round casing. u will normally need a special tool to do this. but a small pair of vice grips will do. read the part number off it. contact automotive supplies on 02871 261261. i got the insert from them for my bmw cost me £36.00 when i plugged it back in the car went like new. the part info is as follows. PBT-GF30 FIVE PIN AIR FLOW METER. your origional part will be a bosch part but ur car will run just as good with this one. one from bosch will cost you £285.00. if you need any more help post me back, hope this helps. remember dealers will only rip u off......

Nov 04, 2009 | 1997 BMW 318

1 Answer

My '83 320i is in neutral revs up fine, however when I put it in gear it feels like something is holding it back. it's not the clutch. The RPM's crawl up the tach. the engine gets louder but sounds muffled...


the airflow sensor is the box like item on the airbox tubing b4 the airbox its self there should be a solid plastic tobe/pipe between 2 rubber 1s with a wiring plug attached this is the airflow meter/sensor

Oct 02, 2009 | 1988 BMW M3

1 Answer

Q45 airflow meter wiring.


That's not going to work. You can't install a air flow meter into a Pulsar from a Q45. Totally different animals. Air flow meters are car specific. I don't think its gonna work, but good luck with that.

Sep 28, 2008 | 1998 Nissan Maxima

1 Answer

Air flow meter


you need an airflow meter. unplug the airflow meter start up your car it should still be the same. this action wont damage your car. hence telling u that when plugged in there is no differance.

Sep 15, 2008 | 1993 BMW 3 Series

1 Answer

1992 BMW won't stay turned on


The spark plugs shouldn't be wet, or are they wet because it won't start and they just get fuel soaked? Check the injectors.

Jul 21, 2008 | BMW 325 Cars & Trucks

2 Answers

Bmw 316 e36


change your fuel filter if it does'nt work check that your fuel pressure is ok if not check that all the plugs on your air intake is all good and pluged in properly

Jul 16, 2008 | 1997 BMW 318

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

151 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Frankie B

Level 2 Expert

65 Answers

Fred Sops

Level 2 Expert

272 Answers

Doberman

Level 2 Expert

254 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...