Question about 1989 Chevrolet Camaro

1 Answer

My 1989 RS Camaro has been sitting for 2 weeks because it was overheating and I had to order a part for the fan-radiator mounting .The car will now not start,like it is starving for fuel,I hope it is not the fuel pump,this seems like the sympton.Has a quarter tank of gas ,could it lose a PRIME ON PUMP?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Legend:

    An expert who has written 200 answers of more than 400 characters.

  • Expert
  • 251 Answers

A fuse will blow for 2 reasons . 1) If the device has a Short in the circuit that runs through this fuse. 2) If the device draws more amperage from the power source through the fuse than the fuse will handle. ex. if a fuel pump or starter has a 20 amp fuse and the starter/fuel pump is going bad and draws 30 amps it will blow the fuse. A fuel pump on a 1996 vehicle is located in the fuel tank and is kept cool by the surrounding gas and the gas that flows through it. Overheating a fuel pump is virtually impossible. That being said there is a High probability that replacing the fuel pump and relay will fix this problem. It is quite common for this to occur in the GM vehicle of 1996. When the pump starts to fail, it draws an excessive amount of amperage and would blow the fuse. Hope you find this information useful.

Posted on Jun 07, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is my computer located on my 1989 camaro RS and how do I rest it?


Pull battery cables then touch the cbles together it discharge any remaing power let sit for ten min hook cables back up

May 13, 2015 | 1989 Chevrolet Camaro

2 Answers

1989 camaro rs won't turn over replaced starter


You need reprogramme the replaced starter.

Apr 13, 2012 | 1989 Chevrolet Camaro

2 Answers

Just replaced the thermostat but the camaro is still over heating, what to check next?


check and clean all hose and bypass, clean radiator, observe fan speed

Sep 12, 2010 | 1994 Chevrolet Camaro

1 Answer

Cant find relay for radiator fan? 1992 camaro rs v6 5 speed know fan is good because i put toggle switch on it


The relay should be on the left hand side of the engine compartment on a relay bracket. Ive attached a picture of the relay location (#8)

233d205.png

Mar 30, 2010 | 1992 Chevrolet Camaro

1 Answer

1989 camaro engine


Here is a link for you to check the DTC code to see what issues your engine management has detected. I am going to suspect the EGR valve may be stuck open, that's why your having most of the problem you have described. Good luck and keep me posted and check or replace the EGR valve, the car is too old to just clean out the EGR valve.

http://www.troublecodes.net/GM/

Dec 03, 2009 | Chevrolet Camaro Cars & Trucks

1 Answer

1992 Camaro Over heating


Man! this is a good one! Try painting the spair tire blue! If that's not it, Make sure the fans are pulling air through the rad. not pushing. (it's easy to wire them in reverse). Did you convert to 134? If so the condenser may need to be replaced with an after market, more efficient one. Also recheck the small stuff like, water flow, kinks in hoses,thermostat.

May 22, 2009 | 1993 Chevrolet Camaro

2 Answers

1993 camaro overheating


make sure all the air induction is in place to the radiator behind the front bumper if its not there that maybe your problem, or blown headgasket

Apr 29, 2009 | 1993 Chevrolet Camaro

1 Answer

Please help


take off fan and fan shroud. then the radiator hose. then the 6 - 8 bolts that hold the water pump on. clean surface of block where gasket would go. use rtv sealant on water pump and seat the gasket to it. let it sit for 10 mins. then install water pump, hoses and fan and fan shroud. if you need more help you can go to your local parts store and pick up a haynes manual. this will have more detail and pics too.

Jun 21, 2008 | 1989 Chevrolet Camaro

Not finding what you are looking for?
Cars & Trucks Logo

152 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...