Question about 2006 Chevrolet Cobalt

Open Question

2006 chevy cobalt security light flashing and want start.changed elec. Part of ign. Switch. Because acc. Part not working,didn't help.need car bad.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 3 Answers

SOURCE: 2006 chevy cobalt woulnt start lock light is on

Are you using the original key that came with the car? The chip in that key may have gone bad. Try using the spare key that should have come with the purchase of the car. You may also be having battery issues. If all else fails....call the people who really know how to rape you...DUM Dum dummmmm....the dealer

Posted on Dec 31, 2008

Ad
  • 76 Answers

SOURCE: how to adjust headlights on 2006 chevy cobalt

There will be adjustment screws located on at least two different spots surrounding each headlamp. By turning these screws you move the angle of the headlamp. Most shops will do this at a very resonable rate, I say this because improper headlamp angle may lead to a ticket, or at least a warning. To say the least, they have to be at specific angles and heights. Good luck.

Posted on Feb 20, 2009

  • 45 Answers

SOURCE: service transaxle fluid for 2006 chevy colbalt automatic.

you take it to a repair shop and they unhook your transmission cooler lines and pump old fluid out and install new fluid in.

Posted on Apr 29, 2009

SOURCE: how do i change the car battery for 2006 cobalt?

the battery is located in the trunk under the carpet where the spare tire is located, loosen the 10 mm nuts on the terminals and pull them off, gently pull the vent hose from the battery, loosen the bolt for the battery hold down, usually a 13mm or 15mm, remove battery and reverse the process to install

Posted on Jun 19, 2009

  • 98 Answers

SOURCE: 2006 chevy cobalt - door won't open

Start with the basics. Check the fuses (all of them) with a test light and be sure you have power to each and that they are good. Then be sure that the power lock relay is good by swapping it with another relay in the fuse block. If the fuses are good and the relay is swapped and the locks still aren't functioning, you may have an issue with the BCM. The BCM can be programmed to change the behavior, but if the car has had water damage, or other stress to the BCM (voltage, heat, etc.), it can sometimes damage the BCM and you will need to replace it and reprogram it at a GM dealership.

Posted on Jul 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Cobalt fuse blown ,no start


could be, but check starter relay in under hood fuse block contacts may be sticking or ign switch

Aug 31, 2012 | Chevrolet Cobalt Cars & Trucks

1 Answer

How to change ignition key for 2006 chevy cobalt


remove the plastic cover from the steering colum then you will see the switch on the left side remove the 2 screws you will need to turn the key to release the switch reverse to put together then you will need to relearn the switch to the body control module this is done by turning to crank and leaving it in the run position til the security light stops flashing you will need to do this three time after the third time remove the key for a min then start the car if possible but on a battery charger if the battery goes died during the relearn you will need to start over

Apr 21, 2012 | Cars & Trucks

1 Answer

My 2006 cobalt wont start


There can be a couple things, nutral saftey switch, AC DELCO, NEUTRAL SAFETY SWITCH Direct Replacement Part For OE Number 24219476 `$68.67 , ignition switch not adjusted correctly, try jumping the starter at the starter to see if the starter is working, of course I have just fixed a car that the guy didn't have the shifter in park, try these things and get back to me

Oct 18, 2011 | 2006 Chevrolet Cobalt

1 Answer

2006 Chevy Impala service security system flashes on he the display. Everything works bit the car will not start it just clicks.


Passlock sensor in the ignition switch is probably bad.try starting the car,when it does not start leave the key in the run position for 10 minutes,then try to restart the car.(after the car sits for ten minutes the security light should be out.) If it now starts you need a new passlock sensor.

Dec 06, 2010 | 2006 Chevrolet Impala

1 Answer

THET DETERET SIGNAL IS ON CANNOT START COBALT 2008


if you have not changed any keys,then first turn the ign. switch on for 20 min.drivers window down and all phones unplugged, radios off,no acc. on. so the anti theft can perform a system relearn. if everything is ok the engine will start after the 20 min. relearn.if not you will need to have the vehicle towed to the dealer for a computer scan for dtc and a reprogram.hope this helps.

Dec 06, 2009 | 2005 Chevrolet Cobalt

1 Answer

My car won't start


needs lock cylender and ignition switch and programing

Nov 01, 2009 | 2006 Chevrolet Cobalt

1 Answer

I changed the turn signal switch on my 2000 gmc pickup. There is now a security light on and the truck will not start. What do I need to do to reset security.


turn on ign-if light is flashing leave key on for 30 mins till theft light stays on ,then try to start-chech at ign switch to see if small 3 wire connector has been unplugged

Sep 19, 2009 | 2000 Chevrolet Silverado

1 Answer

I have a 2006 chevy cobalt and the lock lite is on on the display dash and the car wont start .Also the radio and dash functions wont come on. I live in the bahamas and we dont have access to a chevy...


you will need to do a security relearn.
1.turn key to on position and leave on
2.after 10 minutes the light will flash and go out turn the key on to off 3x then leave on again.
3. do this 3 times for 30 minutes then after 30 minutes your 3rd time and after turning the key 3 times the 4th time start the car. it should start right up.

Jun 10, 2009 | 2007 Chevrolet Cobalt Coupe

2 Answers

Third brake light on constantly, other brake lights seem not to work at all


It sounds like you need a brake light switch. It is mounted under the dash on the pedal assembly. It is easy to change, just twists in place. Good Luck

May 21, 2009 | 2006 Chevrolet Cobalt

Not finding what you are looking for?
2006 Chevrolet Cobalt Logo

Related Topics:

441 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...