Question about 1997 Volvo 850

1 Answer

Need Volvo 1997 850T wagon rear hatch schematic to reattach loose cover

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 972 Answers

Go to the dealer and buy the rear hatch panel repair kit, you will need it to fix it.

Posted on Aug 27, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the inside trunk release on a 1984 volvo 240 dl or is there one


There is no inside Trunk Release unless it is a Wagon and then it is at the center bottom of the hatch.

Mar 29, 2015 | Volvo Cars & Trucks

1 Answer

Break light repacement


. Obtain the correct bulb; I got mine from a Volvo dealer, but it does not look like a highly specialized bulb.2. Open rear hatch. Remove the plastic cover on the side pillar next to the hatch that has a speaker vent: you do this by poking a small screwdriver into each of the two rectangular slots next to the hatch, and prying back the plastic cover.3. Remove the speaker by pulling on the two red tabs at the bottom.4. The bulb holder is now exposed. Remove it by prying gently on the flange that holds it in place. It will come out, and you can replace the bulb.5. Reinstall all parts in the reverse sequence.

May 22, 2012 | 2006 Volvo V70

2 Answers

1992 volvo 240 wagon, and rear break repair


rear disk brakes ,easly changed because the hand brake is inside the drum in the disk ,so just push out the pins and then push piston in on one side and renew pad then do the same on the other side of the piston .

Apr 17, 2010 | 1992 Volvo 240

1 Answer

I have a 98 volvo wagon & the rear passenger side seats r stuck.


it is you have to remove belt to get seat up the tab that keeps belt from retracting too far came off

Jun 12, 2009 | 1998 Volvo C70

1 Answer

1992 volvo 240 gle wagon


MOST LIKLEY IS THE PUMP WHICH IS LOCATED UNDER VEHICLE DRIVER'S SIDE PASSEENGER SEAT AREA.(IN CHASSIS)
REAR LATCH CAN BE REPLACED

Dec 30, 2008 | 1992 Volvo 240

2 Answers

Volvo V70 xc AWD '98 - fuel filter change


Brandonlo168,

The fuel filter can be located under the carpeted cargo storage floor at the rear of the wagon. Remove the four 10mm bolts, remove the cover. You will then see a removeable plate to the right just behind the rear passenger seat. Fuel filter can be seen through hole in hole. Replaced from underneath wagon. Be sure to make sure lines are fully inserted onto filter. Check for leaks. No smoking, extinguisher handy. Note arrow on filter for correct fuel flow.

Ron

Dec 22, 2008 | 1998 Volvo V70

2 Answers

Defroster


FRONT DEFROSTER IS VACCUM OPERATED, ON PASSENGER SIDE REMOVE PANLE TO THE CENTER CONSOLE, YOU'LL SEE A CANISTES SHAPED IN TENNIS BALS IN SECUENCE, START THERE TO CHECK FOR VACCUM PROBLEM.
REAR DEFROSTER/WIPER/WASHER ON HATCH.OPEN REAR HATCH ON DRIVER'S SIDE HINGE YOU'LL SEE A WIRING HARNES GOIN THROUGH USUALLY THAT HARNES BRAKES , LOOSING CONTACT TO ALL OF THE ELECTRICALS IN HATCH DOOR, EASY REPAIR. REMOVE HINGE GET SOMETHING TO HOLD HATC OPEN, LIKE LONG BROOM.PULL OUT HARNES AND REPAIR.GOOD LUCK

Dec 14, 2008 | 1985 Volvo GL

2 Answers

1994 Volvo 940 Station Wagon timing belt


I hope you've solved the problem by now, but there are alignment marks on the crank shaft (top pulley), idler (lower side), and cam shaft (smaller, bottom pulley) which should be aligned with stationary marks on the timing belt rear cover.

The belt has marks that align with the aforementioned marks (lines). The double marks on the belt align with the camshaft marks and the single marks with the others.

Loosen the tensioner clamp (nut) to allow the spring loaded tensioner to press on the belt and retighten the nut.

Rotate the crank shaft (clockwise, probably two revolutions) and make sure the pulley marks realign to the marks on the cover (they don't have to realign with the marks on the belt).

Rotate the crank shaft a full revolution once the belt is on and check that alignment is preserved.

Periodically loosen and retension the tensioner nut (access through a hole in the cover) to ensure that tension is maintained as the belt relaxes.

Oct 25, 2008 | 1994 Volvo 940

1 Answer

Rear hatch is stuck


you need to remove the panel form the hatch and spray it with white lithium greae, it is more than likely stuck to dryness.

Jun 30, 2008 | 2001 Audi A4

Not finding what you are looking for?
1997 Volvo 850 Logo

Related Topics:

83 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...