Question about Isuzu Trooper

Open Question

Timing diagram for Isuzu trooper 3.2L DOHC - Trooper Isuzu Cars & Trucks

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 8 Answers

SOURCE: 1992 isuzu trooper 3.2 DOHC

I had the same trouble with my 93 Trooper.

I went on a sensor-changing spree.

The one sensor that fixed this idle problem was the throttle position sensor.

You can get one here.

Throttle Position Sensor

It's very easy to change, and fixes the problem instantly.

Good luck.

Posted on Sep 19, 2008

Ad
  • 1 Answer

SOURCE: alternator belt diagram 1992 Isuzu trooper

1. Remove battery terminals and secure them away from the battery posts using nylon wire ties.

1a. Fine some comfortable eye glasses (clear or yellow) and keep them on. There are plenty of opportunities to get debris in your eyes during this procedure.

2. Spray "PB Blaster" (loosens bolts) on two bolts that secures alternator.

3. Jack-up vehicle on side to access alternator. Use a jackstand to support.

4. Using a 10mm open-ended wrench, loosen the bolt that swings the alternator. Screwing the bolt "in" or toward the engine will allow play to increase in the alternator belt. Loosen the 12mm bolt slightly next to the 10mm bolt (approximately 1.5" toward engine).

5. Continue to loosen 10mm bolt until there is enough slack in the belt to remove the belt from the alternator pulley.

6. Remove belt. It may be possible to remove belt without removing fan faring. Maybe not. If not, you will need to remove plastic fairing. If you must remove fair, go below fan fairing and disassemble connectors that hold together pieces of fan fairing. Carefully remove.

7. Install alternator fan from above.

8. Check that alternator belt is on all tracks (from below with a flashlight), and slowly tighten.

9. Secure 10mm and 12mm bolts. Recheck tightness.

10. Reassemble battery connection and run vehicle at idle for about 5 minutes. Check belt for proper tension.

11. CAREFULLY check tension of belt. Or disassemble battery connections and re-check belt tension.

12. Reassemble fan fairing (if not already assembled), re-connect battery terminals, and have a nice day. :-)

Posted on Jan 04, 2009

emissionwiz
  • 76846 Answers

SOURCE: wiring diagram for 99 trooper dohc v6

Here u go.
050fb57.gif

Posted on May 06, 2009

greenspan
  • 1734 Answers

SOURCE: all diagrams of timing for isuzu trooper 94 3.2

They can help you:
http://manualfox.com/schematic.htm

Posted on Jun 26, 2009

  • 1129 Answers

SOURCE: '92 Isuzu Trooper speedometer problem

Replace the speed sensor located on the transmission this sends the signal to the speedometer, you may want to check the plug and its terminals to be sure the terminals in the plug are not corroded if they are clean the terminals with electrical contact cleaner then drive the care see if cleaning the plug fixed it if not replace the speed sensor.

Posted on Dec 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Isuzu 320 KB v6 camshaft timing diagram posted to wrong forum.


Here is a diagram, I just want to make sure we have the correct information or engine damage will occur. double check these specs. 1999 ISUZU TROOPER V-6 WITH A 3.2 OR 3.5 ENGINE.

Here are two diagrams to line up camshafts and crankshaft. hope this is helpful. good day.3_2_2012_9_19_49_pm.gif3_2_2012_9_20_21_pm.gif

Mar 02, 2012 | 1999 Isuzu Trooper

1 Answer

What are the specs settings for a 1998 isuzu trooper timing belt ?


Here are diagrams for the timing belts and the timing marks for replacing the timing belt on the 1998 Isuzu trooper. Hope this helps.

http://www.2carpros.com/diagrams/isuzu/trooper/1998

Aug 04, 2011 | Isuzu Trooper Cars & Trucks

1 Answer

What is the order of the spark plug wires for my 1994 isuzu?


For the 1994 Isuzu Trooper 3.2L DOHC V6:
Cylinders:
.......(back).......
|..5.............6..|
|..3.............4..|
|..1.............2..|
.......(front).......
Coil Connections:
............(back)...........
|.1..4.|..|.6..3.|..|.2..5.|
............(front)............

Let me know if this helped....Thanks for using FixYa.com!

Aug 21, 2010 | 1994 Isuzu Trooper

2 Answers

How to line up the cams?to put on timing chain.


Click on the following direct, free Link. It has the Timing Belt + Mark Diagrams for your 1999 Isuzu Trooper. It also has additional - very helpful Instructional and Directional Diagrams and Procedures including how to line up the Cams.

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!



http://www.2carpros.com/car_repair_information/year/1999/make/isuzu/model/trooper/1999_isuzu_trooper_timing_belt_diagram_marks.htm

Apr 27, 2010 | 1999 Isuzu Trooper

1 Answer

I need a belt diagrame of a 1996 V6 isuzu trooper


Click on the following free, direct Link. It has the Belt Diagrams for your 1996 Isuzu Trooper with the 3.2L DOHC V6. It also has the positioning for what Belts go where on the Crank Pulley.

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!

http://www.2carpros.com/car_repair_information/year/1996/make/isuzu/model/trooper/1996_isuzu_trooper_drive_belt_routing_diagram.htm

Apr 16, 2010 | 1996 Isuzu Trooper

1 Answer

Need a diagram of a serpentine belt for a 1998 isuzu trooper


Click on the following: free, direct Link. It has several Diagrams including the Serpentine Belt Diagram for your 1998 Isuzu Trooper 3.5L DOHC V6. It also has Instructional and Directional Diagrams that will help you.

http://www.2carpros.com/car_repair_information/year/1998/make/isuzu/model/trooper/1998_isuzu_trooper_drive_belt_routing_diagram.htm

Let me know if this helped, or if you have additional information questions. Feel Free to contact me at FixYa.com!

Apr 03, 2010 | 1998 Isuzu Trooper

2 Answers

Looking for a diagram of the coil pack firing order for a 94 isuzu trooper. i know it's 123456


Check this for 1994 Isuzu Trooper 3.2 liter DOHC V-6 (6VD1)

a038799.gif

Hope that helps (remember rated this help) Good luck.

Jan 22, 2010 | 1994 Isuzu Trooper

1 Answer

'92 Isuzu Trooper speedometer problem


Replace the speed sensor located on the transmission this sends the signal to the speedometer, you may want to check the plug and its terminals to be sure the terminals in the plug are not corroded if they are clean the terminals with electrical contact cleaner then drive the care see if cleaning the plug fixed it if not replace the speed sensor.

Dec 07, 2009 | 1992 Isuzu Trooper

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

243 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14384 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...