Question about 1996 Chevrolet C3500

1 Answer

D 1996 chevy 3500 deisel 1 ton starts runs for 5 min. stalls ,starts again runs for 5 min. and stalls third time startsand runs a little longer

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 14,036 Answers

SOUND LIKE DEFECTIVE FUEL SUPPLY PUMP.

Posted on Aug 25, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How you tell when the clutch is out on a 2000 dodge 3500 1 ton 2 wheel drive 5.9 deisel


Hi Dennis if there's difficulty changing gear. Or if it slips under pressure like going up a hill the motor revs up but the speed of the vehicle dosent change. Regards Jim...

May 09, 2015 | 2000 Dodge Ram 3500

1 Answer

Show diagram for sparkplug wiring on 1996 chevy 3500 454 engine


1-8-4-3-6-5-7-2 GM motors are numbered on the driver side as 1-3-5-7 and on the passenger side as 2-4-6-8. These numbered cylinder go from the front of the motor toward the back. Hope this helps.

Mar 08, 2013 | Chevrolet 3500 Cars & Trucks

1 Answer

1996 chevy 3500 7.4 vortec. the ecm fuse blows at the turn of a key


One of the power wire going from your ecm to a sensor or solenoid is shorting to ground. Get a wiring diagram and an ohm meter. disconnect the battery and start checking each wire measuring from the wire to ground. as you wiggle you will see the meter show 0 ohms when it is shorted. These are the hardest and most time consuming kind of electrical problems .good luck

Nov 21, 2011 | Cars & Trucks

1 Answer

1989 Chevy 1 ton wont start


It is likely the electronic ignition control module. When they go, they just go bad and usually when you are driving.

If it was a smaller vehicle it could also be a timing belt but your's has a heavy duty valve train so no worries there.

Mar 17, 2010 | 1989 Chevrolet C/K 3500

1 Answer

I have a gmc 3500 deisel,it starts and run great but out of no were it just shuts off.at stop ligyt or highway,doesn't matter.wait ten min. and it will start again,run for fifteen min. and die again.i...


check the camshaft and crankshaft sensors. If they get faulty (typical in GM cars) the PCM would shut down the engine. Happened the same problem to me and solved it by changing the crankshaft sensor.

Jan 24, 2010 | 1998 GMC Sierra

1 Answer

Sprak plug Wires Need To Be Installed Correctly


You have several RAM sub-models in here:
Normal 0 21 false false false MicrosoftInternetExplorer4 /* Style Definitions */ table.MsoNormalTable {mso-style-name:"Tabla normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-parent:""; mso-padding-alt:0cm 5.4pt 0cm 5.4pt; mso-para-margin:0cm; mso-para-margin-bottom:.0001pt; mso-pagination:widow-orphan; font-size:10.0pt; font-family:"Times New Roman"; mso-ansi-language:#0400; mso-fareast-language:#0400; mso-bidi-language:#0400;} B1500 RAM Van
B2500 RAM Van
B3500 RAM Van
RAM 1500 1/2 ton 2WD
RAM 1500 1/2 ton 4WD
RAM 2500 3/4 ton 2WD
RAM 2500 3/4 ton 4WD
RAM 3500 1 ton 2WD
RAM 3500 1 ton 4WD

Chrysler Full-Size Trucks 1989-1996 Repair Guide
To avoid confusion, remove and tag the wires one at a time for replacement.


f160dd3.jpg


Fig. 1: 2.5L 4-cylinder Engine. Engine Firing Order: 1-3-4-2. Distributor Rotation: Clockwise


a1a8242.jpg

Fig. 2: 3.9L V6 Engine. Engine Firing Order: 1-6-5-4-3-2. Distributor Rotation: Clockwise


dc6748e.jpg

Fig. 3: 5.2L and 5.9L V8 Engines. Engine Firing Order: 1-8-4-3-6-5-7-2. Distributor Rotation: Clockwise


832c92e.jpg

Fig. 4: 8.0L V10 Engine. Engine Firing Order: 1-10-9-4-3-6-5-8-7-2. Distributorless Ignition


Hope helped with this (remember rated this help) Good luck.

Nov 06, 2009 | 1996 Dodge Ram

1 Answer

I have a 96 chevy c3500 6.7 turbo diesel runs fine on hwy but while driving in the city it tends to die most times will start right back up but some yimes it takes 5 or 10 min then t will start up then...


YOU COULD HAVE A RESTRICTED AIR FILTER OR FUEL LINE OR FILTER.YOU COULD HAVE DEFECTIVE FUEL SUPPLY PUMP OR DEFECTIVE INJECTION PUMP.YOUR IDLE SPEED TOO LOW OR FAST IDLE INOPERATIVE.

Sep 02, 2009 | 1996 Chevrolet C/K 3500

1 Answer

Electrical? no speedometer no overdrive no third gear no wait to start light


check fuse #9 in the fuse box for being blown or lacking power...if there is no power to the fuse it is possible the ignition switch is bad

Aug 20, 2008 | 2006 Dodge Ram 3500 Truck

Not finding what you are looking for?
1996 Chevrolet C3500 Logo

Related Topics:

159 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...