Question about 2002 Kia Sportage

1 Answer

No fault codes but no spark or fuel pump operation

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Contributor
  • 157 Answers

If you have NO spark NO injection pulse suspect a Camshaft Position Sensor(CMP), that is the sensor that tells the computer your ignition firing and timing and pulse width for your injectors once it has received a signal from your Crankshaft Position Sensor (CKP) the 2 sensors work together to achieve the correct combination for start up

Posted on Aug 25, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

WHAT WOULD CAUSE MY 98 TOYOTA COROLLA TO STOP WHILE I WAS DRIVING IT?


there is a problem with the injector circuit or pressure to the fuel manifold
because the pump is running doesn't mean that there is fuel pressure for the injectors
run the fault codes and have a pressure test done to check the fuel pressure regulator operation

Sep 09, 2015 | Toyota Cars & Trucks

1 Answer

Ford taurus i have spark and fuel but will not run


have a fuel pressure test done on the fuel manifold to determine operation of fuel pump, pressure regulator and filters. run fault codes to check for injector problems

May 17, 2014 | Ford Taurus Cars & Trucks

1 Answer

Hard to start at times hot or cold


engine wont start cold or hot could be fuel problem.check for fuel or spark.try doing little troubleshooting make sure sparkplugs and wires good condition.fuel filter been changed.engine need fuel and spark ignition to run.turn ignition on listen for fuel pump operation in fuel tank if no check fuel pump fuse and relay.if fuse relay okay.problem could be the fuel pump but first use code scanner look for PCM, CRANKSHAFT POSITION SENSOR,CAMSHAFT SENSOR AND DISTRIBUTOR IGNITION FAULT CODE.MAKE SURE YOU HAVE FUEL INTANK I SEEN THAT HAPPEN BEFORE.

Dec 27, 2012 | 2002 Lexus RX 300

1 Answer

Toyota 5s fe engine stalling when hot no fault code


check for a bad coil. it may be shutting down engine when the thermostat opens. if bad it will not produce enough spark under warm or hot conditions. if this did not do it! check the fuel pump it may be getting hot and shutting off the engine. change the fuel pump relay with another of the same size. and see if thats your problem.

Apr 18, 2012 | Cars & Trucks

1 Answer

Audi A6 no cranking..


NEED HAVE VECHICLE CODE SCANNED FIRST LOOK FOR FAULT CODES MANY THINGS WILL CAUSE NO STARTING,LIKE BAD CRANKSHAFT POSITION SENSOR.FAULTY CAMSHAFT POSITION SENSOR,BAD SPARK PLUGS FOULED OUT BY FLOODING ENGINE DUE TO LEAKING FUEL INJECTORS,BAD ENGINE COOLANT TEMPERATURE SENSOR,BAD MASS AIR FLOW SENSOR.FAULTY ECM. CODE SCAN VECHICLE FIRST.IF NO FAULT CODES CAME UP YOU COULD HAVE FAULT IN FUEL SYSTEM, COULD HAVE STOPPED UP FUEL FILTER,BAD FUEL PUMP RELAY OR FUSE THE FUEL PUMP COULD BE FAULTY. TURN IGNITION SWITCH TO ON POSITION LISTEN FOR FUEL PUMP OPERATION IN FUEL TANK, YOU SHOULD HEAR FUEL PUMP RUN FOR FEW SECONDS THEN TURN OFF.IF NO FUEL PUMP BAD MORE LIKELY BUT CHECK FUSE AND RELAY FIRST BEFORE BUYING NEW FUEL PUMP.DONT BUY NEW PARTS HAVE VECHICLE CODE SCANNED FIRST USING DIAGNOSTIC SCANNER YOU COULD HAVE BAD CONTAMINATED FUEL.

Oct 06, 2011 | 2000 Audi A6

2 Answers

I REPLACED MY FUEL PUMP ON MY 1999 CHEVY SILVERADO EXT CAB P/U TRUCK AND IT CRANKS BUT IT WILL NOT START...ANY SUGGESTIONS?


did you check for fuel pressure at the fuel rail?
listen for the fuel pump when you turn the key on
did you change the wire harness when you changed the pump?

Sep 25, 2011 | Cars & Trucks

1 Answer

Replace egr valve still wont start


PROBLEM COULD BE FAULTY FUEL PUMP OR IGNITION MODULE.CHECK FUEL PRESSURE SHOULD BE 41 - 47 PSI. IF NO FUEL PRESSURE TO LOW REPLACE FUEL FILTER.STILL LOW FUEL PUMP FAULTY.IF FUEL PUMP DONT RUN CHECK FUSE AND RELAY.IF FUSE RELAY GOOD PUMP BAD.IF FUEL SYSTEM OKAY USE A SPARK TESTER TO CHECK FOR SPARK AT SPARK PLUGS IF NOT CHECK IGNITION MODULE FUSE IF OKAY IGNITION MODULE COULD BE BAD.USE A CODE SCANNER TO CHECK FOR FAULT CODE IN PCM AND IGNITION MODULE.THIS SAVE YOU FROM SPENDING TOO MUCH MONEY.

Sep 04, 2010 | 1993 Oldsmobile Cutlass Supreme

1 Answer

My car wont start,you turn the key , and sounds like it's going to start but it just wont' i already take to the mechanic he had the car for about 2 months i get the car back ; he said it was fix and now...


FIRST GET A SPARK TESTER TO SEE IF YOU ARE GETTING SPARK AT SPARK PLUGS.IF NOT CHECK IGNITION MODULE FUSE.IF FUSE GOOD HAVE CAR HOOK UP TO SCANNER LOOK FOR IGNITION MODULE FAULT CRANKSHAFT SENSOR FAULT AND PCM FAULT.IF ALL LOOK GOOD SO FAR.CHECK TO SEE IF FUEL PUMP WORKING.CHECK PUMP FUEL PRESSURE IT SHOULD BE 41 - 47 PSI. IF NOT REPLACE FUEL FILTER STILL LOW REPLACE FUEL PUMP.IF FUEL PUMP NOT WORKING AT ALL CHECK FUEL PUMP FUSE AND RELAY.IF BOTH IS GOOD FUEL PUMP AT FAULT.BUT SCAN TO CHECK FOR PCM FAULT CODES IT CONTROL SPARK AND FUEL SYSTEM.MAKE SURE SPARK PLUGS AND WIRES IS GOOD. ALSO CHECK FUEL INJECTORS FUSE ALSO.

Jun 08, 2010 | 1999 Oldsmobile Alero

1 Answer

2002 buick rendezvous turn over but will not start. started then stalled now will not start


DO A SPARK TEST USING A SPARK TESTER AND USE A FUEL PRESSURE TESTER GAUGE TO DO A FUEL PRESSURE TEST.FUEL PRESSURE SHOULD BE 41 TO 47 PSI.IF YOU GETTING NO SPARK.CHECK THE IGNITION MODULE FUSE.IF FUSE IS GOOD.SCAN IT TO CHECK FOR IGNITION MODULE FAULT CODE.PCM FAULT CODE CRANKSHAFT SENSOR + CAMSHAFT SENSOR CODE.IF YOUR FUEL PRESSURE IS 0 CHECK FUEL PUMP AND FUEL INJECTOR FUSES AND RELAY.IF OKAY FUEL PUMP FAULTY.BY USING A SCANNER IT WILL SAVE YOU TIME AND MONEY.NEW FUEL PUMP ABOUT $300.00 AND A NEW IGNITION MODULE ABOUT $200.00.

Apr 30, 2010 | 2002 Buick Rendezvous

Not finding what you are looking for?
2002 Kia Sportage Logo

Related Topics:

407 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75117 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...