Question about 2001 Chevrolet S-10

Open Question

2001 Chevy s-10 crew cab 4x4 4.3 V6. Need a vacuum diagram.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

geharbison
  • 101 Answers

SOURCE: Fuel guage reads half way and the truck runs out of gas

The float that helps detect fuel level is most likely broken. You or a mechanic will have to remove the fuel pump from the gas tank and check and possibly replace the float. Merry Christmas.

Posted on Dec 24, 2008

cgtotty
  • 1 Answer

SOURCE: chevy s10 broken vacuum line

The plastic line in the wiring harness goes to the heater controls; and believe it or not , the other end goes to the vacuum tank - but its in the FENDER !!!!! behind the ABS, kinda under the drivers side hood hinge - great place to put one ain't it ? No wonder GM is going broke !! Good Luck

Posted on Dec 25, 2008

  • 5 Answers

SOURCE: i need a 1987 chevy S10 vacuum hose routing diagram

Go to Autozone.com, become member, will give you repair manual,location of parts,diagrams.

Posted on Apr 09, 2009

  • 126 Answers

SOURCE: How to: change headlight bulbs in '04 Chevy S-10 Crew Cab 4x4?

raise hood on back side of core support there are two plastic clips pull up on clips to remove head light . then rock headlight forward and up to remove . twist bulb to remove .

Posted on Apr 15, 2009

  • 3600 Answers

SOURCE: how do i change my upper and lower ball joints

Jack up the car remove wheel remove brake caliper and remove rotor rent a ball joint press remover and installer tool (at schucks you get money back when you bring it back) if it's 4 wheel drive you will have to remove the axle shaft next pull the snap ring off on the top side and put tool on the lower tie rod end and press out, next do the top press out top joint next sand ball joint sockets so it is clean lube with WD-40 next press in top ball joint and then lower ball joint. In this order otherwise you will have to un install the top ball joint by removing the pin then nut.

Posted on Aug 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need 95 s10 blazer vac hose diag


follow this link to a blazer forum with vacuum diagram
Vacuum Lines 10 Forum

Jul 13, 2014 | 2000 Ford F250 Super Duty Crew Cabs

2 Answers

Where is located MAP/BARO Switch Solenoid Valve in a nissan frontier 2001 3.3L V6


Looking at the vehicle its on the right hand side,also before condeming,make sure the MAF (mass air flow ) boot is not torn and there is no vacuum leak causing false air8_5_2012_5_02_03_pm.gif8_5_2012_5_02_33_pm.gif

Aug 05, 2012 | 2001 Nissan Frontier Crew Cab

1 Answer

How to change a water pump in a 2001 nissan frontier v6 (non supercharge)


you need to remove the whole front end of the engine apart. the pump is behind the timing belt. may as well replace that and the crank and cam seals while you in there.

Jan 06, 2010 | 2001 Nissan Frontier Crew Cab

1 Answer

My sons 2004 v6 chevy 1500 will not start. It has


fuel pump is where I would look first, turn key on and see if you hear the fuel pump come on

Dec 16, 2009 | 2004 Chevrolet Silverado 1500 Crew Cab

1 Answer

Chevy S10 fuse diagram


go online or local parts store (chiltons) or (hanes) manual good luck

May 02, 2009 | 1991 Chevrolet S-10

1 Answer

How to: change headlight bulbs in '04 Chevy S-10 Crew Cab 4x4?


raise hood on back side of core support there are two plastic clips pull up on clips to remove head light . then rock headlight forward and up to remove . twist bulb to remove .

Apr 15, 2009 | 2004 Chevrolet S-10

1 Answer

Caution Flashers have quit working


well good place to start would be with checking and perhaps replacing the flasher usually located in fuse box! good luck hope this helps

Dec 31, 2008 | 2001 Nissan Frontier Crew Cab

1 Answer

Fuel guage reads half way and the truck runs out of gas


The float that helps detect fuel level is most likely broken. You or a mechanic will have to remove the fuel pump from the gas tank and check and possibly replace the float. Merry Christmas.

Dec 23, 2008 | 2001 Chevrolet S-10

1 Answer

Chevy s10 broken vacuum line


I have the same problem, did you get a solution or a diagram?
gonefishn55@yahoo.com

Jul 06, 2008 | 2003 Chevrolet S-10

Not finding what you are looking for?
2001 Chevrolet S-10 Logo

Related Topics:

136 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...