Question about 1999 Oldsmobile Intrigue

1 Answer

Replaced starter, battery and ignition switch. Car will not start, or will only start after turning key on and off for 15-30 minutes.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 306 Answers

Has a problem with the passlock system,,,if there is or was a remote car starter installed in the car it may be causing your problems

Posted on Aug 24, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Car wont crank


I have a 2000 Olds Intrigue that has the starting problem that some people have spoke about. You turn the key and all lights come on but the car will not start nothing. I 1st replaced the ignition switch which did not correct the problem. To get around the problem I have connected a wire to my starter and ran the wire up to the battery and when the car acts up I take the wire touch the positive pole on the battery post and the starter will turn over. I then get in my car and use the key and start the car. I have not been stranded by the car since. I try the key a few times if nothing happens I'll wait a few minutes and if that does not do it I jump the starter with my wire. This has been working for the last 2 years. It's not a correction but it is a work around.

Jul 08, 2010 | 2000 Oldsmobile Intrigue

1 Answer

Flashing alarm light after battery change. Car wont start,


System operation
System arms 5 seconds after switching ignition OFF. Switch ignition ON. Ensure clock LED illuminates for 3-5 seconds. If LED flashes rapidly at regular intervals for approximately 1 minute, then flashes at irregular intervals: Key code not recognised. Remove key and try again.
Programming
When
System malfunction: LED illuminates for 1 minute, then flashes at irregular intervals. Key(s) added or replaced.
NOTE: Replacement keys MUST have blue mark. Keys with red mark are NOT compatible with this system.
How
NOTE: Programming method using vehicle keys can be deactivated using diagnostic equipment.
Obtain 2 programmed keys (A and B). Insert key A into ignition switch. Turn ignition switch to position II. Wait 1 second. Switch ignition OFF. Remove key A. Insert key B into ignition switch within 5 seconds. Turn ignition switch to position II. Wait 1 second. Switch ignition OFF. Remove key B. Within 10 seconds: Insert key to be programmed into ignition switch. Turn ignition switch to position II. Wait 4 seconds. Switch ignition OFF. Wait 5 seconds. Start engine. If engine does not start and clock LED flashes: Switch ignition ON. Wait at least 20 seconds. Switch ignition OFF. Repeat programming procedure. Repeat above procedure to program remaining keys. Keys can also be programmed using diagnostic equipment

Mar 08, 2010 | 2000 Ford Focus

2 Answers

1995 BMW 525i. Car will not start or turn over. Have lights battery is strong, replaced starter, starter was tested, and worked. When ignition is turned dash lights up but starter does not engage. Have...


I had the same problem, after having the car towed to four Seasons, it was discovered that the electrical portion of the ignition switch was defective. Works like a charm. Part number 61 32 8 356 026 Hope this will help.

Feb 06, 2010 | 1995 BMW 5 Series

1 Answer

The car want start i think its the key because someone tried to steal the car before


IF YOU SEE CAR SECURITY LIGHT ON.WHEN YOU TURN KEY TO THE START POSITION.NO STARTER NOISE.TURN THE IGNITION KEY IN SWITCH TO THE RUN POSITION FOR 10 MINUTES.IF SECURITY LIGHT IS OFF.TURN OFF IGNITION SWITCH FOR 5 SECONDS.THEN START ENGINE.IS IT STARTS OR NOT. YOUR SECURITY THEFT SYSTEM IS GOING BAD THE DEALERSHIP HAS TO REPLACE BODY CONTROL MODULE WITH NEW IGNITION KEYS AND LOCK CYLINDER AND SWITCH.THEY HAVE TO PROGRAM IT IN TO PCM SO CAR WILL START.MAKE SURE BATTERY IS GOOD IT HAS 12.5 VOLTS AND BATTERY CABLES CLEAN AND TIGHT.BECAUSE A BAD STARTER OR SOLENOID SWITCH AND WEAK BATTERY WILL CAUSE NO START UP.

Jan 25, 2010 | 2000 Pontiac Grand Prix

3 Answers

My impala will not crank at all. my battery is charged but when i turn the car to start nothing at all happens.


POSSIBLE CAUSE BATTERY CABLES COULD BE LOOSE OR CORRODED OR BAD GROUND CABLE.YOUR STARTER SOLENOID OR STARTER IS FAULTY.YOUR CAR COULD BE IN THEFT DETERENT MODE.ALSO CHECK IGNITION FUSE TO MAKE SURE THE IGNITION SWITCH IS GETTING POWER.BECAUSE A BAD IGNITION SWITCH WILL CAUSE NO START PROBLEMS.

Jan 18, 2010 | 2003 Chevrolet Impala

3 Answers

Saab 9-3 SE won't start!!!


My boyfriend was having the same problem with his 2002 9-3 and in reading the user manual i found the following...when the car wouldn't start this morning he tried it and instead of having to wait 15 minutes for it to start, it started right up. Oh and his screen didn't give an error.

Electronic starting interlock
(immobilizer)
When the key is inserted in the ignition, a
signal is sent to the receiver. If the signal is
verified, the engine can be started.
Each time the key is removed from the ignition,
the electronic immobilizer is activated.
If a fault is detected (e.g. in the transmitter)
”KEY NOT ACCEPTED” will appear on the
SID.
In this case, you can still start the car if you
turn the ignition key to ON and press one of
the buttons on the key.
Take the car to an authorized Saab dealer to
have the system checked.

If the car does not start
If the text "KEY NOT ACCEPTED" appears
on the SID when the engine refuses to start,
the trouble may be a fault in the transponder
of the key or in the receiver of the ignition
switch. Proceed as follows:
• Turn the key back to the LOCK position.
• Turn the key to the ON position.
• Press one of the buttons on the remote
control (the LED on top of the dash stops
flashing).
• Start the engine.
Try the other key. If it works, the trouble is in
the first key.
Call on an authorized Saab dealer for
inspection and correction

Sep 10, 2009 | Saab 9 3 Cars & Trucks

1 Answer

1999 Pontiac Grand Prix Won't Start


if battery cable and starter is good . key entry security mode is on or going bad .try another car key .if cranks that it if not. put key in ignition. turn the key to on position .for 10 minutes. dont touch nothing if security lights off turn switch off for 5 secs.if starts your .security body control module or ignition switch is bad that a dealer ship job .have to have tech 2 scanner to reprogram it to crank.

Mar 10, 2009 | 1999 Pontiac Grand Prix

4 Answers

Dead battery


The clicking sound you hear when you turn the key is the starter solenoid trying to apply voltage to the starter. Try this, if you can see the starter tap it with a hammer and then try to start the car. this is an emergency make do.

The solenoid is a heavy duty relay that is capable of switching the high current requirements of the starter (up to 70 - 100 amps).

If it's clicking its closing. By the way a new starter will come with a new solenoid

I just replaced my starter in my F-150 today for the exact same problem. Cost $100

Hope this helps Good Luck Loringh

Oct 09, 2008 | 2004 GMC Envoy

2 Answers

95 F150 wont crank


the starter should be replaced. The solenoid is kikcing the pinion out but there is no contact being made to turn the starter motor. I have the exact same truck and before i changed the starter used the old starter tap trick. Tap the starter casing with a hammer and it should start turning again. hope this was helpful for you. Good luck.

Sep 16, 2008 | 1995 Ford F150 Styleside Regular Cab

Not finding what you are looking for?
1999 Oldsmobile Intrigue Logo

Related Topics:

154 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...