Question about Hyundai Tiburon

1 Answer

How do you change the oil pan in a 2001 hyndai tiburon.

Posted by on

  • thebigdog61 Aug 24, 2010

    Do you need to lift the engine? Is the oil pan easily accessible?

  • thebigdog61 Aug 24, 2010

    Yes very polite and helpful.

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Hyundai Expert
  • 1,868 Answers

how do you change the - 8-24-2010%204%3b39%3b57%20pm.jpg8-24-2010%204%3b39%3b57%20pm.jpg8-24-2010%204%3b39%3b57%20pm.jpg prev.gif next.gif
Oil Pan; Here is procedure...Guru...Saailer
REMOVAL & INSTALLATION
Fig. 1: Oil pan sealant applications points — except 3.0L engine 7923gg69.gif

Fig. 2: Oil pan sealant applications points and tightening sequence — 3.0L enhow do you change the - 7923gg70.gif 7923gg70.gif

  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2. Drain the engine oil.
  3. Remove or disconnect the following:
    • Negative battery cable
    • Engine splash shield
    • Exhaust front pipe
    • Oil pan
    To install:
  4. Apply a 1⁄8 in. (3mm) bead of RTV sealer along the groove in the oil pan.
  5. Install or connect the following:
    • Oil pan. Tighten the bolts to 48–72 inch lbs. (6–8 Nm).
    • Exhaust front pipe
    • Engine splash shield
    • Negative battery cable
  6. Refill the crankcase with oil.
  7. Start the engine and check for leaks.prev.gifHere is procedure...Guru....Saailer

8-24-2010%204%3b39%3b57%20pm.jpg

Posted on Aug 24, 2010

  • David Burbee
    David Burbee Aug 24, 2010

    Hello! Pan is easy to get to; I would jack stand the vehicle...Simple because it allows more workable room................Saailer

  • thebigdog61 Aug 24, 2010

    Thanks!

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I remove oil pan on a 2001 gmc Sonoma pick up truck to replace gasket


1993 GMC SONOMA 2.6 CYL V6 NOT 4x4 OIL PAN ...

? 2:31
https://www.youtube.com/watch?v=1KsRTlnW7Cg
Sep 27, 2011 - Uploaded by JohnSmiths8379858
trying to reomove the oil pan to this truck has been sitting for about 6 ... 1993 GMC SONOMA 2.6 CYL V6 NOT 4x4 OIL PAN REMOVAL "HELP!

Oil Pan Gasket: How to Change Oil Pan Gasket for 2001 ...

www.2carpros.com/questions/2001-gmc-sonoma-oil-pan-gasket
Mar 18, 2011 - How to change oil pan gasket for 2001 sonoma, can i get away with just raising the engine two inches to ... 2001 GMC Sonoma • 4 cylinder 2WD Automatic • 150,000 miles ... You need to remove the engine to get the sump off.

Nov 28, 2015 | GMC Cars & Trucks

2 Answers

How do i change the oil in my 2001 hyundai tiburon Se


Hello,
Well your car will use a 5W30 oil. Then to change it you need to -
  1. First thing is to make sure the dipstick that checks the oil level pulls up.
  2. Make sure to have a 5 quarts drain pan to safety store used oil for disposal.
  3. Set the drain pan under the oil plug and then scoot it out about 6 inches so when the oil comes flying out the drain pan catches it.
  4. When all the oil has completely drained then make sure the gasket is on the oil plug.
  5. Now wipe the tip of the oil plug off (some oil plugs pick up metal shavings and you don't want to put that back into the engine.
  6. Put the plug back into the oil pan and snug it up.
  • Now for the oil filter
  1. Move the drain pan back to the oil filter. (will be on the backside of the pan)
  2. With a strap wrench loosen the oil filter just a few turn. Just enough for the oil to begin to drain from it.
  3. Now remove the oil filter completely.
  4. Check on the oil filter housing to make sure the gasket from the oil filter did not stick.
  5. Now take the new oil filter and inspect it for dent or holes and also make sure the new gasket is on it and not torn or severely cracked.
  6. Take a few drops of oil and rub it onto the new filters gasket to help that gasket seal.
  7. Now screw the new filter on the oil filter housing.
  8. Clean off and old excess oil in the area with a shop rag.
  9. Now add the required amount or oil (4.5 quarts)
  10. Start the car and right away get out and look underneath the car for leaks.
  11. If no leaks turn the car off and check the oil level to insure a proper fill.
  12. Job finished
Regards, Tony

Apr 20, 2011 | Hyundai Tiburon Cars & Trucks

1 Answer

How often do i need to change the oil in my 2001 hyundai tiburon


Hyundai,for all of Europe, say every 10,000 miles or every year and use 10/40 semi sythetic oil with a new filter.

Sep 13, 2010 | 2001 Hyundai Tiburon

1 Answer

How often do i change the oil in my 2001 hyundai tiburon


OIL CHANGE AT 7500 MILES CHANGE OIL 3000 MILES IF VECHICLE DRIVEN IN HOT AND DUSTY AREA.

Sep 13, 2010 | 2001 Hyundai Tiburon

1 Answer

The nut in the oil pan wich way do i turned it ti release the oil


Turn the bolt counter clock wise or in a left rotational direction.

Aug 02, 2009 | 2001 Hyundai Tiburon

1 Answer

P0130 trouble code


P0130 means that the oxygen sensor circuit malfunction
plse look at the following items.
heating inoperative,poor connection,wiring,ecm.

Jul 11, 2009 | 2005 Hyundai Tiburon

1 Answer

How hard is it to change the oil pan?


well if your asking you want to take it to a mechanic

as you have to remove the exhaust
motor support then seperate the motor from trans
trust me it's worth the trip to the garage

Jul 07, 2009 | 2001 Hyundai Tiburon

1 Answer

How do you change a timing belt on a 1998 hyundai tiburon


put engine at TDC. place a jack under the oil pan, remove the engine mount followed by the belts remove the mount bracket, timing cover and the timing tensioner, remove the belt and reinstall make sure its in time by cranking by hand about 3 full turns

Jun 30, 2009 | 1998 Hyundai Tiburon

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

115 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...