Question about 2006 Dodge Grand Caravan
Cleaning is only a temporary fix as cleaning solutions removes the coating on the pindle and ruins the egr, buy a new one and you will fing it located on the intake near the throttle body
Posted on Aug 24, 2010
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Sometimes you can remove them and clean the carbon build up off of them and lubricate it before you reinstall it. Make sure you can find a new gasket before you take it off. Usually you ruin the gasket removing the EGR. Good luck. Please rate me so I know how I'm doing. Thanks.
Posted on Dec 30, 2008
You have to the EGR valve (sometimes the Intake manifold to EGR Vlalve line also). After you remove it take a drill bit the about 20 % smaller than the actual hole of the outlet side and rotate the drill bit with your hand to dig out the carbon. Aditionally the line coming from the intake manifold to the EGR valve will clog near the connection to the EGR valve. I use either a single piece of copper wire or the wire that you would use to tie ribar together to clean the line. When your done cleaning take a piece of vacuum line and connect it to the diaphram side and **** on it... then plug the line well with your thumb. Grasp the valve and blow thru it... Air should blow thru it freely. Remove your thumb from the vacuum line and try blowing again.. No air should pass thru the valve.
Then reinstall the valve and start the vehicle with the vacuum line disconnected (but blocked off) Use another piece of vacuum line connected to the diaphram again and **** on the line.. The vehicle should die or run really bad. If it does this then you cleaned it correctly.
Posted on Jan 20, 2010
SOURCE: egr valve cleaning
Hello! Cleaning works at times...The EGR is bolted to the back-side of the intake manifold...Two bolts hold it in place...More than likely it's fouled with carbon...However, looking at the age of the vehicle I would recommend replacing it...
Auto Zone sells them for $74.99...The part # is EGR3173...Guru........Saailer
Posted on May 08, 2010
SOURCE: to clean the EGR valve
Not sure why you would want to clean it and not just replace it..... it's a cheap part that is normally replaced as part of a tune up. To clean it, remove it and spray it out with a spray degreaser, engine cleaner, carb cleaner, etc. Make sure to rinse it completey and make sure it's thoroughly dry before reinstalling.
Posted on Jun 03, 2010
Tips for a great answer:
Jan 25, 2016 | Cars & Trucks
Dec 13, 2015 | Cars & Trucks
Oct 12, 2012 | 1998 Nissan Maxima
Aug 06, 2011 | 1997 Toyota RAV4
Mar 20, 2011 | 1998 Ford Taurus
Dec 15, 2010 | 2002 Isuzu Trooper
Oct 23, 2010 | 1997 Nissan Pickup
Oct 22, 2010 | 1995 Subaru Legacy
May 04, 2010 | 1999 Mercury Sable
Apr 07, 2009 | 2000 Mercury Sable
Jun 23, 2017 | 2006 Dodge Grand Caravan
294 people viewed this question
Usually answered in minutes!