Question about 2007 Mercedes-Benz C230 Sedan

1 Answer

Steering wheel tilt lock on a 2004 c230 coupe not locking

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Contributor
  • 157 Answers

There is a electronic motor that is attacked to the steering wheel to allow you to adjust it, I would not get involved in that location if you have no working knowledge of the vehicle. The Air Bag wires run up and down the channels near the steering wheel and can cause deployment if you are not careful, take it to a mercedes technician to help you out.

Posted on Aug 24, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replacement ignition key 1999 pontiac bonneille


Just the key or the whole lock cylinder with key ?

Removal Procedure
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
Disconnect the battery negative cable.
Disable the SIR system. Refer to Disabling the SIR System
Position the steering wheel half way between the upper and lower tilt stops (if necessary).
Remove the steering wheel. Refer to Steering Wheel Replacement .
Roll back the shift lever seal from the upper and the lower shrouds.
Remove the tilt wheel lever (if necessary). Refer to Tilt Lever Replacement - On Vehicle .
Remove the 2 TORX® screws from the lower steering column shroud.
Remove the lower steering column shroud.
Remove the 2 TORX® screws from the upper steering column shroud.
Lift the upper steering column shroud to gain access to the lock cylinder access hole.
Using a bent tip awl, insert the tip into the ignition lock cylinder access hole.
Turn the ignition lock cylinder to the START position.
Using the bent tip awl, push down on the ignition lock cylinder retaining pin.
Release the ignition lock cylinder to the RUN position.

Remove the ignition lock cylinder from the lock module assembly by pulling the ignition lock cylinder away from the steering column.

There may be a video on youtube .

Feb 23, 2017 | Pontiac Cars & Trucks

1 Answer

Tilt wheel stuck I the up postion,How do you fix it


This happens with my ram. The tilt wheel locking pin is stuck. When this happens to me i have to wiggle my steering wheel up and down and pull on the tilt release lever at the same time until the locking pin slides out of it's locked position. I have found that if i do not lock the wheel in the max up or max down position i do not have this problem.

Mar 03, 2016 | 2006 Dodge Durango

1 Answer

Key will not turn


Insert the key, gently twist the steering wheel and then open the key, if that's ok. Now you tilt of the wheel direction twist, twist gently, hear click open key,car key

Mar 16, 2013 | 2004 Chevrolet Impala

1 Answer

My 1999 c230 Mercedes Benz key won't start my car


Jerk the wheel back and forth while trying to turn the key

Nov 14, 2012 | Cars & Trucks

1 Answer

1987cadallic deville steeringwheel


Hi,

Usually, vehicles with tilt adjust steering, have a small lever just under the steering wheel column. Pulling this lever out, unlocks the wheel. Pushing lever back in, locks the wheel.

Have a look for a lever of this type and once you find it, have your Dad hold the steering wheel at his preferred position, then push the locking lever back up, to lock the wheel in place.

Let me know if you resolve this.....


Cheers,

Dec 28, 2011 | 1987 Cadillac DeVille

1 Answer

My tilt steering wheel will not lock where i want to set it. How do I tighten it up?


sound like locking mechanism inside tilt steering wheel column broken.

Aug 08, 2011 | 1996 Oldsmobile Achieva

1 Answer

Tilt steering wheel won't tilt. What's wrong?


your steering wheel adjuster is blocked or stuck up thats why it doesnt freely move to the max. take off cover/ check condition and or lubricate it.

Apr 05, 2010 | 2000 Toyota Camry

1 Answer

Door Lock Malfunctioning


power door lock solenoid may need replacement

Jul 04, 2009 | 2007 Mercedes-Benz C230 Sedan

1 Answer

Locked steering wheel


Sounds like the rack is broken inside steering column. This happened to me while getting tires replaced at pep-boys. Try moving the tilt wheel up and down while turning key.

May 10, 2009 | Chevrolet Suburban 1500 Cars & Trucks

Not finding what you are looking for?
2007 Mercedes-Benz C230 Sedan Logo

Related Topics:

662 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75117 Answers

Michael Contreras
Michael Contreras

Level 2 Expert

166 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...