Question about Ford Escort

Open Question

1994 ford escort wiring diagram - Escort Ford Cars & Trucks

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

danny_murray
  • 55 Answers

SOURCE: fuel cut off switch for 1990/91 ford escort 1.9

The "inertia switch" which shuts off fuel to the engine in the event of a collision or jolt on a 1991 through 1996 models, as well as on 1998 coupes, is located in the rear of the vehicle, near the right (passenger's side) strut tower. On sedan and coupe models, open the trunk and remove the right-sided trim panel. On sedan and coupe models, open the trunk and remove the right-side trim panel. On hatchback and wagon models, there may be an access door secured by clips. On some models you may need to remove the lower quarter trim panel on the right side, however it is easier to cut an access hole directly above the switch.

Posted on Dec 04, 2008

emissionwiz
  • 75066 Answers

SOURCE: 1994 ford escort stereo wire

1994 Ford Escort Car Stereo Wiring Diagram
Car Radio Battery Constant 12v+ Wire: Blue/Red
Car Radio Accessory Switched 12v+ Wire: Blue/Black
Car Radio Ground Wire: Black
Car Radio Illumination Wire: Red/Black
Car Stereo Dimmer Wire: N/A
Car Stereo Antenna Trigger Wire: N/A
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Violet
Left Front Speaker Negative Wire (-): Blue/Orange
Right Front Speaker Positive Wire (+): Blue/White
Right Front Speaker Negative Wire (-): White
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): White/Blue
Left Rear Speaker Negative Wire (-): Red/Blue
Right Rear Speaker Positive Wire (+): White/Green
Right Rear Speaker Negative Wire (-): Blue

PLEASE RATE THIS INFO AS A FIXYA! IF YOU FIND IT IS WHAT YOU NEED, THANKS ALLOT.
-->

Posted on Oct 08, 2008

alicantecoli
  • 22095 Answers

SOURCE: timing belt diagram for 2001 ford escort zx2 dohc

cam shaft timing marks on back of cams ,two slots ,use a flat piece of metal to align .remove no1 spark plug and drop long thin screwdriver down it to bring piston just below tdc,then align cams so both cams are on the rock (valves closed) with knob on back cam aligning with pick up sensor left side between lobes.then bring piston up to tdc and fit belt.turn engine over twice with socket on bottom pulley to make sure no valves clear pistons.Remember to remove flat edge from back of cams i didnt last time and bent my home made tool

Posted on Jan 28, 2009

ZJLimited
  • 17970 Answers

SOURCE: how to change a thermastat 1994 ford escort with a 1.9 engine

1.9L Engine

CAUTION Never open, service or drain the radiator or cooling system when hot; serious burns can occur from the steam and hot coolant. Also, when draining engine coolant, keep in mind that cats and dogs are attracted to ethylene glycol antifreeze and could drink any that is left in an uncovered container or in puddles on the ground. This will prove fatal in sufficient quantities. Always drain coolant into a sealable container. Coolant should be reused unless it is contaminated or is several years old.

  1. Disconnect the negative battery cable.
  2. Drain the cooling system.
  3. Remove the air intake tube, crankcase breather and PCV hose.
  4. Remove the ignition coil pack and bracket.
  5. Remove the upper radiator hose.
  6. Remove the ignition coil pack bracket.
  7. Unfasten the heater hose inlet tube bracket bolt and remove the heater hose inlet tube from the thermostat housing.
  8. Remove the three thermostat housing attaching bolts, then remove the thermostat housing and gasket.
b2d5ac4.jpg

Fig: Remove the ignition coil pack


b5ad3b2.jpg

Fig. : Detach the air intake tube, crankcase breather and PCV hose


3a3c4dd.jpg
Fig. : Disconnect the upper radiator hose from the radiator


63b3b74.jpg
Fig. : Unfasten the ignition coil pack bracket upper bolts...

076a94a.jpg

Fig. : ...and the lower bracket bolt, then remove the bracket

f656bf8.jpg

Fig. : Unfasten the heater hose inlet tube bracket bolt (arrow)

314321c.jpg

Fig: Unfasten the heater hose inlet tube-to-thermostat housing clamp


3204281.jpg
Fig.: Disconnect the hose inlet tube from the thermostat housing

5dc1ba9.jpg

Fig. : Unfasten the three thermostat housing bolts


2fb60e5.jpg

Fig. Separate the thermostat housing from the engine block


6f1527f.jpg

Fig. : Remove the thermostat from the housing


e33ea6d.jpg

Fig. : Use a scraper to clean old gasket material from the engine block's thermostat housing mating surface ...


db9a50c.jpg

Fig. : ... as well as the thermostat housing

continue...





Posted on Oct 29, 2009

  • 36 Answers

SOURCE: Ford Escort cooling fan not working, Wiring

check the fuses there s also fuses in the engine bay,also check the wiring to the fan,the wires lead back to the main loom so if you are trying to trace the wire back its easier to take this out to check it but make a note of what connects to what.

Posted on Jan 31, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I need a diagram for a serpenten belt for a 1994 ford escort


Hello everettburns,

The pictures below are for the 1.9 engine. I hope this is what you want.

netvan_81.png

Regards,
netvan

Apr 10, 2011 | 1994 Ford Escort

1 Answer

Spark Plug Wiring Diagram For 1994 escort


Firing order is 1-3-4-2
Remove no 1 cylinder sparkplug(furthest from the transmission). Block the plug hole with your hand. Rotate the engine with a wrench until you feel pressure under your hand. No 1 cylinder is now on compression stroke.
Now get the engine on TDC(Line up notch on the crank pulley with the timing pointer). Remove the distributor cap. The rotor arm will be pointing at no 1 cylinder plug wire. Moving clockwise connect the wires.
59dec26.jpg

Sep 23, 2010 | 1994 Ford Escort

1 Answer

1992 ford escort wiring diagrams


I have the instrument cluster diagrams, need an email address to send to in pdf format

Feb 10, 2010 | 1992 Ford Escort 4 Door

1 Answer

Need entire wire diagram for 1996 Ford Escort Lx


i want to wire up my towbar to a 1996 ford escort 5 door, i have the colur codes for which coloured wires come from 7 pin but need to know which coloured wires are for what on my car for rear light

Nov 08, 2009 | 1996 Ford Escort 4 Door

1 Answer

Diagram for vacuum system


check the "repair info" section at autozone.com. If not on there, check your local library for a Chilton or Hayes repair manual

Apr 13, 2009 | 1994 Ford Escort

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

562 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...