Question about 1998 Land Rover Range Rover

1 Answer

Started it this morning and managed to reverse but i mistakenly put it into LO and it cant go back into Hi. am now getting the select neutral message on the dash

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Better sell it

Posted on Aug 24, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2005 Audi A5 steering is get stiff after few minutes of starting in the morning. This is the situation even with enough power steering oil. The power steering doesn't work. The gear system also has a...


Check the gear box oil level sounds low to me i had a similar problem with a auto box car before and as for your steering it could be a worn steering rack if the oil level is good

Feb 03, 2015 | Audi A5 Cars & Trucks

1 Answer

1 Answer 2001 GMC Jimmy started fine this morning as usual. Put it in reverse, back out then put it in drive and it died


and , did it start back up , did you put it back into park of neutral , is the battery dead , there could be a number of reasons , get back with more info

May 05, 2014 | 2001 GMC Jimmy

1 Answer

2005 jeep grand cherokee stuck in four wheel drive


are you in four wheel low or four wheel hi. if you are in four lo, put vehicle in neutral before trying to shift out and be at a complete stop. if you were in four hi, put vehicle in reverse and keep backing up, usually 4wd while come out and go back into 2wd

Mar 17, 2014 | 2005 Jeep Grand Cherokee

1 Answer

Jimmy 99 put the lo gear and try to put in back in 2 hi. and still remain in 4 lo ?


My lifted 97 Expedition does that every once in a while. Try putting the vehicle in neutral, or changing from low to high on loose soil or gravel, and switch from forward to reverse a few times. 4 low is only meant for extreme conditions, so you shouldn't be using it too often.

May 18, 2011 | GMC Jimmy Cars & Trucks

2 Answers

My 4x4 is stuck in four wheel low it is shift on the fly and i have already replaced the transfer case motor


Ok here is a long shot but sometimes it will work. Put the 4wd position switch to 4wd Lo, put your transmission in reverse and back up for about 50 yards, stop and put your transmission in neutral, then shift the 4wd to 4wd hi, wait a few seconds and shift the 4wd to 2wd hi, Sometimes the t-case will get stuck and this is how you reset the computer. I have known people that really got their t-cases messed up because they thought that shift on the go meant that they could shift the t-case into 4wd LO while moving but shift on the go is only for 4wd hi the gears will not mesh up fast enough for 4wd LO because the ratio is 1 to 1 . I hope this helps you.

Feb 08, 2010 | 1990 Ford Bronco

1 Answer

Wont shift out of 4lo to any other 4hi or 2hi what can i do


Shot in the dark but I have done this before! Back up at least 50 yards in reverse with the selector set to 4wd Lo come to a stop, put your transmission in neutral, shift the 4wd selector to 4wd hi wait for a few seconds, shift it to 2wd hi wait a few seconds then put your tranny back into drive and see if that takes it out of 4wd. Good luck

Feb 08, 2010 | 2001 Chevrolet Blazer

1 Answer

Shifts into 4 lo without warning


Sounds like you have a faulty transfer case control module which is located on the passenger side under the dash area right at the kick panel,there isnt any real test for this TCCM except replace with known good one.

Oct 31, 2009 | 1999 Chevrolet Blazer

1 Answer

2002 Durango wouldn't go when shifted into reverse or drive


if a customer came to me with this i would first check fluid level
before anything else

what you need to ask is if a maybe 100 diagnostics is worth saving the 2 grand to replace your transmission

Mar 11, 2009 | 2002 Dodge Durango

1 Answer

4WD basic question


The 4-lo is so low that sometimes you really have to push it to go into gear. Put the transmission into neutral, and even let it roll a little bit to get it to slip in easier.

You could try to turn the engine off as well while you're in neutral, and then put into 4-lo.

If it's impossible, I'd have your linkage checked to make sure nothing flew up in there and is stuck and/or it's bent.

Dec 06, 2008 | 1999 Jeep Cherokee 4WD

Not finding what you are looking for?
1998 Land Rover Range Rover Logo

Related Topics:

44 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

yadayada
yadayada

Level 3 Expert

75807 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...