Question about Mazda Millenia

Open Question

Car will start but runs a little sluggish, but when i put it into gear it stalls immediately. what could be the problem/

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Car will start but put it in gear engine will die


engine starts with no problem; but, when I put in gear and ...

www.cargurus.com > Questions > Hyundai > Sonata

CarGurusNov 15, 2012 - The engine just fall dead when you step on the gas; it seems to jerk before ... My car does the same thing but i put it in neutral n it starts up. ... I have a 2004 kia optima it jerks when I go into reverse it was driving ... start and run fine butwhen I put it in drive or any other gear it dies! ... 2002 Hyundai Elantra GT.

Engine stalls when tranny put in Drive or Reverse - Kia Forum

www.kia-forums.com/kia-carnival...2002.../43407-engine-stalls-when-tr...

Feb 28, 2008 - 10 posts - ‎3 authors
Give it a little gas before putting in D or R and it will go. .... When I start the van cold and shift the tranny into drive or reverse.....the whole front ... won't run in forward gears - Kia Forum
10 posts
May 25, 2012
Intriguing problem - engine rough idle & hesitation ...
10 posts
Aug 31, 2011
2006 Kia Spectra engine stalls and bad idle, cleaning the ...
10 posts
Aug 30, 2010
2002 Kia Spectra Won't Go Out of Park - Kia Forum
3 posts
Oct 28, 2008
More results from www.kia-forums.com

Dec 17, 2015 | 2002 Kia Rio

1 Answer

Cods P1747,P0750,P0755,P0743


OK, so is it still setting the codes? Or has that gone away with the transmission harness repair? The idle is controlled by the Idle Air Control (IAC) solenoid. Ford has had a lot of trouble with these. However, the symptom is usually low idle speeds that cause the engine to stall. I think I would be looking for vacuum leaks. Ford 4.6L engines are notorious for the PCV hoses leaking at the elbow where it connects to the back of the throttle body.

Mar 12, 2012 | 1995 Ford Thunderbird

2 Answers

As you've probably heard before my 91 cav starts fine gets warm stalls at lights starts right back up but cuts off when i put it in gear


pull off the transmission transition switch wire pluged on to tranny
start car drive should be fine never hook op again 0 money
or pay 700 dollars to install a new one
or buy switch pull tranny and install your self

Jul 14, 2010 | 1991 Chevrolet Cavalier

1 Answer

I got a 1990 ford ranger 2.9 v6 its running very crappy


Fluctuating an high RPMs sounds like a leaking or missing vaccume hose to me, I had simmilar problem found open hole with hose off, replaced it now the RPMs are under 1000 again.
As for the stalling I also am having a simmilar problem, and am finding air in the fuel rail, I suspect the fuel pump is going.
I cant go more than a mile without problems.

Dec 03, 2009 | 1990 Ford Ranger SuperCab

1 Answer

04 Jeep starts but stalls when put into gear.


make sure your idle air control motor is working, if you give and hold gas pedal a little will it stay running in drive.

Oct 03, 2009 | 2004 Jeep Grand Cherokee

1 Answer

Pontiac G6 2005 - starts then stalls immediately


Chage the throtle possition senser.

Jul 03, 2009 | 2005 Pontiac G6

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8548 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...