Question about 1995 Subaru Legacy

Open Question

1993 LEGACY 2.2 RAD HOSES COLAPSE WHEN CAR SHUTS OFF.TEMP RISES WHEN DRIVING BUT DROPS ON ACCELLERATION?

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

L200 Warrior.Temp gauge rises then falls back to normal on driving.


The gauges rises fast and drops fast because there is air in the system. I would fill it first/purge the air out as it is running. If it still discharges on the floor, you might want to change the T stat and or water pump.

May 22, 2016 | Cars & Trucks

1 Answer

Temp guage Rises/almost oveheats when Heater is on. Temp Rises to almost H then drops fast to just above C and repeats but only while heater is on


The cooling system has an air pocket in it. The best solution is to have someone with a vacuum coolant system,and drain and replace the coolant. The only other way,is to jack up the front of the vehicle,and take off the radiator cap,and run it with the heater on full blast. Wait till the thermostat opens,(when coolant level drops)...then top it off while its still running.If you buy ,or have a friend who has a tool called an "Air Lift",..it will make this MUCH easier,and cleaner to fix.

Sep 23, 2012 | Ford Explorer Cars & Trucks

2 Answers

Why does top and bottom hoses collapse on a oldsmobile 88 95


as they get older they loose there stiffness some hoses even have a spring inside them to prevent this replacing them should resolve the problem hope this helps

Jun 17, 2010 | 1995 Oldsmobile Eighty Eight

1 Answer

Check engine code po125 - 97 GP 3.8 - heater blows cold as engine temp rises to redline, then kicks in HOT and engine temp drops to normal... REPEAT. Is this the code for coolant temp sensor? Where is it...


What your describing is either a sticking thermostat, a low coolant condition or a blown cylinder head gasket.The code is for coolant temp fault.Not always the temp sensor but it is located next to the thermostat housing.

Apr 17, 2010 | 1997 Pontiac Grand Prix

3 Answers

Having problem maintaining water temp after water


This is either an air lock or a leaking headgasket. Remove the rad cap, with the rad full, watch for air bubbles. You didn't tell us if you were adding coolant??

Mar 28, 2010 | 1993 Ford Taurus

1 Answer

Engine temp rising.


Change the thermostat & it would be good to flush & fill the cooling system.

Jun 21, 2009 | 1996 Nissan Maxima

3 Answers

No heat in car and temp gauge rises while driving but stays half


With engine cold, remove rad cap & check level in rad. Top it up if needed to 1 or 2 inches from top. Start engine, turn heater on (not defrost) and observe coolant level as engine warms up, add if necessary. Radiator fan should be off, and only come on when engine reaches normal operating temperature, for a short time, then shut off again. Let it run until that happens about 3 times, then put rad cap back on. If temperature gauge climbs up over normal toward hot, too much, shut it off. Do you now have heat? Is rad fan acting as I described? Let me know.

Jan 25, 2009 | 2001 Ford Escort ZX2

Not finding what you are looking for?
1995 Subaru Legacy Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...