Question about 1994 Jeep Grand Cherokee

1 Answer

Not geting electrical power to distributer or coil

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Check the Crank Shaft position sensor which is located on the drivers side of the transmission bell housing and will have three wires going to it. Also check the Cam shaft sensor which is located under the rotor button inside the distrubtor cap (it looks like a dust cover). If either of these have failed you'll get no spark.

Posted on Aug 24, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why no fuel, no spark?


Is there B+ ( power) , voltage to these components, fuel pump ,coils ? B+ voltage to PCM ? Do you know how to test automotive electrical circuits ? Go to you tube an check out basic automotive electrical trouble shooting videos , how to read a wiring diagram .Go to http://www.bbbind.com/free_tsb.html free wiring diagrams . click on electrical distribution under system , then under subsystem power distribution. . Check through diagrams to see where these components get battery voltage , an grounds . Could have a bad power relay. See if they have anything in common . Do you have a DVOM - digital volt ohm meter ? There are videos on how to use one on you tube . Your going to have to test to find out what the problem is . Good luck an happy hunting .

Mar 13, 2016 | 1996 Ford Explorer

1 Answer

Jeep is geting fuel but not steady fire has new plugs wires and distributer cap what to check next


check the coil and igniter pack, also dheck if u have a good earth to the eng

Apr 08, 2013 | 1996 Jeep Grand Cherokee

1 Answer

How to fix 2010 BMW 128i cigarette lighter not working


When engine working, ECU according to the sensor signal is identified as a cylinder ignition,
The ignition signal instructions, ignition control ignition coils in the primary circuit
Electricity or without electricity. When the ignition coil primary power circuit, the secondary coil
Produced by high voltage transmission to distributor, distributor shall, in accordance with the engine ignition
Sequence, which in turn will give the high voltage transmission cylinder, spark plug, spark plug flame, lit
The mixture formation within the cylinder. This way of distribution according to distributor distribution way.
auto diagnostic tool.

Mar 30, 2013 | 2006 BMW 1 Series

1 Answer

Electronic over ride


which vehicle/motor/year?

Mar 06, 2013 | Cars & Trucks

2 Answers

Mty 2000 dodge van turns over fine but wont start


Souond like it mite be the coil pack check in see if it geting fire if not coil pack should fix it

Dec 01, 2011 | 2000 Dodge Caravan

2 Answers

Car cuts out after it warms up..runs fine cold


age is showing cause some electric is heatng up-a relay--solenoid--switch etc--you need a diagnostic test-1st a scan then maybe inspection of wiring with instruments--------make sure uve done a tuneup-new dist cap and plug wires

May 31, 2011 | 1994 Buick Century

1 Answer

Car won't start, new battery, starter ok, just won't kick over Saturn 2004, 80,000 miles, oil change 2 months ago,


If the starter/Battery are ok.Check for spark by pulling off a sparkplug wire,have someone try to start hold wire near sparkplug tip you'll hear the spark jump to the plug tick..tick..tick..sound.Be carefull to hold wire just far enough to hear spark,also this is the secondary circuit from the coil it's high voltage wear a glove.If you smell gas youre geting gas if no spark it is 1 of the following.Bad Coil, or ignition modulator, crack in distributer, cracked wires that cause spark to not reach plugs.Good Luck.

Sep 09, 2009 | Saturn SL2 Cars & Trucks

1 Answer

Theres no sprk replaced coil,distributer cap and rotor


i would say module but havent a clue where it be ,never seen one of these cars before here in spain ,module could be inside distributor or under the coil or mounted somewhere else around the engine compartment

Jun 29, 2009 | 1995 Ford Taurus

1 Answer

Dodge d50 will not start


if distributor components + coil look good problem could be in the power module.

Jun 01, 2009 | 1985 Dodge Ram 50

Not finding what you are looking for?
1994 Jeep Grand Cherokee Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...