Question about Plymouth Scamp

1 Answer

How do i replace the axle seals on my 69 roadrunner. it has the dana 8.75 rear end. it is leaking the gear oil into my brake drums

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 120 Answers

First make sure that its not the wheel cylinder's causing the leak as well okay? if so, replace. thats pretty straight forward. If it is for sure the axle seals, then you will need to remove the brake drums. take off the differential cover. there should be like 13 bolts, empty out the fluid. Rotate the differential carrier unti you can see a small bolt. remove the bolt and take out the axle pin. Once the axle pin is out, then push ONE axle in until u hear something drop. this is a c clip that drops inside housing usually will land at the bottom in the remaining oil. pick out clip. keep off to the side as u will need to reinstall this clip later. then once clip is out pull axle out of tube, and set aside. there are multiple ways to remove the seal itself. you can use a seal puller, screw driver, pry bar, or the axle itself. Becareful not to scratch the bore where the seal goes or else IT WILL LEAK. then just do the same for the other side. pay attention for the bearings and not to nick them either, or else they will need to be replaced as well and that's much more of a pain in te ***, lol..good luck!

Posted on Aug 24, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace rear axle seal on my 86 k2500


need to remove diferential cove then on the spider gears caseyou see a 5 16 bolt to remuve the sode gear pin then you remuve the c clip and remuve axle

Sep 07, 2014 | Cars & Trucks

2 Answers

I HAVE A 03 TOWNCAR WITH LEAKING OIL AT THE RIGHT REAR WHEEL. I NEED HELP ON HOW AND WHAT TO CHANGE. ALSO SHOULD I DO BOTH SIDES. THANK YOU JERRY SORRELL 337-842-0485


Leaking oil at the rear wheels can be one of two things, Easy fix is brake fluid, this would be the rear brake wheel cylinder leaking. Check your brake fluid tank under the hood for low fluid. If that is ok. Your leak may be your rear axle shaft seal. You need to remove the tire/wheel ether way. Jack up the car to pull the wheel, take your lugs loose while the tire is still on the ground, it is easy to take them loose this way. Take the EM: brake off, and jack up this side of the car. Your car could have disk or drums as both are offered on the 2003 Town car. Once the tire is off you will see if you have disk or drums brakes. If drums you will need to pull the drum off at access the brake cylinder to see if that is leaking or not. If drums you have to back off the brake shoes by the adjusting wheel thru a small access window in the back plate. If you have disk brakes the caliper is right there and will be easy to see if it is leaking. If you have determined it is the rear axle seal leaking, this may be best done by a shop, due to needing a few special tools to remove the axle and then reinstall a seal. You will need a slide hammer. If drum brakes you will have to remove the brake backing plate, this means shoes and all hardware, please take pictures and get as good focus as you can to see how everything goes back together. Once down to the axle mounting, remove the 4 bolts and attach the slide hammer and pop out the axle, catch any fluid that will leak out. Hope this helps FixYa up.

Aug 13, 2011 | Lincoln Town Car Cars & Trucks

1 Answer

How do you replace the rear axle seal?


Its easiest to buy a hanes manual for this vehicle for this repair. Here goes. Remove the tire and wheel. Remove the drum if drum brakes or brake caliper and rotor is its disc brakes. remove the cover on the rear differential. remove the small bolt that holds the lock pin in place. slide the lock pic out of the spider gears. **its very important not to let the ring and spider gears turn at this point or the spider gears will fall out of the carrier. Once the lock pin is removed then go around to the axle where the tire was and push it in (toward the rear end) as far as it will go. Go back to the differential and remove the retainer clip (looks like a big "C") from the axle shaft. You can now pull the axle completely out of the housing. At this point you will be able to see the axle seal and the wheel bearing located behind the seal. Carefully remove the old seal (be sure not to damage the wheel bearing) and install the new one. You can then put everything back together. Make sure to refill your differential with oil when everything is back together. check your owners manual for the exact gear oil that you need because these cherokees can use different types depending on the model and towing capacity.

Oct 09, 2010 | 2002 Jeep Grand Cherokee

2 Answers

1994 buick roadmaster, oil leaking out of right rear axle, checked brake fluid is full, could it be differential oil leak @ end of axle??


If what you see leaking is very oily and does not evaporate, likely it is an axle seal. If there are no leaks in the brake system, that's the only thing back there that can leak. If the axle bearing is going away, it can damage the seal so make sure you look for small shiny metal flakes behind the seal when you replace it or you will be doing the job again very soon. Can't remember...that IS rear wheel drive right?

Dec 01, 2009 | 1994 Buick Roadmaster

3 Answers

Rear brake drum leaking on my 1989 ford bronco 2 y did it happen and how do u fix it


The drum isn't leaking, either the wheel cylinder is leaking or the line is leaking

Oct 07, 2009 | 1989 Ford Bronco II

2 Answers

1993 Ford F-150 drum brake problem


It appears the rear axle shaft seal is leaking. You will need to pull the axle and replace the seal. Then check the rear end for adequate gear oil. The iron filings I am not to sure about. It sounds as if something came loose from the brakes or brake hardware and got chewed up in the drum. You will need to replace the brake shoes and maybe the brake hardware kit. Always change the shoes or pads on both sides when working on brakes, rear or front. If the inside of the drum is not perfectly smooth it will need to be turned or replaced. If this were brake fluid leaking from the wheel cylinder the master cylinder would be low on fluid and your brake pedal would go down much further than normal.

Jul 18, 2009 | 1998 Ford F150 Regular Cab

1 Answer

Grease and differential oil inside left rear drum


Not that difficult, raise and support the rear of the truck and remove the wheels. Might as well replace both sides so you know you have new seals, remove the differential cover and drain the fluid. Once differential is opened and cleaned , remove the axle "C" clip that hold the axle in place and slide the axle out. Once the axle is out remove the wheel seal and clean around the area. This would be a good time to replace the wheel bearing too since you have access to them and there not that expensive. Install the new bearing and seal, note make sure you oiled the bearing and seal before installing it back and take care when installing the axle back in and "C: clip. Use RTV silicon gasket maker to seal the differential cover and wheels back on and lower. If your lazy like i am, you can drain the differential fluid and replace it with a 50/50 mix with gear oil and Lucas engine oil additives. That may stop the leak and get you a few more miles. You gear oil is (ford 75W-140) (Dana 80W-90)and the capacity is 2.6 liters and 3.5 liters if you have the 10.25 Ring gear. Good luck and hope this helps.

Jul 07, 2009 | 1998 Ford F150 Regular Cab

2 Answers

Rear wheel seal leaking


Remember SAFETY FIRST. Jack up the right rear wheel, support the axle with a jack stand, remove the wheel, the brake drum, the banjo cover or differential cover. Allow the gear oil to drain out into you drain pan, carefully and slowly spin the ring gear (watch out not to pinch your fingers) look for a small bolt that is restraining the king pin, remove the bolt and then carefully slide the pin out !(don't spin the axles or ring gear while the pin is out) if you do the bushings and spider gers will move out of their places. After the pin is out then go over to the exposed axle and push it in until it stops. Go back over to the pumpkin and look inside, for a "U" shaped washer it will be on the end of the axle. Remove it from the axle. Now you can remove the axle and replace the wheel seal. Either rent a seal installing tool or carefully use a block of wood and evenly install the seal. If you kink or damage the new seal remove it and try it again. When you put everything back together put a little thread lock on the bolt for the king pin. dont over tighten it, could snap it. Let me know if I can help any more.

May 27, 2009 | 1999 Ford Ranger SuperCab

4 Answers

Rear end (axle)


call jeep and give them last 9 digits of your vin and ask for three things -Differential Type,Gear ratio, and Track lock- They will give you
1) Dana 35 or 44
2) Gear Ratio 3.31 or 3.73
3) Track Lock - yes/no

Jan 11, 2009 | 1998 Jeep Grand Cherokee

1 Answer

2000 gmc both rear tire oil leakage.


You are correct, it's not brake fluid. Check the level in your rear axle, it sounds like you have bad seals in the axles allowing the rear differential gear oil to leak inside the brake drums.
This is a heavy weight oil, 80 or 90 weight. This leakage will ruin your brake pads, and if enough leaks out, your rear differential will blow. The seals aren't expensive, but it's a lot of labor to pull everything apart to get at the seals, plus new rear brakes. My Ford ( and I'm sure your GMC) require removal of the rear axles to change the seals. Good Luck! countrycurt0

Sep 17, 2008 | 2000 GMC Sierra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

167 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

75842 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...