Question about 1997 Ford Econoline

1 Answer

When the Van is in Drive and stopprd at a Stop Sign or Light the Van stats to jurk forward like it is slipping and the Engine starts to run rugh

Posted by on

1 Answer

Look for a vacuum leak, open up the motor area and listen for a hissing sound. After you locate the air leak, replace the little rubber hose with new vacuum hose avalible at your local auto parts store. If it still jerks forward after you replace the hose then you will need to replace the (IAC) idle control valve. Click on the link below to view:

http://www.partsgeek.com/gbproducts/WC/5027-01017385.html?utm_source=google&utm_medium=ff&utm_term=1997-1999+Ford+Econoline+Super+Duty+Idle+Control+Valve+Delphi+97-99+Ford+Idle+Control+Valve&utm_content=YN&utm_campaign=PartsGeek+Google+Base

Posted on Aug 24, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1992 ply voyager.it passed inspection,then the engine light stays on, now when i drive the van makes a loud jurking movement the stops and starts again. plse help.


You have an engine light on

So as with ALL Vehicle problems

You check for codes & resolve them first

Simply can't guess at vehicle problems without
a vehicle to drive & test

Apr 24, 2014 | 1992 Plymouth Voyager

1 Answer

Starts and cuts off


serial number/keygen for registry reviver

Jan 28, 2014 | Cars & Trucks

1 Answer

Coming to stop sign by putting break gear slips then return to park move to drive runs. second as i drive in curves slips but as give gas enough continues running.


Just to make sure I got this right. If you come to a stop, the car won't pull again unless you put it in park? Then, if you start into a curve, the transmission starts to slip unless you give it more gas? This could be signs of a bad torque converter, failing fluid pump (not as likely), or burnt/low transmission fluid level. Check the transmission fluid after the vehicle has been driven (warm engine), leave it running, and on a level surface. Check the level twice and take the lowest reading.

Dec 29, 2011 | 1993 Pontiac Bonneville

1 Answer

My car all of a sudden would not go forward in drive it went in reverse so i parked it for about twenty min and when i started the car again it started to drive forward again but as soon as i stoped at a...


Check your transmission fluid level. This is done with the engine running. If it is low, please understand, that the add mark on a trans dipstick, usually means a pint, not a quart as your oil dipstick does.

Aug 14, 2011 | 1995 Lincoln Continental

1 Answer

2001 Mazda MPV, 2.5L eng. During accelerating on to highway, van lost power. Van continued to operate but with little power available. I have no engine light and my code "checker" shows PASS (no...


looks like not enough fuel pressure, check the fuel filter.
and the fuel pump pressure.with car running 60 psi
the pump is located at the rear seat driver side you have to remove the carpet to access the cover. if the fuel pressure checked "OK" suspect defective maf sensor (sometimes defective maf sensor do not show errors codes)another way to test is disconecting the maf sensor and start the car (computer goes to limp in mode) and works little better,or check by scanner idle= low grams per seconds and increase when accelerate.

May 02, 2017 | 2001 Mazda MPV

1 Answer

Run good till the check engine light go off


Check the fuel lines under the car. Don't actually start the car though, just turn the key until you hear the fuel pump turn on. This will load the fuel system and you will be able to see leaks (or sprays) under the car because of the pressure. If there are no leaks, see if the car runs perfect with a full tank of gas compared to a low tank. It should drive good turning left, but it might **** turning right or after a sudden stop. This could mean you have a crack in the seams of your gas tank or that your fuel pump is going bad (or a little of both).

Jun 07, 2010 | 1991 Honda Accord

1 Answer

Van dies while at a stop sign or light won't start back until moved manually


take a little time to check the air/fuel filters and spark plugs if you have not done so in a long time. all of those things will cause the van to stall at light or stop sign. replace all items that need replaceing. a little service work will keep your van running for a long time.

May 03, 2010 | 1996 Dodge Grand Caravan

1 Answer

1992 Dodge 250 van, 318, Automatic - Dies when coming to a stop


I cannot see how adding a fuel additive would help to be honest. I would be looking for a split or leaking vacuum line, I have even seen a leaking evap canister before that caused a similar problem. Does the engine pull clean and strong when it is warm or at cruising speeds? Does it feel like its running lean or misfiring?

Apr 08, 2009 | 1992 Dodge Ramcharger

Not finding what you are looking for?
1997 Ford Econoline Logo

Related Topics:

71 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...