Question about 1992 Buick Roadmaster

Open Question

HOW TO REPLACE IGNITION SWITCH ON 1992 BUICK ROADMASTER

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Car will not start

If the starter is good, a bad ignition module or failed fuel pump will produce similar symptoms, i.e. no cranking, nothing happening when you turn the key. Ignition module sits under the distributor cap and is about the size and shape of a cassette tape with 2 female plugs and one male plug. Quick way to check the fuel pump is to put the car in a quiet place like inside the garage. Find a quiet friend to sit behind the wheel and turn the key so the dash lights come on, DO NOT TURN THE KEY FULLY LIKE YOU'RE TRYING TO START. You get down on the ground and listen near the gas tank for the quiet hum of the fuel pump that tells you it is working.

Posted on May 31, 2009

saailer
  • 1868 Answers

SOURCE: ignition switch 1992 Lebaron

Hello! Disconnect +battery cable...Remove tilt lever...Remove 3 Torx column cover attaching screws...Then the upper and lower column column covers...Using a Torx with a security tip (also called tamper proof tip) #440-tx20H... Remove 3 ignition switch mounting screws...Carefully pull switch away from column...Release 2 connector locks on 7 terminal wiring connector...Then disconnect from ignition switch...Release connection lock on 4 terminal connector...Then disconnect from ignition switch.

Guru..................saailer

Posted on Jan 12, 2010

emissionwiz
  • 75235 Answers

SOURCE: replace heater core on 1992

It appears I was incorrect about removing the dash assembly, here are the instructions from a Buick owners club.

Under the passenger dash is an access panel that will allow you to remove the heater core, it really isn't that hard, there are lots of little dash screws and panel screws to remove before you get where you need to be but at least it is roomy. The AC evaporator is located by the heater core. I will give you a tip. I changed mine last year and the heater core that I ordered for my 92 Roadmaster was not correct, when I took my old one out and matched it in a book at the local part store, the heater core for my vehicle was listed as a 96 Caprice???? The car has been in my family since it was purchased new and the heater core had never been changed!!!! Explain that one!Oh yeah, one more tip, if your heater core is leaking, this access panel lowers towards you, if there is nasty sweet smelling water in there it will pour all over you, be careful! Caprice parts are the same as a Roadmaster,so if you ever need anything just look up caprices

Posted on Dec 16, 2008

  • 2 Answers

SOURCE: 1992 buick roadmaster wont start at times

you have a bad connection on the ground wire to the starter the screw get loose on them

Posted on May 21, 2009

  • 563 Answers

SOURCE: starter install 1992 buick roadmaster

Do you mean the starter-motor removal?
Disconnect the battery. Disconnect the red/positive battery cable from the starter. Trace the red/positive cable to where it ends (that's the starter), disconnect it from the solenoid. Use applicable socket wrench/flat-wrench to unbolt/remove the starter-motor. Installation is reverse of removal.

Posted on Nov 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replace vent window 1992 buick roadmaster


Remove window and side vent track.then you can remove vent glass

Aug 24, 2016 | 1992 Buick Roadmaster

1 Answer

Replace fuse dashboard 1992 buick roadmaster


press the helpful button and check links below, it is a 1993 manual, should be the same.
one fuse panel on that vehicle. It's on the driver side end of dash, you have to open the driver door to get at it. The box is under the hood, labeled relay center I believe. http://www.vadengmpp.com/owners-manual/buick/1993-Buick-RoadMaster.pdf

Buick Workshop Manuals

1992 Buick Roadmaster the tail lights nor dash lights work tried replacing...

Feb 03, 2016 | Buick Cars & Trucks

1 Answer

How do i replace backup light bulbs


then look underneath on the bumper

Oct 10, 2014 | 1992 Buick Roadmaster

1 Answer

Clicking sound when turning the ignition 1992 buick roadmaster


Just going by what you described it sounds like battery or starter. I bet the car starts when it is jumped off. Take it somewhere to have the battery checked (Auto Zone, etc where they will check it for free.) If its not the battery then take it somewhere to get the starter and solenoid checked. Either solution shouldn't be extremely expensive.

Apr 29, 2012 | 1992 Buick Roadmaster

1 Answer

Why would the fuel pump work but not when the car is running


more than likely your ignition switch check to see if you have fire in the cylinders as these are connected if not replace ignition switch located under dash on or close to steering column

Jan 07, 2012 | 1992 Buick Roadmaster

1 Answer

1992 buick roadmaster. how do you replace the neutral safety switch


HI, IT IS UNDERNEATH THE AIR CLEANER ASSEMBLY ON TOP OF TRANSMISSION. SO REMOVE AIR CLEANER, REMOVE THE WIRE CONNECTOR,THE 2 OR 3 13MM BOLTS, 1 15MM NUT, AND LIFT OFF SHIFT CABLE, THEN REMOVE. INSTALL IN OPPOSITE ORDER. THANKS MOTOR62500.

Dec 21, 2010 | 1992 Buick Roadmaster

1 Answer

How do I locate the EST(electronic spark timing) module so I can disconnect it in order to check ignition timing on a 1992 Buick Roadmaster?


It is flat,and black in color,and has a wide flat connector with multi wires going to it.On firewall,or mounted on air cleaner housing.

Jul 08, 2010 | 1992 Buick Roadmaster

1 Answer

We have a 1992 Buick Roadmaster Sedan. We are


try to flush the heater core this should fix the problem

Feb 24, 2010 | 1992 Buick Roadmaster

1 Answer

1992 buick roadmaster wont start at times


you have a bad connection on the ground wire to the starter the screw get loose on them

Mar 17, 2009 | 1992 Buick Roadmaster

Not finding what you are looking for?
1992 Buick Roadmaster Logo

Related Topics:

450 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...