Question about 1998 Oldsmobile Intrigue

1 Answer

Turn signal electronic flasher switch - 1998 Oldsmobile Intrigue

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,796 Answers

Hi!!
You did not say much but if what you need is the location, it is under dash, driver side by steering column, it is shaped like a regular relay but is twice as long, dark brown or black in color.
Good luck!! Don't forget to rate this post!!!

Posted on Aug 23, 2010

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

ltfrc
  • 227 Answers

SOURCE: flasher or turn signal switch

When you select left or right do any of the bulbs come on? If you select left check front and back left side if one of the bulbs did not come on the flasher will not work. Change the bulb that is out. Same with the right. If the fuse for the turn signal is good (check fuse or replace do not use visual, some appear to be good but are not).
The emergency flasher is different from the turn signal flasher. Look at manual for location of turn signal flasher. If you manually lift and lower turn signal control you may hear a clicking under the dash to locate the flasher.

Posted on Jan 12, 2009

  • 1 Answer

SOURCE: electronic flasher

It is in the fuse panel. Open your front car door and you will see a panel on the outside edge of your dashboard (hidden when the door is closed). That is where the fuses are and it is the big square fuse in the center.

Posted on Nov 26, 2008

  • 1 Answer

SOURCE: Where do I install the electronic flasher relay for the turn signals?

If the turn lights come on and don't flash, like mine did, I found the flasher behind the ashtray.If you can't reach it,there are only 4 screws holding the bracket (1/4 in.nut driver) that holds the ashtray.

Posted on Dec 04, 2008

bunnydawg
  • 5158 Answers

SOURCE: 1997 mercury cougar electronic flasher location

it's likely in the fuse panel under the dash... on my windstar... it was larger then the other relays and blue.

Robert

Posted on Jan 21, 2009

  • 1 Answer

SOURCE: turn signals hazards flasher don't work jeep

I NEED TO LOCATE THE SWITCH WHERE IS IT ?
MY INDICATORS NOR HAZARD LIGHTS ARE WORKING I DONT KNOW WHAT IS WRONG WITH IT CHANGED BULBS BUT NOTHIGN THEY ALL WENT OUT AT THE SAME TIME
SO THERE MUST BE A RELAY SWITCH SOMEWHER BUT DONT KNOW WHERE ?
THANKS FOR HELPING

Posted on Apr 01, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The hazard back lights wont quit blinking when car is running even when i pull the fuse on a 2002 buick regal


What fuse are you pulling ?

Hazard Lamps
The hazard warning switch is part of the turn signal switch. The turn signal switch receives battery voltage at all times through the HAZARD SWITCH Fuse. When the hazard switch is placed in the HAZARD position, battery voltage is applied to the hazard lamp/turn signal lamp flasher. The hazard lamp/turn signal lamp flasher sends a turn signal flasher signal to the turn signal switch. The turn signal switch provides all of the turn lamps and turn indicators with the turn signal flasher signal, simultaneously flashing them on and off.

Turn Signal Lamps
The front turn signal lamps are made up of the front park/turn signal lamps and rear turn signal lamps. The front turn signal lamps flash with the rear turn signal lamps when a turn is initiated using the turn signal/multifunction lever. The turn signals will operate only with the ignition switch in the RUN position and will not operate during hazard flasher operation.
When the ignition is turned to the RUN position, battery voltage is supplied to the TURN SIGNAL Fuse. Battery voltage is then applied through the turn signal fuse circuit to the turn signal switch. When the turn signal switch is placed in the LH or RH position, voltage is supplied to the hazard lamp/turn signal lamp flasher. The hazard lamp/turn signal lamp flasher supplies a turn signal flasher signal to the turn signal switch. With the turn signal switch in the LH or RH position the corresponding turn signal indicator, rear turn signal, and front turn signal receive the turn signal switch signal and will flash. The front turn signals receive the turn signal switch signal from the turn signal switch via the BCM. The turn lamps are permanently grounded.

Replace the turn signal switch. Refer to Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle in Steering Wheel and Column - Tilt.

Feb 11, 2017 | Buick Cars & Trucks

1 Answer

My turn signals don't work when activated on my 99 Saab 9.5...what is the problem and how can I repair?


Do the indicators light up on the dash when switch is activated? If not possible fuse or electronic flasher assembly. Do you hear any click when first activated? If fuse good for signal lights, suspect faulty electronic flasher. This is normally located under the drivers dash area and can be a pain to locate. Sometimes they incoporate the 4 way flasher in the same unit. Turn on the 4 ways and follow the click sound. The flasher will control the signals and 4 ways or the flasher will be close to the 4 way flasher and look similar

Nov 15, 2015 | Saab Cars & Trucks

1 Answer

1998 Toyota Avalon turn signals stopped working


Its either the flasher's, the turn signal lever switch or the hazard switch.
Try pulling one of the flashers out and see if the other system starts working.
Has anyone installed aftermarket electronics or tampered with the wiring in either system? Like an ALARM system? Stereo?

Jul 08, 2013 | Cars & Trucks

1 Answer

I have an 02 kia sportage. my signal lights come on but dont blink outside. no lights for the signal lights come on on the dash at all. also, no hazard lights.


If the 15A HAZARD fuse in the passenger compartment fuse box is OK, power is getting to the hazard function of the flasher unit. Pressing the hzard switch should cause the hazard lights to flash. HOWEVER, there is an electronic time and warning indication system module connected to to the hazard switch lead and that may be affecting things. If the 10A TURN fuse is OK, power is applied to the turn switch (with the engine in START or RUN) and you state you can select a right or left turn. HOWEVER, the RED/WHT and RED/BLU outputs from the flasher unit connect directly to the front and rear turn lamps and the instrument cluster turn indicators so you are not getting any flasher output. Again, that electronic time & warning indication system module could be affecting things

Oct 26, 2012 | Cars & Trucks

1 Answer

92 sunbird turn signal will not flash only hazard signal works


I have the same Problem. Replaced fuses, turn signal lights, electronic flasher and steering column switch, I had an electrician check it out, and assess that there is a short somewhere in the circuit before the flasher. Hard to get at.

Feb 18, 2010 | 1994 Pontiac Sunbird

3 Answers

My turn signals on my 87 camaro don't work but hazards do.anyone know the problem?


Most likely it is a defective turn signal flasher......put in a electronic unit when changing it.

Oct 29, 2009 | 1987 Chevrolet Camaro

1 Answer

Turn signals inside and outside of car do not work


Did you replace the turn signal flasher unit?
Put in a electronic flasher when changing it.

Oct 29, 2009 | 1995 Chevrolet Cavalier

2 Answers

96 ford tarus turn signal


The turn signals and the emergency flasher are controled by a single electronic flasher unit. It looks like an electronic relay and is located on the far left underside of the dash. It is on a mounting bracket and has a three wire connector. If you do not hear this clicking when you use the turn signals or the emergency flasher it may be bad. Just remove the connector and remove the one screw holding the flasher to the bracket. Be sure the replacement is identical to the old one and compare them before installing the new one.

You may want to also check the turn signal bulbs also. Other causes would be bad signal and flasher switches, bad bulb connectors, and opens or shorts in the wiring.

Nov 19, 2008 | 1996 Ford Taurus

Not finding what you are looking for?
1998 Oldsmobile Intrigue Logo

409 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...