Question about 2007 Ford Expedition Eddie Bauer EL

Open Question

Locate & Replace backup up sensor 2007 Ford expedition

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 236 Answers

SOURCE: PRNDL error, no backup aid

i think the computer is telling you that it is not recognizing what gear you are in as you can only start the vehicle in park or nuetral. thats the best i can do for you sorry

Posted on Jun 24, 2009

  • 8197 Answers

SOURCE: how to reset tire pressure sensor light on 2007

To reset the tire pressure light you need to get the tool.

You can get the tool here on link below.

Posted on Nov 09, 2009

  • 1428 Answers

SOURCE: 2007 ford expedition limitid

The car will take 6 quartz of oil.


Posted on Jan 12, 2010

SOURCE: 2007 Ford Expedition EL Limited 4x4 ... no

On the bottom of the trans pan,there should be instructions.

You warm up the trans to 180 degrees or more,hold the drain plug with a 22mm wrench or 7/8",then remove the 1/8" pipe plug in the center with a torx bit.
If filled correctly fluid should just barely run out.

Capacity is around 12 quarts total.
You only get about four to four and a half, if you remove the drain plug or remove the pan to change the filter. Some extra will drain down while your doing the filter.
You need to have a special container that hold two quarts at a time, then you put an air hose to it,to pressurize,and blow the new fluid in,warm up,and any extra will drain back into your fill container.
I found on my Lincoln LS, you can fill it by removing the 3/8" tail housing plug. The other rear drive fords may be similar.

You want to get the old fluid out including your power steering every couple years or 30,000 miles.

I drained mine twice, ( 8 quarts),drove it two weeks to make sure it shifted okey,then repeated. (16 quarts total) I prefer that to a flush machine. I used to own a trans shop.

Use Mercon V and a bottle or two of Red Lubegard on final refill.
Use the power steering additive from lubegard with the correct P/S Fluid.
They are the only two chemicals I ever use on a vehicle,that I know ,not only work, but are necessary on some foreign trans.

If you look at the drain plug when it is out,you will see an extension tube. That is how the correct level is obtained with the torx plug out and fluid warmed up. You need the vehicle up on stands and level,so you can get under it.

Posted on Aug 17, 2010

  • 1 Answer

SOURCE: how to replace rear brakes on a 2007 ford

I had the same problem ... seemed the assembly was too thick to fit back in. I ended up nipping off the end hook (with a grinder) of one of the pads so it could slide in. Once in, the pad can't come out anyway.

Posted on Oct 13, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

The reverse backup alarm isnt working

Ford Reverse Backup Sensor not working - YouTube

? 2:11
Oct 26, 2013 - Uploaded by MOSES CALI
Ford Expedition. Parking sensor not working. Diagnoses works for most car makers.

Troubleshooting Backup Sensors - YouTube

? 8:30
Aug 15, 2014 - Uploaded by DeathScouter
Troubleshooting and replacing backup sensors on a 2006 Ford F250 truck, but information is ... Offered up an aftermarket back up camera for $150 in place of repairing the factory system. ...The backup alarm did not work.

Nov 19, 2015 | Cars & Trucks

1 Answer

Check backup aid

Backup aid not working - Ford Expedition Forum > ... > General DiscussionApr 29, 2004 - 6 posts - ‎2 authors Join Date: Apr 2004. Location: ... Suddenly the reverse sensors stopped working. ...This may be a longshot, but if I saw a the message "Check Backup Aid", I'd look to see if a fuse had burned out. Share ... HTML code is Off.

Oct 01, 2015 | 2004 Ford Expedition

1 Answer

2004 ford expedition backup sensor not working


Backup aid not working - Ford Expedition Forum > ... > General Discussion
Apr 29, 2004 - 6 posts - ‎2 authors Join Date: Apr 2004. Location: ... Suddenly the reverse sensors stopped working. ...This may be a longshot, but if I saw a the message "Check Backup Aid", I'd look to see if a fuse had burned out. Share ... HTML code is Off.

Oct 01, 2015 | 2004 Ford Expedition

1 Answer

Cam & crank timing marks 2007 expedition

If the codes were not there before then your chain alignment is off for sure.

May 02, 2014 | 2000 Ford Expedition

1 Answer

2007 Ford Expedition 5.4L revving while driving normally after sitting idle...sometimes will give a **** after revving. Check enging light just came on. Autozone said code PO171 & PO174. Fuel filter...

Replace the spark plugs & only install the one piece
Champions 7989

Replace the front or upstream Oxygen Sensors at 100,000 miles

Clean the MAF Sensor--CRC MAF Cleaner (instructions on can)

The 171 & 174 are lean condition both banks,your doing the
sensors based on mileage & the fact their about to fail or slow
down anyway (Preventative Maintenance)

Also check for other codes & vacuum leaks anywhere,intake,exhaust
before converter,evap system,pcv hoses

Egr Valve may be a problem also

Need to be more proactive thru out the year & look for problems
not just drive until they happen

Fords have many COP Ignition Coil failures,one or several a year

Need a 20 mile road test with professional scan tool or software
along & 2 drivers to look at data,fuel trim,cylinder misfire counts,
codes not seen by code reader,etc,etc.

Spray Throttle Plate with CRC Throttle Body Cleaner

Oct 09, 2012 | 2007 Ford Expedition

1 Answer

Why is there no power to third row seat?

Power 3RD Row Seat Problems and Tranny Shutter - Ford Truck ... > ... > Expedition & Navigator
Mar 27, 2014 - Expedition & Navigator 1997 - 2002 and 2003 - 2006 Ford Expedition andLincoln Navigator SPONSORED BY: ... First the 3RD row seats won't fold down, noclicking, no sounds, nothing. I the fuses are good and there is power at the fuse box, but no power at the motors or switches. Based on continuity ...

3rd row powerfold seat stuck down - Ford Truck Enthusiasts Forums > ... > 2007 - 2014 Expedition & Navigator
Mar 14, 2010 - 3rd row powerfold seat stuck down 2007 - 2014 Expedition ... 2010, 2011, 2012, 2013 and 2014 Ford Expedition and Lincoln Navigator ... I also tried lifting the seat while my wife was pushing the button to raise it, to no effect. There is defnitelypower going to the motor but it just isn't ... Join Date: Feb 2005.

No power to third row seat on 2005 lincoln navigator - Fixya
Apr 4, 2012 - no power to third row seat on 2005 lincoln navigator third row seat is ... U will have to replace the entire power seat transmission, there is no ...

Lincoln Navigator Review -

Apr 04, 2012 | 2005 Lincoln Navigator

1 Answer

My 2007 expedition has jerky feel when in low speed and someone suggested it was the ignition coil . How do I change it?

If you never installed the new one piece
spark plugs, that is the number one reason

That should be a 3 valve 5.4 & at least 2 or
more plugs are are going to break on removal
Research that on internet first. There is a lot
about the ford glued together plugs

Only Champion makes the correct spark plug
CHA 7989 at NAPA about $16.00 ea

You will get at least 1 bad COP Ignition Coil
a year, on all Fords from 1998 thru 2011

If you got 100,000 miles on it ,the front (2) O2 Sensors
surely slowed to a crawl,change them. Only the ones
in converter inlet

Clean MAF Sensor

You can not drive any of these vehicles, especially a
ford product & never look for problems through out the

You have to be pro active & expect issues & actually go looking
for things or have it act up or break down. Too much in the
way of electronics.

Jun 27, 2011 | 2007 Ford Expedition EL XLT

1 Answer

I locate oxygen sensor on my ford expedition

for 1998 Ford Truck Expedition 4WD 5.4L EFI 8cyl the Oxygen Sensor is located under vehicle, driver side, below seating area, mounted in exhaust pipe in rear of catalytic converter.

Application: Number three

Hope helps (remember rated this).

Aug 09, 2010 | 1998 Ford Expedition

1 Answer

I can't locate the IAC or idle air control valve in my 97 ford expidition 4.6l v8 triton. can anyone help me w/ this? Tnx & more power..

I.A.C sit in top on T.B.I. it's held on by two 8mm bolts, remove bolts clean surface replace gasket and reinstall sensor.

Nov 27, 2009 | 1999 Ford Expedition

1 Answer

2007 Ford expedition won't start

ur oil pump may be failin-there r sensors everywhere on new cars-keepin u from starting as safety measure-computer systems r complex n things dont always show on 1 scan-they kinda hav the mindset of a pc

Sep 15, 2009 | 2007 Ford Expedition Eddie Bauer EL

Not finding what you are looking for?
2007 Ford Expedition Eddie Bauer EL Logo

Related Topics:

122 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers


Level 3 Expert

5522 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides