Question about Mitsubishi Montero Sport

1 Answer

2001 MONTERO SPORT 3.0L 6CYL I NEED A PICTURE OF EGR SOLENOID OR LOCATION THAT CAUSE P0403. I SAW MANY SOLENOID BUT WHICH ONE.

Posted by on

  • Rudy Cordova
    Rudy Cordova Aug 23, 2010

    THANK YOU VERY MUCH. THIS IS VERY HELPFUL.

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,272 Answers

Follow the vacuum lines on the egr valve to the solenoid that actuates the egr valve. Check the fig and see the yellow arrow pointing solenoid and the white arrow is pointing to the EGR.:--2001 MONTERO SPORT 3.0L 6CYL - 163f91d.jpg
Check out.Thanks.

Posted on Aug 23, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Failed smog +egr valve 2001 Mitsubishi montero sport


I need the exact readings of the gas analyzer sheet and the cause of the functional EGR failure.

Nov 10, 2016 | 2001 Mitsubishi Montero Sport 4WD

1 Answer

Hello I have a huyandai Tucson 2005 Today I check with device it sayes P0403 EGR . What is this . How can I arrange that. It's important or not . Can I drive without arrange that.


P0403 - OBD-II Trouble Code - RepairPal

repairpal.com > Encyclopedia > Exhaust & Emissions
Definition of error code P0403 - Exhaust Gas Recirculation Circuit Malfunction. ... TheEGR OBD-II monitor deploys a set of test criteria that are usually run ... Problem, a Plugged or Restricted System, or a Defective Feedback Device ... Nissan ' Volkswagen ' Chrysler ' Lexus ' Mercury ' Cadillac ' Hyundai ' Buick ' Volvo ' AudiMissing: tucson ‎sayes

OBD-II Trouble Code: P0403 Exhaust Gas Recirculation ...

www.obd-codes.com/p0403
Causes. The causes for a P0403 EGR code could be any of the following: ... If the solenoid does operate, you'll have to check current draw on the ground circuit.Missing: huyandai ‎tucson ‎device ‎sayes

Egr P0403 Fault Code Help - Hyundai Forums : Hyundai Forum

www.hyundai-forums.com/...xg.../102478-egr-p0403-fault-code-help.ht...

Dec 12, 2015 | Cars & Trucks

1 Answer

OBD-11 codes 0403 & 0405


code p0403 refers to EGR --circuit malfunction===causes ---wiring--EGR solenoid---ECM
code p0405 refers to EGR valve position sensor A --low input===causes ---wiring ---short to ground---EGRF valve position sensor--- ECM.
By only changing the EGR valve you have not fixed the problems that cause the valve not to work.

Dec 22, 2013 | 2001 Chevrolet Lumina

1 Answer

How to codes p0032 an p0403 on a 2005 pacifica


There is a very common problem with early Pacificas and several other year models of other Chrysler cars and vans that causes the codes P0032 and P0403 to set and its not due to a failing HO2S sensor or a bad EGR solenoid. It is in most cases caused by a bad ground to the Exhaust Gas Recirculation (EGR) solenoid. The ground you need to check, at least on the Pacificas, is the G100 ground located on the left frame rail below the battery. Make sure its clean and tight with no signs of corrosion. They are known to break and come loose.

Feb 04, 2013 | Chrysler Pacifica Cars & Trucks

1 Answer

I have a code p0403 on my 2003 ford escape


Hi,


This is an issue w/the EGR system.

The causes for a P0403 EGR code could be any of the following:

  • Bad EGR solenoid
  • Excessive resistance in control circuit (PCM controlled ground) due to an open, chafing or damage to the harness
  • Poor connection at the EGR solenoid harness (worn or loose pins)
  • Water intrusion at the EGR solenoid harness
  • Blockage in EGR control solenoid holding solenoid open or closed causing excessive resistance
  • Loss of supply voltage to EGR solenoid
  • Bad PCM


How many miles/kms on the Escape? If the EGR is bad, it could be due to a plugged catalytic converter in the exhaust.


Td

Nov 06, 2012 | 1999 Isuzu Rodeo

1 Answer

2001 mitsubishi montero sport code po 403



Trouble Code: P0403

EGR Control Circuit Malfunction
Possible Causes:


EGR solenoid control circuit is open or shorted to ground . EGR solenoid power circuit is open (check power from relay) . EGR solenoid is damaged or has failed . PCM has failed .

Sep 11, 2012 | Cars & Trucks

1 Answer

Code p0403 on a 2001 chrysler intrepid


Hi there:
P0403 - Exhaust Gas Recirculation Circuit Malfunction



The most common failure is the EGR solenoid goes bad. The code will not set and turn on the light until the car's computer has gotten around to completing the EGR self-test.

The P0403 indicates the computer is not seeing any voltage on the blue wire coming back from the egr solenoid.


With the ignition on and engine off, use a scan tool to activate the EGR solenoid. Listen or feel for a clicking, indicating that the solenoid is operating.

If the solenoid does operate, you'll have to check current draw on the ground circuit. It should be less than one amp. If it is then the problem is intermittent. If it isn't then there is excessive resistance in the circuit and perform the following

1. When it's activated see if you can blow lightly through it. IF you can\'t there may be a blockage causing excessive resistance. Replace EGR solenoid as needed. If there is no blockage, disconnect the EGR solenoid and the PCM connector containing the EGR solenoid control circuit. Using a digital Volt-Ohm meter (DVOM) check resistence between the control circuit and battery ground. It should be infinite. If it isn't, then there is a short to ground on the control circuit. Repair the short to ground and retest as needed.

2. If the solenoid doesn't click as it should, disconnect the EGR solenoid connector and connect a test light between the two wires. Using the scan tool, command the EGR solenoid on. The light should light up. If it does, replace the EGR solenoid. If it does not perform the following: a. Check for 12 Volts on the ignition supply voltage to the solenoid. If it isn't present, inspect the supply circuit for an open, or a short due to chafing or breakage and re-test. b. If it still doesn't operate: then manually ground the EGR solenoid control circuit. The light should light. If it does, repair open in EGR solenoid control circuit and re-test. If it doesn't, replace EGR solenoid.


Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Aug 28, 2012 | 2001 Dodge Intrepid

1 Answer

Code number po 403


code P0403 EGR ( exhaust gas recirculation ) valve solenoid malfunction, could be many things most likely would be just a bad control solenoid but could be the wiring to the solenoid, but most likely is not a bad EGR valve.

Jun 18, 2011 | 2000 Mitsubishi Montero Sport

1 Answer

What does the code p0403 and p1784 mean and what do i need to do to fix it


P0403 - Exhaust Gas Recirculation Circuit Malfunction

Causes for DTC P0403:
- Harness or connectors (EGR volume control valve circuit is open or shorted.)
- EGR volume control solenoid valve
- EGR temperature sensor and circuit

Solutions for DTC P0403:
- Repair EGR harness or connector
- Replace EGR volume control solenoid valve
- Replace EGR volume control valve


P1784 - Transmission Mechanical Failure (First and Reverse)

Causes for DTC P1784:
- Not waiting to allow transmission to engage gear before accelerating.
- Dirty fluid / clogged transmission filter

Solutions for DTC P1784:
- Allow gears to engage before acceleration
- Preform transmission service (flush & filter)

Mar 09, 2011 | Chrysler Town and Country Cars & Trucks

2 Answers

2001 dodge stratus r/t code p0403


Here are possible causes for this code.

  • EGR solenoid connector is damaged (check pins for damage, and moisture)
  • EGR solenoid control circuit is open or shorted to ground
  • EGR solenoid control circuit is shorted to voltage
  • EGR solenoid has failed
  • PCM has failed
Please let me know if this information is helpful. Positive feedback is appreciated. Thank You!

Mar 26, 2009 | 2001 Dodge Stratus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

641 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...