Question about 1966 Ford Mustang

Open Question

Won't turn over unless jump ralay then turns over but starter doesn't disengage

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 17 Answers

SOURCE: wont start unless jump from starter

Check the safety switch on trans to see if the power is getting to it for the start circuit. If this switch gets old and worn it will drop the voltage so much that it wont start. If it does have voltage then check the wiring to the solenoid for voltage from the battery. The solenoid wire is easy to remove and test with test ligt and a second set of eyes to watch the light when you turn switch

Posted on Jun 01, 2009

Ad
  • 22 Answers

SOURCE: turn on ignition switch car will not start battery

it is either you solenoid switch or your starter gone
take it to Auto Zone or O'Reilly and let them put it on their machine. they can bring it out to your car and test it like that, and sometimes your battery may appear to be good with a jump but may have bad cells or don't have enough cranking amps for the type of vehicle you have

Posted on May 28, 2010

hotrodshop
  • 106 Answers

SOURCE: the car will turn over but won`t start but if I

Sounds like the ignition switch has gone kaput. The ignition switch come in two pieces, an electrical switch and a mechanical switch.

The switch electrical portion can be replaced separatly from the mechanical portion (tumbler that the key engages). It is not a real difficult repair but requires some mechanical knowlege of how the column is assembled.

This can be verified with electrical test equipment prior to buying a new electrical switch.

Posted on Apr 18, 2011

  • 116 Answers

SOURCE: 2007 chevy cobalt ls won't

Ignition relay or fuse could be the problem. When you turn the key to start do you hear a fuel pump kicking on and or do you have spark when you hot wire the starter (I know it's hard to check while trying to start it)? You can email me back and I might be able to pinpoint it more.

Posted on Jun 06, 2011

alicantecoli
  • 22246 Answers

SOURCE: My 2002 Toyota Camry won't

did you use professional quality jump leads and not them cheap made in china junk ones for the local chinese shop??

Posted on Jun 27, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

88 Mustang GT won't turn over unless I jump the starter relay.


Hi Kevin it sounds to me like your solenoid that is attached to your starter motor needs replacing had this with a ford cortina mk 5

Apr 10, 2013 | Ford Cars & Trucks

1 Answer

I have 2001 mercury courage replace alternator 2wks ago ran great. Now today will not start. Tried to start and it would click when I turned key now won't do anything doesn't have any power....


Could quite possibly be you have a bad starter. I would have it tested. Could also be a bad battery. If, when jumping it, you used too high of a voltage, could have shorted out a wire somewhere

Oct 27, 2012 | Cars & Trucks

1 Answer

I have a 2000 Ford Taurus. My wife left the radio running with the ignition off for a short while. Now the car won't turn over, won't start, won't jump. There is one click when trying to s


The click you are hearing is most likely the start slenoid making contact, however you should short the large wires @ the solenoid to make certain the starter still doesn't run, if so try tapping the starter with a hammer to shift the comutator a litle and try to start. Even if it now starts the starter will continue to give you problems so the proper fix is change the starter

Sep 22, 2012 | 2000 Ford Taurus

1 Answer

Car doesn't start


Have the Voltage in the Battery checked. The antitheft system will sometimes disengage the starter if the battery is below Specs.

If you disconnect the battery completely on the Honda and then jump the Honda with another battery, it will verify the battery in the Honda is the problem.

May 30, 2012 | Honda Accord Cars & Trucks

1 Answer

1993 Toyota Camry won't restart after driving unless waiting hours. The starter doesn't try and it's brand new. It always starts cold and if you don't drive it, you can turn it off and restart it over


i'me asumeing the batt is ok....turn on lights, do they dim when you try to start engine? if not .bad selonoid on new starter..was it rebuilt? it happens. Billy Starr

Dec 27, 2011 | Cars & Trucks

1 Answer

1966 mustang 289. won't start, jumped across solenoid, started. Replaced solenoid-starter wouldn't disengage, replaced starter, back to square 1, jumping across solenoid to start - whats my...


Ignition problem... No signal from ignition to solenoid...run a starter draw test to confirm starter is ok --- You can run your jump wires to a remote starter button or switch to get around it for now.

I hope this helps.

Sep 22, 2011 | Ford Mustang Cars & Trucks

1 Answer

My daugthers 2003 Olds Alero (3.4) isn't starting. Turning the key doesn't ingage the started. First time: I went in and tapped on started and couldn't get anything to happen then all of a...


This sounds like there is a dead spot in your starter. The easiest way to resolve this issue is to replace your starter. Many times, if you take a lot of short-distance trips over the life of your car, the wiring inside the starter itself will wear (short trips means starting it more often, causing a lot of wear over time). Then the inner wiring of the starter wears too much, it forms a "dead spot" -- when the starter is stopped at a very specific spot i will not form the magnetic force needed to torn the starter motor. This is a common issue which can be dealt with for a time if you have to save the money to replace the starter. Tapping the starter, or arcing it with a screwdriver makes the inner workings of the starter jump a little, allowing it to move out of the dead spot and kick over as normal, but it is only a temporary fix. Unless you refurbish electronics for a living, it is very unlikely that you will be able to repair the starter on your own, and such a repair takes some time, so you are better off to replace it than try to repair the starter itself.
As long as the starter does not happen to stop in the dead spot, it will work as normal ... but in time the dead spot will spread, causing the issue to worsen. You can keep forcing it to turn with the two tricks you used until you have had the opportunity to earn the money to replace the starter (or until you have a day off to get the repairs done) .. but over time this can cause more damage to other parts of the car, so I recommend replacing the starter as soon as you can.

Jun 07, 2011 | Oldsmobile Alero Cars & Trucks

1 Answer

My 2004 Pontiac Grand Am ignition switch all of a sudden with the key will not turn on or turn at all for that matter this has not happened before Why ?


It sounds like your telling us the key won't turn in the ignition anymore for some reason. If that is the case the problem is one or more of the tumblers in the ignition have fallen, if this is the case you will have to replace the ignition itself or at least the ignition core. If you mean the key turn but the vehicle doesn't start I would start by disabling the alarm system you installed to eliminate the starter kill switch as the source of the problem. Also, if this is the case try jumping the vehicle. If it turns over and starts with a jump your problem is the battery having a dead cell in it. It can have all the world but if you have a dead cell it doesn't have the amperage to turn the starter over.

Apr 19, 2011 | 2004 Pontiac Grand Am

1 Answer

Motor turns over but won,t start, i'm not getting


check the fuses and ralays, check to see if your getting 12v from the battery

Jul 19, 2009 | 1995 Chevrolet C1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

49 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...