Question about 2004 Toyota Corolla
Remove the glove box by taking the screw out of limit arm, squeeze sides of the glove box together and pull out to remove. You get a good view of the heater box assembly, while you are in there service the in cabin air filter, replace or blow out with compressed air. replace right side up. to remove the blower you must move a shelf on the bottom of the dash that hold an electronics box, you do this be removing the plastic clips then slip the entire shelf from the firewall and lay it aside. The blower is held on by 3 screws. take note where the plug is located so that you orient the new blower correctly. make sure to check for any leaves or debris that may have fallen down when you removed the in cabin air filter.
Posted on Aug 23, 2010
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: heater blower noisy
there should not be no more then three screws and unplug and the blower is out and you say its noisy check for leaves and to make sure the blower is not hitting anything before you go to buy another one.
Posted on Feb 14, 2009
first check the fuse if ok check the pulg on the motor for power and ground.if ok remove the motor and the rear cover off to check the brushes.either replace the brushes or put in a new motor.
Posted on Jul 24, 2009
Try the following & I am sure about the results;
Remove two screws on bottom of front face of glove box
Remove Glove box
Heater is just behind the glove box on the right side (the motor points downward and the fan is in a big round shroud).
Un plug the cable bundles that get in the way of removing the blower moter (the motor will come straight down).
There are three bolts holding the blower assembly in place, remove them and the blower assembly can be removed (pull downward).
Hook the black wire from the new motor up to the connector were the wire with the line on it (from the truck) was and the red wire from the motor to the solid colored wire from the truck (the wires from the motor had leads that you could slide into the connector from the truck).
Good Luck & Thanks,
Posted on Aug 20, 2009
Testimonial: "Very close... only had one screw on the right side of the glove box to remove then took the shock looking part off. Took 2screws from computer, done!"
Tips for a great answer:
Jul 04, 2016 | Toyota Cars & Trucks
May 09, 2014 | 2005 Toyota Corolla
Aug 15, 2010 | 2005 Toyota Corolla
Aug 20, 2009 | 2006 Toyota Corolla
Jul 24, 2009 | 2001 Toyota Corolla
Jul 16, 2009 | 2006 Toyota Corolla
Jul 12, 2009 | 1999 Toyota Corolla
2,757 people viewed this question
Usually answered in minutes!