Question about 1988 Honda Civic 2 Door

Open Question

Fuse box on a 1988 honda civic dx - 1988 Honda Civic 2 Door

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 82 Answers

SOURCE: 1991 civic fuse box diagram

1992 civic but this is probably the same as yours. http://autoforums.carjunky.com/autof...A_CIVIC_P3020/

Posted on Oct 10, 2008

Ad
blueextc3221
  • 15935 Answers

SOURCE: How to change upper control arm on 1996 Honda Civic DX ?

UPPER CONTROL ARM:

Do not disassemble the upper arm. If the ball joint or bushings are faulty, or the upper arm is damaged, the entire upper arm must be replaced.

  1. Raise and support the vehicle safely.
  2. Remove the front wheels. Support the lower control arm assembly with a floor jack.
  3. Separate the upper ball joint from the steering knuckle using a ball joint separator tool.
  4. Remove the self-locking nuts from the upper arm anchor bolts. Remove the upper arm from the vehicle.

Do not disassemble the upper arm. If the ball joint or bushings are faulty, or the upper arm is damaged, the entire upper arm must be replaced.
To install:
Use new self-locking nuts when installing the upper arm and strut.
  1. Install the upper control arm assembly into the strut tower.
  2. Connect the upper ball joint.
  3. Install the front wheels and lower the vehicle.
  4. With all four of the vehicle's wheels on the ground, torque the upper control arm nuts to 47 ft. lbs. (65 Nm). Torque the castle nut to 32 ft. lbs. (44 Nm); then, only tighten it enough to install a new cotter pin.
  5. Tighten the wheel nuts to 80 ft. lbs. (110 Nm).
  6. Check and adjust the vehicle's front end alignment.
The bushings on the front lower control arms are replaceable on most models.
This procedure requires the use of a press and may be above the skill range of the average driveway enthusiast. It is recommended that this procedure be done by a qualified machine shop if you are not skilled in the proper use of a press.
  1. Remove the lower control arm that is in need of new bushings.
It is recommended that both the left and right lower control arm bushings be replaced at the same time. The vehicles handling may become unstable if there are new bushings on one side of the car and worn ones on the other.
  1. Set up the control arm in a press.
  2. Using a impact socket of the correct length and size, press out the old bushing.
  3. Install the new bushing by slowly using the press to push it into the control arm.
  4. WARNINGExcessive force could cause the bushing to bend or tear so be careful.
  5. Once the bushing is properly seated in the control arm, remove the arm from the press and install it on the vehicle.

Posted on Apr 05, 2009

MNfisherman
  • 11896 Answers

SOURCE: how to remove transmission on 97 honda civic dx

remove crossmember, axles, cables, tranny mount bolts (3), tranny to engine of course bolts

Go to autozone.com and register for full free online repair manual

Posted on Sep 11, 2009

  • 7353 Answers

SOURCE: where is the fuel pump fuse located on 1994 Honda

Fuel pump is in the tank, there may be an access panel under the back seat area. One thing to check is the Main Relay. Ususally up under the dash, Left Dash area, I dont have a diagram, but you will need one to find and verify the relay operation.

Posted on Mar 16, 2010

  • 1757 Answers

SOURCE: i need the fuse diagram for a 94 honda civic dx

Here's a link to the fuse diagram you need...

http://media.honda.co.uk/car/owner/media/manuals/CivicManual/pdf/23-a36.pdf

Posted on Jun 27, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 honda civic dx ignition coil


- Check to see if there is sufficient fuel in the fuel tank.
- Check the fuse named IGN in fuse and relay box.
- Check the ignition switch.
- Replace the distributor assembly, if any.

Mar 24, 2014 | 1997 Honda Civic

1 Answer

Where is the fuel pump relay located on my 94 honda civic dx


d3b8073d-1bf3-4380-950a-09fe156d8ad9.jpgThe fuel pump relay is located under the dashboard of the car right next the fuse panel. Depicted in the included photo, is the exact replacement relay for a 1994 Honda Civic DX, and should look like, or similar to, the one located by the fuse box.

I hope that you have found this information to be useful, and if I can be of any further assistance, please let me know. Thank you for using fixya!

Oct 01, 2013 | 1994 Honda Civic

1 Answer

Honda civic 2000 problem code PO420


P0420: Calayst system efficiency below threshold (Bank no. 1)
You can clear the code by turning your engine off, locating fuse number 12 in your under hood fuse box (backup, radio 7.5A) and pulling that fuse for about 10 seconds. If the code comes back, it was not a glitch and I would have the code checked out (has to do with you catalytic converter, I believe).
Hope this helps you.

Nov 22, 2009 | 2000 Honda Civic

3 Answers

What Manufacture makes Alternator for 1988 Honda Civic DX


Your most popular alternator for that car is a Bosch or Lucus.Bosch is the better one

Aug 12, 2009 | 1988 Honda Civic 2 Door

1 Answer

2003 honda civic dx won't start or crank


well if it's a fuse location problem get to a auto parts store and purchase a auto repair manual or look in your vehlcles service manual it should be in the glove box

Jun 07, 2009 | 2003 Honda Civic

1 Answer

1991 Honda Civic DX Location of Fuel relay switch


in the fuse box up by the firewall on the drivers side .... fuse 13 fuel injector relay is the only fuel related fuse/relay that i could locate.fuse 9 in the passenger compartment fuse box as well.... what size motor is in your car ?

Apr 19, 2009 | 1991 Honda Civic

1 Answer

88 honda civic DX; idles rough and then dies.


you need to FILTER the air coming in the intake with something screen or something zip ty some screen and paper towel .then give it an oil change and clean the plugs(do this first).

Feb 24, 2009 | 1988 Honda Civic 2 Door

2 Answers

1990 honda civic


Hi there guys it should be number 12 {15A} on the fuse box

Jun 23, 2008 | 1990 Honda Civic

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

197 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...