Question about Hyundai Motor S

Open Question

Doors keep locking and unlocking - Motor S Hyundai Cars & Trucks

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 Chevy Impala. The door locks keep locking during drive.


It's probably a bad input to the BCM - body control module ! Have it checked for DTC'S - diagnostic trouble codes .
The automatic door lock function can only be enabled by the body control module (BCM) if the driver door open switch and door ajar switches are in the Closed state. For information on programming the automatic door locks, refer to Vehicle Personalization in Personalization.
DTC B3064 or B3069
DTC B3127
DTC B3128, B3133, or B3138
DTC B3132
DTC B3137
DTC B3272
Your best bet , take it to the chevy dealer . Unless you own a GM factory Tech 2 scan tool an have access to factory sevice repair info.
.
The outputs to the door lock actuators are controlled by the body control module (BCM). When the BCM receives a lock input from a door lock switch, or a keyless entry transmitter, it applies battery positive voltage to the door lock actuator lock control circuit, a ground to the door lock actuator unlock control, and the driver door lock actuator unlock control circuits. When the BCM receives an unlock input from a door lock switch, it applies battery positive voltage to the door lock actuator unlock control, the driver door lock actuator unlock control circuits, and a ground to the door lock actuator lock control circuit . When the BCM receives an single Unlock input from a keyless entry transmitter, it applies battery positive voltage to the driver door lock actuator unlock control circuit and a ground to the door lock actuator lock control circuit to unlock the driver door. A second Unlock input from the transmitter applies battery positive voltage to the door lock actuator unlock control circuit, and a ground to the door lock actuator lock control circuit to unlock the passenger doors.

This diagnostic procedure supports the following DTCs:
• DTC B3128 Left Front/Driver Door Unlock Circuit High
• DTC B3133 All Door Unlock Circuit High
• DTC B3138 All Door Lock Circuit High

Jul 21, 2017 | Cars & Trucks

1 Answer

My 98 accord will lock and unlock all doors but the right front door. However, I tried to lock and unlock from the right front door everything works. So what's the problem why can't I lock and unlock...


check all fuses. always, 1st.
in kiddy mode?
RTM
ever read the operators guide, and how to keep keep kids from falling out of car.
if not kiddy.
then the switch is bad, on drivers side. (seems this is it)

Sep 09, 2013 | 1998 Honda Accord

1 Answer

I have a Hyundai Elantra2001 GLS with manual transmission. I do not have keyless entry, but when you unlock the drivers door, all of the locks are supposed to unlock. It stopped working few months bcak,...


This particular vehicle is equipped with two relays. One is the "door lock" and the other is the "door Unlock."

Have a qualified Hyundai Service Technician properly diagnose your vehicle's problem.

Jun 30, 2011 | 2001 Hyundai Elantra

1 Answer

Power door locks keep unlocking, and then when unlocked they keep clicking to unlock repeatedly, the car will not stay locked and had to disconnect the battery to keep it locked and so not to need a jump...


it could be a shoted wire to ground going to the door lock actuators or a bad door lock actuator.

Disconnect all door lock actuators & see what happens, If ok, connect one at a time and see which one acts up.

actuators in doors behind trim panel

Jan 19, 2011 | Nissan Altima Cars & Trucks

1 Answer

When i unlock the car the locks just .....unlock-lock-unlock-lock...and keep going


Happend to mine - lockin solenoid on one of the doors is dud. OR loose.


You will have to remove door card and remove solenoid and replace. - remove the wire from each door in turn to see which one it is.

Jan 29, 2010 | 1996 Ford Escort 4 Door

1 Answer

Doorlocks keep locking even when out of the


Dave, it would appear that at one point one of the manual locks were forced either to unlock or lock and has now repositioned the nuetral point at a different location on the locking rod, hence, sending false readings to the control unit to either unlock or lock, I would try this, close all doors and manually lock them see which lock lever look unlike the rest in that position, this will be the culprit and have to be reset on the rod behind the door trim panel. This advice is as best as I can give without manually seeing the car. Drive safely

Jan 19, 2010 | 1999 Pontiac Montana

1 Answer

Central locking not operating all time. also keeps


re sync you fob. maybe a problem with door actuator also

Sep 29, 2009 | 1994 BMW 3 Series

1 Answer

2008 Chevy Blazer automatic door lock problem


you have a short in the locking system.

Aug 12, 2009 | 1996 Chevrolet Blazer

1 Answer

4 door 2001 chevy blazer front power locks will not work.


SOUND LIKE THE DRIVERS DOOR LOCK SWITCH IS STUCK IN THE UNLOCK POSITION. SINCE THE DRIVERS DOOR LOCK SWITCH OVER-RIDES THE PASSENGER DOOR, I WOULD REPLACE THE SWITCH WITH A NEW ONE. HOPE THIS SOLVES THE PROBLEM. GOOD LUCK. KEEP US POSTED, WE ARE ANXIOUS TO KNOW.

Apr 30, 2009 | 2001 Chevrolet Blazer

1 Answer

Drivers power lock will not unlock with remote.


the door lock actuator is defective, they get really hard to move when they go bad, that is why the difficulty with the key.

Mar 31, 2009 | 2000 Ford Explorer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

46 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...