Question about 2007 BMW 550i Sedan
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
You need to set all the pressures to 35 psi. first then drive for approx.1/4 mile. If this doesn't work to reset the light (keep in mind the code itself will still be stored even though the light goes off) you will need to take it to your Nissan Dealer to have it scanned as there may be a malfunction with the sensor. If faulty and you are under 36k miles then it should be covered under your factory warranty. Hope this helps.
Posted on Oct 17, 2008
Hi geonkm, if you look on the instrument clusteryou will see 2 buttons in the lower centre part of the dash, make sure the ignition is swiched off, press and hold the left button and turn the ignition on to the first position keep holding the button down until you see the display change, then lift you finger and press and hold again untill reset appears ( normally after aprox 5 seconds ) it will also flash, once this happens lift your finger again then press and release straight away, this should reset the service indicator. regards mark ps you may want to print this off prior to trying to reset to make it easier to follow, good luck
Posted on Jan 28, 2009
On some X5's you can do it through the instrument cluster whereas other through the button on the centre console depending on the spec.
On the centre console you'll find the tpc button. It looks like a flat tyre with an exclamation. With the ignition turned off, press and hold this button and turn on the ignition to position 2. You'll notice on the instrument cluster the light go red, yellow, off and then come back on yellow. When the light comes back on yellow release the button and wait with the ignition on until the yellow tpc button goes out. Thats it.
If this hasnt worked you have a different spec and therefore a different way of doing it! Let me know and il guide you through it.
Hope this helps!
Posted on May 27, 2009
You cannot "disable" the TPWS. Also, when you replace sensors, they need to be programmed to the TPWS computer.
Posted on Jun 09, 2009
Tips for a great answer:
Dec 11, 2016 | Ford Cars & Trucks
Oct 22, 2016 | 2007 BMW 550i
May 23, 2014 | 2007 Suzuki Reno Hatchback
Mar 30, 2012 | 2006 BMW 550I
Oct 10, 2011 | 2007 Lexus RX 350 FWD
Mar 07, 2011 | 2006 BMW 550I
Dec 08, 2010 | BMW Z4 Cars & Trucks
Oct 24, 2009 | 2007 Toyota Sienna
Apr 26, 2009 | 2001 Buick LeSabre
315 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: