SOURCE: Where is starter located on 2004 chrysler
Look around the "back" of the engine beside the transmission. The Starter connects to the flywheel to start the engine.
If you are replacing the starter you may want to consider doing this first;
) Have the charging system checked. Many auto parts stores and Sears will do this for free.
) Clean the battery terminal/connectors.
) Check the wiring from the battery to make sure it's good.
If you replace the starter yourself;
) Does your car have an anti-thief alarm ? If so find how to reset it if the battery is disconnected. Some alarms will shut down the car if the battery is disconnected !!
) DISCONNECT THE BATTERY.
) Disconnct the wiring to the starter.
) Remove the bolts holding the starter. Remove the harder one to reach first.
) Pull out the old starter.
) Put it the new starter.
) Bolt the new starter in. Put the easier bolt to reach first.
) Connect the wiring to the new starter.
) Re-connect the battery.
) If necessary reset the thief alarm.
) Take the old starter back for a core charge refund.
SOURCE: How do you replace the EGR valve on a 2004
check with you dealer, that part may have a manditory extended warranty by law
SOURCE: the performance service light came on our 2004
Most likely it means that the mechanic didn't bother to reset the service interval after changing the oil.
You can do this yourself by hitting the Step button until you see 0 miles until Service displayed, then hold the reset button until it changes to 3000 miles.
SOURCE: How do I adjust the headlights to see further down
The adjustment screws/nuts should be located either on the top of the headlamp assembly,
behind the headlamp assembly, or near the frame rail by the radiator
support.
You will have vertical adjustment screws for each independent beam
(separate highs and separate lows, but will be same screw if highs and
lows are the same bulb). You may also have additional horizontal
adjustment screws as well
Park
your car on a level ground 30 feet from a wall and measure the height
from the ground to the bulb and mark on a wall (do this for highs beams
and low beams if the bulbs are separate, if highs and lows are the same
bulb, only do it for the lows)
For Low Beams: If the headlights read VOR, then
aim the brightest part or cutoff part just below the mark on the wall.
If it says VOL or nothing, aim them 2 inches below the mark on the wall.
For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.
SOURCE: 2004 chrysler pacifica, front blower not working,
replace restor open glove box uplug 4 wire plug and two wire plug put 12 volts two wire plug to mke sure fan works if it does replace restor
218 views
Usually answered in minutes!
×