Question about 2008 Nissan Frontier

Open Question

My 2008 frontier has the abs/slip lights on aswell as the check engine light on. The engine wont rev past 2400 rpm? i can drive it around fine it just wont go past 2400 rpm. I'm just wondering what sensor might be gone?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 8 Answers

SOURCE: 1997 chevy K3500 won't rev past 2300 rpm, scanner values show 0?

rpm limit ... built in to unit so you
don't blow the engine.

Posted on Mar 15, 2009

Ad
Ajkill
  • 2035 Answers

SOURCE: won't rev past 2000 rpm

Check the computer on the car it may be programmed to run still on 2 K rpm you need to reprogram the computer on your car.......

Posted on May 27, 2008

SOURCE: transmission slipping

What you need is a "revolution sensor" I had the same exact problem. Replaced the sensor and everything is fine

Posted on Jun 28, 2008

pal03246
  • 726 Answers

SOURCE: TCS, SLIP and ABS lights on

Check your brake fluid first. If that is low, top it off and recheck. If its ok, than you will need one of the rear ABS sensors. You will need to plug it in and find out which side it is. That's really the only ABS issue that car has. One of the rear ABS sensors fails.

Posted on May 09, 2009

  • 1 Answer

SOURCE: High idle speed- Nissan N16 Pulsar/ Almera

Battery not charging well when airconditioner on ( also engine speed not increase when air conditioner on )

Posted on Jul 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Daewoo leganza wont rev past 2800 rpm idles fine just wont rev past 2800 ?


In park, this could be normal. ECU does this. around 2800 to 3500 RPMs. If driving, have the codes read. No codes , could be a clogged fuel filter, bad fuel pump(have the pressure checked), or clogged catalytic converter/s. With no codes, something is restricted..

Jun 10, 2016 | 2001 Daewoo Leganza

2 Answers

1997 dodge ram 1500 4x4 abs light on runs fine idles good but put it into gear wont go past 35 mph engine running smooth even at 35 mph


Bernard's Blog: Dodge Transmission Output Speed Sensor

bernardsblog.blogspot.com/.../dodge-transmission-output-speed-sensor.h...
Sep 8, 2009 - My 99 Dodge 2500 Ram won't accelerate..transmission is NOT slipping,.... It has been running fine and the check engine light even cleared itself yesterday.... So it wouldn't go into first gear and then 3 minutes later my check engine ... I have a1997 Dodge Ram 1500 with a 5.9L instead of the stock 5.2L. It ...

Dodge Ram Idle and Stalling Problems - Car Forums at Edmunds.com

forums.edmunds.com > Dodge > Dodge Ram Pickup 1500

Aug 17, 2011 - 30 posts - ‎25 authors
Learn more about Dodge Ram Pickup 1500 at the Edmunds.com ... The crank sensorwas put on however it started stalling again. ... The truck starts fine, but will only runat 2000's RPM and only then if .... Then as I start driving about 1/3 of a mile go dead again, I knockout of gear, crank back up immediately.

WILL NOT GO OVER 30MPH WITH PEDLE TO METAL ...

repairpal.com > Questions > Dodge > Charger > 2006 Dodge Charger
I WAS DRIVING FINE AND THE CAR ACTED LIKE IT GOT STUCK IN ... Then the transmission didn't want to change into 2nd gear. .... Whenever i start up my car theabs and esp light turn on and when i try driving it doesnt go over 30 mph even .... in neutral but not it just wont go up hills and i think it has something to do with

Jan 07, 2016 | Dodge Cars & Trucks

1 Answer

Engine revs up and down while driving


How is it at idle? A fast idle might be the result of a vacuum leak. Is there a check engine light with a code? Did you clean the mass air flow sensor?

Mar 01, 2015 | 2008 Pontiac G5

1 Answer

ABS light on & car wont accelerate in drive


Feedback ?

You need a repair shop to diagnose
ALL the codes & resolve ALL the cars
problems,not a guess without a vehicle to test

Mar 05, 2014 | 2003 Nissan Maxima

1 Answer

My rpm rev's past 3 car stalls then shifts...sometimes won't shift


Due for a transaxle rebuild,common on that veh

The fact you continued to drive it when it won't
shift correctly & has been slipping, your done

Aug 30, 2012 | 1998 Plymouth Grand Voyager

1 Answer

2001 nissan frontier won't rev over 2500 rpm


Is the check engine light on ?
Have you checked the fuel pressure ?
Could also be a restriction in the exhaust.

Jul 01, 2012 | Nissan Frontier Cars & Trucks

1 Answer

Car dies & wont go over 1000rpm


sound like your ABS system. you may have a lose wiring plug some where in the system when the ABS system get active it the system gets all kind of funny things make the car go slow the brakes it brakes it self there is no power in the engine. have your car for a truly electrical check up

Apr 24, 2010 | 1999 Daewoo Lanos

3 Answers

In neutral car is not going more then 4000 rpm


The 300M is equiped with a rev-limiter. The technology is designed to protect the engine. It keeps you from blowing it up when it has no load on it...If it is driving and shifting ok, and you have no check engine light on...there is nothing wrong.
Why would want to rev the engine past 4000 rpm in neutral anyway? Max torque comes in around 3950 RPM...
If you keep reving it up in neutral you might throw the computer in to LIMP mode, then you wont go no where.
Hope this answers your question...

May 23, 2009 | 2001 Chrysler 300M

1 Answer

1990 1.5l wont rev past 3500rpm's


Honestly I wish I could offer you more info, if it revs now that eliminates the convertor, only I can figure is when you got it to rev you were "blowing the soot out" LOL I hope I have helped you some if so please rate me accordingly.

Dec 16, 2008 | 1990 Honda Civic

Not finding what you are looking for?
2008 Nissan Frontier Logo

Related Topics:

155 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...