Question about 1988 Acura Legend

1 Answer

How often should i change my timing beit - 1988 Acura Legend

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 56 Answers

Most cars 60000 miles top 80000

Posted on Aug 22, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

When to replace timing belt for isuzu kb 350 lx

generally timing belts are due for replacement at 60,000 miles or 100,000 klms
the manufacturer states that adverse operating conditions affect that period
when changing the belt good practice dictates that the crank and cam shaft seals , hydraulic tensioner and idler pulleys are all replaced with the belt
oil seals especially as oil will halve the life of a beit

Jul 26, 2016 | Isuzu Cars & Trucks

1 Answer

My stearing starting jerking and all ove a sudden the truck over heating and now it wont start

check the beits.........if you got it to hot it may be done unless it doesnt turn over,,,,,,,if you drove it far enough battery could be dead

Jan 10, 2013 | 1998 Chevrolet Blazer

1 Answer

Timing beit cut,could not start after replacement

this is an interference engine meaning if engine turns out of time due to a broken timing belt the pistons can contact and this case the intake valves.if belt is on properly perform compression and leakdown tests to confirm damage to valves..sorry for bad news.

Dec 10, 2011 | 1993 Nissan Maxima

1 Answer

Idles high,jumps high and low,cleaned throttle body,and still idles high,will come down but takes a minute or two,what could it beits a 2004,mag. v 8 ,4.7 liter

disconnect the negative battery clamp, and leave it off for 5-10 minutes-resets the computer and forces it to relearn the sensors-if the problem continues, your idle air control or the throttle position sensor are prime suspects.

Sep 12, 2011 | 2004 Dodge Ram 1500

2 Answers

Beit routing for a 1994 pontiac bonneville with a 3800 v6 engine



Sep 11, 2011 | Pontiac Bonneville Cars & Trucks

1 Answer

On a saturn 2000 ls 2.2 liter engine do i have to take off timing beit covers can i just change the water pump

No, you should only have to remove the accessory drive belt. Remember to drain your cooling system, so you all your coolant doesnt spill out when you remove your water pump. Also, it is easier to remove the water pump from the passenger wheel opening, jack you car remove the tire and the inner fender splash shield and it should make the job a lot easier. Hope this helps, let me know if you have any other questions.

Feb 07, 2010 | 2000 Saturn SL

1 Answer

2003 towncountry over heating.replaced rad and thermstat but still over heating what the f cuold it beit has a 3.3 ....the rad had side blown out to begin with replaced it with upper,lower hoses and...

1. With what you have replaced, the only remaining credible explanation is the Water Pump. If the Water Pump is not operating correctly, this will cause overheating. The Radiator -"side blow out"? Did the radiator cap you have on not work. Overheating should cause fluid = steam to blow out the cap and not blow out the side of the radiator.
2. One thing you can do before replacing the Water Pump is to flush your entire system. There could be a blockage in the system. These flushing kits are available at most stores (Walmart or Autoparts Stores) and you can do it yourself.
3. Was the Engine Coolant Temperature Sensor (mounted near the thermostat) also changed out? If this was malfunctioning it could be giving you a false reading.
The Water Pump is the likely culprit if the Van is truely overheating.
Let me know if this helped, or if you have additional questions or information. Feel free to contact me at!

Jan 23, 2010 | 2003 Chrysler Town & Country

1 Answer

Chevy caprice

Ignition module. They get hot and shut down. After they cool they work again.

Aug 12, 2008 | 1996 Chevrolet Caprice

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts


Level 3 Expert

79186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides