Question about 2004 Buick Rendezvous
Check the wires behind the wheel hub asembly. wires can iether be frayed or broken. replace hub
Posted on Sep 06, 2010
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The sound could be isolated and may not be related to you not having 4wheel drive. You may have to inspect the speed sensors on the hubs of the wheels. You may have it inpsected and see if there could be a faulty sensor. Some 4x4 relies on sensors for 4x4 to work and these sensors also help ABS to work. Inspect the drive shafts as well. This may have caused the noise and may have affected your 4wheel drive capabilities.
Posted on Mar 20, 2010
Testimonial: "Good Advice."
Tips for a great answer:
Oct 25, 2016 | Cars & Trucks
The AWD data list can be used to assist in determining which type of fault is causing the AWD Disabled Lamp to illuminate. with a scan tool, verify the above data displays are within specification.
AWD temperature disables can be caused by an open circuit.
Using a scan tool, select the Body - Instrument Panel Cluster - Special Functions - Lamp Test mode. In the Lamp Test mode you can turn on or off the instrument panel indicators. All indicators will turn ON when commanded on and OFF when commanded off. The AWD DISABLE indicator should turn on or off as commanded.
If the AWD DISABLE indicator is always ON or always OFF, replace the instrument cluster. Refer to Instrument Cluster Replacement in Instrument Panel, Gages and Console.
The AWD disable lamp illuminates when one of the following conditions exists for 5 seconds:
The PCM commands the solenoid ON and the voltage feedback remains high, B+.
The PCM commands the solenoid OFF and the voltage feedback remains low, 0 volts. This condition is present for 3 key cycles.
The PCM detects fluid temp is too high.
You need to have this hooked-up to a professional grade scan tool.
Mar 02, 2015 | 2003 Pontiac Aztek
this warning light or any other stays on in the dash it is indicating
that the systems control module (or the system sensor in the case of
lights like low oil pressure, door open indicators etc.) has detected
a fault, it then disables the system (this applies to ABS,TCS, TCM,
SRS and BCM faults and others) as long as the light is on. You must
now have the dealer hook up a special electronic diagnostic tool and
"scan" the system for the fault code that is stored for the
Legend of Abbreviations. ABS Antilock brake system.TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module
Oct 11, 2012 | 2001 Pontiac Aztek
Jul 04, 2012 | 2005 Buick Rendezvous
Feb 04, 2011 | 2002 Pontiac Aztek
Jun 27, 2010 | 2002 Buick Rendezvous
May 25, 2010 | 2002 Buick Rendezvous
Jan 20, 2010 | 2002 Buick Rendezvous
Jul 28, 2009 | 2002 Buick Rendezvous
Mar 08, 2009 | 1996 Mitsubishi Eclipse
Mar 22, 2017 | 2004 Buick Rendezvous
1,512 people viewed this question
Usually answered in minutes!