Question about Chrysler Town & Country

1 Answer

I have 2002 town and country leaking fuel from an appendage on the top left of the intake. its one inch high and half inch diameter with a disc shape in the middle. maybe housing a this unit defective or is there some underlying problem?

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Chrysler Master
  • 14,036 Answers


Posted on Aug 22, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How do I replace the fuel filter on a Chrysler 1997 town and country 3.8 lxi

  • Relieve the fuel system pressure by removing the fuel pump relay from the power distribution center. Start the engine and allow it to run until it stalls. Try to start it again and let it run until it stalls. Repeat this procedure until it no longer will start. Turn the ignition off.
  • Disconnect the negative battery cable and raise the vehicle. Support the fuel tank with a transmission jack. Locate the fuel filter on the top of your Chrysler Town & Country fuel tank.
  • Remove the fuel line from the front of the tank and then the ground strap. Next, remove the inboard side of the fuel tank straps and front T-strap fastener. Lower the tank about 6 inches.
  • Detach the fuel lines from the fuel pump module and then remove the fuel filter. Put the new filter in its place. Tighten the fuel filter bolts to 40 inch pounds.
  • Reconnect the fuel lines to the fuel pump module and reposition the tank. Replace the front T strap fastener and tighten it to 250 inch pounds. Put the inboard fuel tank straps back and tighten them to 40 foot pounds.
  • Put on the ground strap and connect the fuel line in the front of the tank. Start the engine of your Town & Country and check for leaks.

  • Read more :

    Nov 09, 2015 | Chrysler Cars & Trucks

    1 Answer

    How to replace thermostat on 2006 town & country van?

    Follow top radiator hose to engine, all the way to the thermostat housing. (dome shaped about 3-4 inches in diameter) Remove housing, replace thermostat and gasket spring side pointing into engine. Re install housing. (and hose if you had to take it off) Some models may require you move other components out of your way first.

    Jul 20, 2014 | Cars & Trucks

    1 Answer

    How do I Check fuel injector gasket for town and country van

    spray carb cleaner around fuel rail where the injectors seat in to the intake whial engin running see if engin speed increases
    if a fuel leak is what your looking for visualy look at teh top of teh injecto where it go in oto the rail for wetness and fuel smell

    Feb 12, 2014 | 2005 Chrysler Town & Country

    1 Answer

    2002 Chrysler Town and Country rear a/c turns on and sounds like it's working, but barely blows air.

    Check the air intake for obstructions like plastic bags and clogged evaporator cores.

    Aug 09, 2012 | 2002 Chrysler Town & Country

    1 Answer

    02 Town&Country LXi. A/C leaks into interior at firewall.

    Sounds like the drain to the ground is stopped up.
    Has anyone tried to clean it out ?

    Aug 01, 2012 | 2002 Chrysler Town & Country

    1 Answer

    What is the height of a 2002 town and country with factory roof rack.

    According to this link, the height is 68.9 inches. There are 4 models listed and all 4 say it is 68.9 inches.

    Jul 29, 2011 | 2002 Chrysler Town & Country

    1 Answer

    2002 Chrysler Town & Country won't start

    you got leaking injectors or seals, remove them and have them tested, most time all that is needed is new seals, and not expensive

    Jun 29, 2010 | 2002 Chrysler Town & Country

    1 Answer

    Changing fuel filter on 2004 chrysler town and country

    1. Remove or disconnect the following:
      • Negative battery cable
    2. Raise the vehicle and support the fuel tank with a transmission jack.
      • Fuel line from the front of the tank
      • Ground strap
      • Inboard side of the fuel tank straps and front T strap fastener and lower the tank about 6 inches
      • Fuel lines from the fuel pump module
      • Fuel filter
    3. Installation is the reverse of removal. Tighten the fuel filter bolts to 40 inch lbs. (4.5 Nm), the main tank straps to 40 ft. lbs. (54 Nm) and the T strap to 250 inch lbs. (28 Nm).
    4. Start the engine and check for leaks.

    Aug 23, 2008 | 2004 Chrysler Town & Country

    Not finding what you are looking for?
    Cars & Trucks Logo

    Related Topics:

    23 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Chrysler Experts


    Level 3 Expert

    79865 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22326 Answers


    Level 3 Expert

    814 Answers

    Are you a Chrysler Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides