Question about Acura TL

Open Question

How to replace cv boot on 98 acura tl - TL Acura Cars & Trucks

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 8 Answers

SOURCE: 2005 Acura tl brake replacement

The Brembos that come on Type S/Manual models wear fast. I've changed them at 20,000 miles. They are expensive also.

Non-Type S/Manual models I have seen go 80,000 miles. The biggest factor on brake wear is how the vehicle is driven.

At 50,000 miles I would have them inspected. Depending on where you go, make sure you get an accurate measurement of both pads (inboard and outboard). 2mm is the service limit and about that time the indicators start making noise, but not always. Most indepent shops are going to sell you brake pads at 4mm. That's another 10,000 miles at least you could have driven on them.

Never replace just the brake pads, resurface or replace the rotors. The uneven surfaces of the rotor will cause your new pads to wear incorrectly and possibly cause brake noise. Most aftermarket pads will cause a squeel.

Posted on Sep 21, 2008

Ad
  • 4 Answers

SOURCE: trying to replace a front headlight bulb on 2001 acura 3.2 TL

Look for the end of the wire retainer clip. Unhook it and lift it up. Remember not to touch the bulb. But if you do, just clean it with a bit of alcohol.

btw - Here's a bit of info from a previous post of mine...
The low beams consist of three parts. The bulb, inverter/ballast and the ignitor. The bulbs usually start to loose their color long before they burn out. The inverters/ballasts either go out after a while or take a while to start up.

Before you spend money on a new bulb, try swapping it with the one on the other side. You'll need a security torx screwdriver to get the covers off of the back of the lights. Don't touch the glass bulbs. If you do, just clean them with a bit of alcohol.

If the problem stays on that side, try swapping the ignitors. They're mounted inside the black covers.

If the problem is still on that side you've got a bad inverter. They're mounted on the bottom of the headlight assembly. You'll need to remove the front bumper and remove the headlight assembly to get to it. (I recommend you take pictures as you remove things so can put them back together correctly.)

Posted on Jan 05, 2009

masterraphie
  • 41 Answers

SOURCE: starter replacement on acura 2000 TL 3.2

This starter can be changed without disassembling the top of the engine on the 2.5 with automatic transmission. You will need a 10mm, 14 mm, 17mm, and a 9mm wrench. First with any electrical repair disconnect the battery at the negative terminal. The starter is on the driver's side close to the firewall below the intake manifold. Remove the transmission dip stick so you don't ruin it, then look and study the starter itself. You will notice the starter drive housing with a top and bottom bolt. The top bolt is a 14mm and the bottom a 17mm, loosen both a half turn. Remove the top 14mm bolt first, then the bottom 17mm, this will allow you to pull the starter out of the bell housing. With some angling and no brackets holding the back of the starter you should be able to pull it out enough to disconnect the positive wire and 9mm nut from the soleniod. Disconnect the starter ignition small wire by pulling it off it's connector. Now just pull it out of the engine and fender void and you've got it, saving about a hundred and fifty dollars of labor. Take it to the parts house and match it up with a well made remanufactured or new starter. Reverse the proceedure, hook up the battery.

Posted on Mar 19, 2009

sheiden9
  • 87 Answers

SOURCE: HID BULB REPLACEMENT 2003 ACURA TL DRIVER SIDE

heres the procedure I uploaded it for you click [b][i]HERE[/i][/b]

Posted on Apr 11, 2009

  • 383 Answers

SOURCE: Where is the starter on a 1996 Acura 3.2 TL? On a

grantgga2: I don't think this is one you are going to want to try to change out.
It entails having to remove the left axle and part of the exhaust pipe to gain access to the starter. At that point, you have one bolt which goes in at the bottom from the starter side and bolts to the engine. The other bolt passes through the trans axle housing and bolts into the starter, pulling it up to the engine.
SCARED YA HUH? I'D SAY FROM A 1-10 FOR A WEEK END WARRIOR, IT WOULD BE ABOUT A 6.
Was I helpful?

Posted on May 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 98 acura tl and the dome light, cigerit lighter and radio just went off wich fuse do i need to replace.


It'll be in the kick panel on the left of your foot well. Most likely the one for radio although i don't have a diagram in front of me.

Aug 12, 2011 | 1998 Acura TL

2 Answers

Where is the Starter relay located on a 1997 Acura TL 2.5


The starter sits right above thepoint where the driver side half shaft CV axle enters the transmission. Youwill have to remove the half shaft to get it out.Your valuable feedback would be appreciated.Thanks for choosing Fixya

Jun 09, 2011 | 1997 Acura TL Series

1 Answer

I need a wiring diagram for a 98 acura downstream oxygen sensor


Canadian Tire Or Acura Dealership Sell Manual Book ..
But if your Lucky you can download it from Goggle Like Exemple
Download Acura TL 1998 Electrical Diagram ..Then you take the one you need ...

Oct 06, 2010 | 1998 Acura TL

1 Answer

How many o2 sensors does a 98 acura 3.2 tl have


it has 4 2 on each side 1 before cat and 1 after cat

Feb 18, 2010 | 1998 Acura TL

1 Answer

The vsa, !, and check engine light came on and are


check around the area of repair for loose ,damaged or disconnected wires or connections-especially the abs system if looks good than either bring back to mech and advise of trouble light on after repair or get scanned somewhere else most auto stores[ such as auto zone/advanced auto check ur local area] scan for free- the trouble code will give u a start point towards correcting ur problem

Feb 13, 2010 | 2004 Acura TL

1 Answer

I REPLACED THE EGR VALVE OM MY ACURA TL 98, THE CHECK ENGINE LIGHT IS BACK ON AND THE CODE READER SAYS IT INSUFFICIENT DETECTED


there is a egr passage in the intake manifold that is clogged and needs to be drilled out. if you want to bring to acura or honda dealer they can drill it out and put in a wider passage pipe. they have a kit for this problem

Oct 27, 2009 | 1999 Acura TL

1 Answer

How to unlock acura tl 3.2 98 with serial number


I went to my Acura dealer and they were able to give me my code with my VIN.

Jun 29, 2009 | 1999 Acura TL

3 Answers

1998 Acura 3.2 TL Starter problem


Hi there,
I dont know about your other problems with the solenoid or etc., but i recently replaced the starter on my cousin's Acura TL (98yr.).Now if this is your problem I can help,1st. disconnect your battery so you dont get fried!!! LOL,next you have to remove the cv boot or cv axel from the tranne no exceptions.Then you remove the lower bolt (which you get to under the car by the driverside tire)the last bolt is in the back by the fire wall (facing the oppesset side of the stater) they dont tell you that @ the dealers. Hope that the information I provided will help GOD BLESS!!!!!

Apr 14, 2009 | 1998 Acura TL

1 Answer

My engine and tbs lights are on in my 2001 Acura TL can you tell me what is the problem.


problem may be wheel tranny or front motor mount does it show any signs of front end wobble if so inner cv joint ball joints brake calipers all common culprits

Dec 26, 2008 | 1999 Acura TL

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

100 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8499 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...