Question about 1999 Ford Expedition

Open Question

1997 Dodge Ram 1500 2wd, replacing the evaporator for the a/c system.

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Vibration under my truck when I accelerate,02 Dodge Ram 1500,2wd,4.7


Most common issue would be worn Universal Joints on the drive shaft.

Aug 17, 2017 | Dodge Cars & Trucks

1 Answer

Squeezing coming from my leaf springs,02 Dodge Ram 1500,2wd.Any way to quiet them without taking them out?


Use a thin viscosity lubricant or penetrating oil on the leafs. Spray 2 or 3 times with a half hour or so between sprays for optimum results.

Aug 13, 2017 | Dodge Cars & Trucks

1 Answer

Where can I get a wiring diagram for a 1997 Dodge RAM 3500 diesel pickup?


1997 3500 Wiring Diagram - Dodge Diesel - Diesel Truck Resource Forums

www.dieseltruckresource.com/...dodge-ram.../1997-3500-wiring-diagra...
Jan 24, 2011 - Hey guys, I'm working on a 97 3500 that's had the bed removed and replaced with a flatbed. There is the biggest mess under that truck wiring wise and. ... 2007 Ram 3500 A/C compressor wont engage, need wiring diagram ...

Dodge Wiring Diagrams / Schematics - YouTube

? 1:13
https://www.youtube.com/watch?v=UI6_vhCHFYU
Nov 19, 2013 - Uploaded by Robert Nauert
Dodge Wiring Diagrams / Schematics ... Nitro, Power Wagon, Ram 1500, Ram 2500, Ram 3500, Ram 4500 ...

1997 Dodge Cummins - Full color wiring diagrams - 12 Valve ...

forum.mopar1973man.com/.../1638-1997-dodge-cummins-full-color-wi...

Jan 01, 2016 | Dodge Cars & Trucks

1 Answer

What does the PO441 code on a 1997 Dodge Ram 1500 mean?


  • Hi, i can help.
  • That code means "Evaporative Emission Control System Incorrect Purge Flow."
  • This most of the time is nothing more than a gas cap that is not on tight of the seal is worn out. Make sure it is on tight. If it looks tight then the seal is bad and the cap should be replaced.

  • If you have any comments please feel free to leave them here.
  • Hope this helps and thank you for using FixYa.

Regards, Tony

Aug 27, 2011 | Dodge Magnum Cars & Trucks

1 Answer

Need to replace upper door hinge on 1997 dodge ram p u the door is sagging


Contact LMC Truck Part's and order a dodge ram catalog, They have a repair kit for the 1997 Dodge ram hing .

Oct 29, 2010 | 1997 Dodge Ram 1500 Club Cab

1 Answer

Where is the heater core located on a 1997 dodge ram 1500 5.2 318


This is to give you an idea where it's at (behind the dash) and what you would have to do to remove and replace it:

Removal & Installation

  1. Disconnect the battery negative cable.
  2. Remove the instrument panel from the vehicle.
  3. If equipped with air conditioning, recover the refrigerant.
  4. Disconnect the liquid line refrigerant line fitting from the evaporator inlet tube.
  5. Ram: remove the accumulator.
  6. Dakota, Durango: disconnect the accumulator inlet tube.
  7. Drain the cooling system.
  8. Disconnect the heater hoses from the heater core tubes.
  9. Ram: remove the powertrain control module from the dash panel. Disconnecting wiring is not necessary.
  10. Remove the four nuts from the heater–A/C mounting studs on the engine compartment side of the dash panel.
  11. Remove the nut(s) that secure(s) the heater–A/C housing mounting brace to the stud(s) on the passenger compartment side of the dash board.
  12. Pull the housing rearward far enough for the mounting studs and evaporator condensate drain tube to clear the dash panel holes.
  13. Remove the housing from the vehicle.
  14. Lift the heater core out of the housing.
  15. Installation is the reverse of removal.


d07d046.gif

May 08, 2010 | 1997 Dodge Ram 1500 Club Cab

1 Answer

1999 Dodge Ram AC blows cold at idle and up to 40 mph


Most likely the orifice tube/expansion valve needs to be replaced. Depending on the type of system, you will have one or the other but they both perform the same function. The expansion valve is typically located at the evaporator inlet. Orifice tubes can be located at the evaporator inlet, in-line between the condenser and the evaporator, or in the condenser outlet. You will have to discharge the system in order to replace. Not very hard to do.

Jun 08, 2009 | 1999 Dodge Ram

1 Answer

Ac compressor oil


First off is your compressor pre-lubed? to find out, remove shipping caps from ports and tip to side and see if any oil comes out. As a rule of thumb, The oil is sold in a small bottle pre measured for the entire system. 1/4 bottle per item (compressor, evaporator,condenser, and filter/dryer) The label showing cc's will do fine for your oil needs as the system will find its own level once activated. Oil continuously flows througout system. Need I remind you that when replacing compressor you should also replace filter/dryer so you do not repeat this job in two months.

Aug 03, 2008 | 1997 Dodge Ram 1500 Club Cab

Not finding what you are looking for?
1999 Ford Expedition Logo

Related Topics:

64 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...