Question about Dodge Ram 1500

1 Answer

Car stero loses memorywhen ignition switch is turned off

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 120 Answers

When there is a loss o power memory will be lost. Upon radio installation there is a 2nd power for this reason. Check wiring diagram.

Posted on Aug 22, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

After i instal a dual car stero i decide to ad a


probably picked up the wrong power wire for the unit and the power is diverted to the ignition circuit.. have the installation checked by professional audio fitters.

Aug 27, 2014 | Cars & Trucks

1 Answer

I need to know which wire is the hot wire, going from the car to the car stero


red wires in auto electrics is the nominal power wire. Use a circuit light tester and if it comes on when the ignition switch is on, or in the accessories position then that is the hot (power )wire.

Dec 23, 2013 | 2001 Buick Regal

1 Answer

Ignition troubles


unplug connector at ignition switch, bridge terminal 30 [battery power] on connector and terminal 50 power to starter solenoid. engine should turn over. plastic ignition switch can wear and not make contact. at times the lug on ignition barrel that turns the switch breaks off.

May 23, 2010 | 1996 Volkswagen Jetta

2 Answers

Had dead battery in 2002 honda civic got jump now word CODE in radio display


try disconecting the positive terminal of the batery for sevral minets (5-10) this will reset the brain box memory for the stero aswell as for the car it self.

what caused the batery to go dead in the first place?
things that i can think of :
1) left headlights on over night
2) bad altenator not charging batery
3) battery is old and not taking a charge anymore
4) new stero installed incorectly and drainging the batery
have you resently installed a new stero or amplifyer?
is the turn key igntion system hooked into the amp/stero antena lead so that thy are shut of when the ignition is?
of note: new streo >theres a blue wire marked ant that goes to the amplifyer if not there you need to find the orange accsesory wire coming from the turn key igntion>check for power when ignition is in the on & off states could be yellow in some cars but is usaly orange if this wire has on and of state controled by the turn key igntion this would be the wire to tap into for the amplyfire and the radio main power
check your radio's instaltion guide for code errors
its posible that when hooking up the jump it was done incorectly and blew up the radio
ie postive and negative where fliped
hope this helped :)

Feb 24, 2010 | 2002 Honda Civic

2 Answers

95 camaro 3.8 liter has head lights, stero, turn singal but when you try to start it , turn the key and you get nothing no even a click?


Check the voltage to the small terminal on the starter when tying to start the car.If there is 12 volts,then replace the starter,if there is not,any voltage,check the neutral safety switch,if it is not the problem,replace the ignition switch.Before all this,make sure the battery is good,and that the battery connections,cable ends included,are clean,and shiny,if they are dirty and corroded,there will not be enough voltage for the starter,it takes more voltage.

Jan 30, 2010 | 1995 Chevrolet Camaro

1 Answer

Ignition when turned on the wipers and stero doesn't work


Perfect...that's exactly what they should do when the ignition is in the "aux" position

Apr 07, 2009 | 1998 Pontiac Grand Prix

1 Answer

Audi A6 stero


pull the keys out of the ignition then put them back in. should turn off now!

Mar 15, 2009 | 2003 Audi A6

1 Answer

Bmw e30 325i convertiable d reg 1987


If you can not find the problem is, maybe you can wire directly from your fuse box 12v to your radio hot wire, and use your radio switch turn on and off, omit the ignation switch.

May 26, 2008 | 2001 BMW 325

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

62 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22258 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...