Question about 1995 Toyota Avalon

1 Answer

All turn signals not working, turn signal indicator light not working

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Toyota Master
  • 8,836 Answers

Do they come on but not blink?--check flasher unit

Posted on Aug 22, 2010

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad
red54eyejp
  • 25 Answers

SOURCE: front driver side turn signal light doesn't flash

replace flasher......usually located in fuse block area...listen in this area....select passenger side ...then select driver side...you can hear flasher clicking...you have seperate flashers for each...FLASHERS are small cubes plugged into fuse block....probable bad driverside flasher

Posted on May 09, 2009

  • 3 Answers

SOURCE: 1997 dodge avenger turn signal probs and location

replace the turn signal switch it self, mine did the same thing with the left turn signal, put in fuse and it will continue to flash... went to junk yard pulled one out of a 97 avenger just like mine, swapped them out and now it works fine. looked to be like some corrosion... to repace: 3 screws under columb, 2 screws on side of signal switch (black plastic side). unplug and replace

Posted on Jun 26, 2009

  • 3 Answers

SOURCE: brake lights and turn signals

Buck Mint
I think your solution is right on.  After further investigating my problem, I found that after pressing the hazard flasher switch several times, sometimes my turn signals would work sometimes they would not.  I fixed my problem by replacing the multifunction (HF, TS, wiper) switch, but I think your solution might have worked and saved me dollars.  

Posted on Nov 04, 2008

  • 1986 Answers

SOURCE: rear left and right turn signal lights not working.

the electronic flasher module may be faulty, or you could have blown a fuse

Posted on Aug 13, 2009

jeffbvegas1
  • 520 Answers

SOURCE: LEFT BRAKE LIGHT AND TURN SIGNAL LIGHT INDICATOR

Replace both sides with correct dual element bulbs which may be the culprit here

Posted on Sep 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My rear turn signals are not working. front turn signals work rear parking lights work brake lights work


In the diagram for rear lamp, the top wires are voltage, the bottom black wire is ground. The brown wire on either side should be tail lamps, goes hot when you turn on the headlamp switch. The other top wire on either should be for turn signal. With everything turned on, is there voltage on that wire?
Because the front works and the rear don't, possible wiring circuit problem? The voltage for turn signals comes from bcm. The bcm knows when you turn on turn signal switch, either side, then the bcm sends voltage to turn signal lamp at the rear and front.

rear-turn-signals-not-working-front-nrw1b5lbo1usuvcsnuvurzx3-3-0.jpg

Oct 17, 2016 | 2009 Chevrolet Chevrolet HHR LS

1 Answer

How do i fix my problem, left indicator starts flashing when turn engine on but stalk will not stop left side or start the right side yet hazards work fine


One of the most important safety systems in the car is the Turn signal system. It can help prevent accidents by signalling to other drivers on the road when you need to change course and which way you'll be turning. It is also required by law to have a car dashboard turn signal indicator that works properly. You will need to wire the indicator in your dashboard to the proper lights and locations in the car. For a standard turn signal indicator in which the turn signal lights are the brake lights, please check this link on how you can do this:
How to Wire the Turn Signal Indicator in the Dash

Oct 18, 2014 | Cars & Trucks

2 Answers

Tail lights not working


ck fuse for rear taillights tis under the dash lower left of steering wheel. or if you still have the manual look in there under fuses.
also look for a bad ground but i doubt that.. if it's both rear out.
fast flashing well here's a chart with all sorts of info.
Problem What To Do Turn signals light, but do not flash Replace the flasher No turn signals light on either side Check the fuse. Replace if defective.
Check the flasher by substitution.
Check for open circuit, short circuit or poor ground. Both turn signals on one side don't work Check for bad bulbs.
Check for bad ground In both housings. One turn signal light on one side doesn't work Check and/or replace bulb.
Check for corrosion in socket. Clean contacts.
Check for poor ground at socket. Turn signal flashes too fast or too slow Check any bulb on the side flashing too fast. A heavy-duty bulb is probably installed In place of a regular bulb
Check the bulb flashing too slow. A standard bulb was probably installed in place of a heavy-duty bulb
Check for loose connections or corrosion at the bulb socket Indicator lights don't work in either direction Check If the turn signals are working
Check the dash indicator lights
Check the flasher by substitution One Indicator light doesn't light On systems with 1 dash indicator:
- See if the lights work on the same side. Often the filaments have been reversed In systems combining stoplights with taillights and turn signals
- Check the flasher by substitution On systems with 2 Indicators:
- Check the bulbs on the same side
- Check the indicator light bulb
- Check the flasher by substitution
hope this helps. may want to print for future reference. :)
hope this helps.

Dec 31, 2017 | GMC Suburban Cars & Trucks

1 Answer

Turn signal indicator doesnt work accord 1998


i think its the indicator relay under the bonnet in with the fuse box

Feb 11, 2012 | 1998 Honda Accord

2 Answers

1992 Cadillac Brougham 5.0 L V8 RWD, turn signal don't work.


The turn signal switch is most likely the problem,but change the flasher for the turn signals first,some times this is all that it is.

Jun 11, 2010 | 1992 Cadillac Brougham

1 Answer

LEFT BRAKE LIGHT AND TURN SIGNAL LIGHT INDICATOR


Replace both sides with correct dual element bulbs which may be the culprit here

Sep 27, 2009 | 2005 Audi A6

1 Answer

Left turn signals not working and left turn signal indicator light does not come on. Right signals working and right indicator light flashes when turn signals activated.


one of the left turn signal bulbs is burned out. turn them on and look to see which one is out when you see one not on replace it and you are up and running again.

Sep 23, 2009 | 1998 Toyota Tacoma

1 Answer

Turn signal isn't working.


More than likely you need to replace your turn signal relay located on the fuse panel.

Feb 10, 2009 | 1999 Buick Park Avenue

1 Answer

Turn signal


Now replace the flasher unit! Frankster016

Oct 25, 2008 | 2002 Nissan Xterra

Not finding what you are looking for?
1995 Toyota Avalon Logo

Related Topics:

408 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

78919 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...