Question about Pontiac Sunfire

1 Answer

How do i bleed my 97 Pontiac sunfires clutch??

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Pontiac Master
  • 1,075 Answers

Its not a hard job if you know what you are doing?first get enough fluid,then get another person yes its takes two,find the bleed screw on the slave cyclinder its the one on the gearbox,when you are ready get the person sitting in the car to pump the clutch pedal about 10 times and tell them to hold the pedal in and[ dont] let it out until you say,open the screw and air should come out along with a little fluid,continue about 4 times and the pedal will put all the air out ,if this was good rate me.adrian,,,,,,,,,,,

Posted on Aug 22, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do u bleed a hydryalic clutch on a 97 firebird formula


Hi Rick,again,here's a link to bleeding your clutch,if your fluid is low,then your slave cylinder may be bad. Repair Guides Clutch Actuator slave Cylinder AutoZone com

Sep 08, 2014 | 1997 Pontiac Firebird

1 Answer

On my 96 sunfire the clutch pedal went to the floor!! I still have half an inch of pressure from the floor and clutch will not engage reverse!! Any suggestions!??


does your car have a hydraulic clutch
just had similar problem on my Jeep had to replace the clutch master cylinder and slave cylinder.
you can bleed some clutch master cylinders removing air in system check fluid level full then bleed master cylinder keeping an eye on fluid levels not to run system dry..

good luck hope this helps (PTL)

Nov 12, 2011 | 1996 Pontiac Sunfire

1 Answer

Where is the clutch bleeder valve for my 1999 pontiac sunfire.


Follow your clutch master hydraulic lines down to the transmission area. See this picture for the bleed valve location.
mcneb_69.jpg

Sep 25, 2011 | 1999 Pontiac Sunfire

1 Answer

Where is the torque converter clutch solenoid located on 97 sunfire


INSIDE THE TRANSMISSION...HAVE TO REMOVE THE SIDE PAN OF THE TRANS.

Aug 08, 2009 | 1997 Pontiac Sunfire

1 Answer

I have no clutch basically.


your problem is in the slave clydliner.. this will cause the clutch to leak dot3.. look under the car at the tranny, there is long rod sticking out of tranny, thats where the slave pushes to release the clutch.. follow the lines up to the clutch master cycdiner, making sure there are not leak in the line.. if it is the slave, once you replace it you will need to bleed the slave.. same as you would your brake..have some one pump the clutch pedal down three or four times hold and let you release the bleeder valve on the slave.. repeat this till the clutch feels back to normal.. sounds alot harder than it is.. good luck keith.. if any more questions contact me at keith.glass765@yahoo.com

Mar 20, 2009 | 1997 Pontiac Sunfire

1 Answer

1999 pontiac sunfire bleeding clutch


my 1999 pontiac sunfire drivers door latch is broke can not close the door. i have it pulled shut? how much will a used latch cost, or even 3 bolts for it? all the auto stores/ jumk yards are closed for me to call

Jan 26, 2009 | 2003 Pontiac Sunfire

1 Answer

Clutch problem with my 1997 sunfire Gt


if there is no leak, change the clutch master cylinder .

Oct 27, 2008 | 2007 Pontiac Sunfire

1 Answer

96 pontiac sunfire


YOU HAVE A LEAKING MASTER OR SLAVE CLUTCH HYDRAULIC CYLINDER (AIR LEAKING INTO THE SYSTEM), SINCE THESE ARE ALWAYS REPLACED TOGETHER IT MAKES NO DIFFERENCE WHICH IS THE PROBLEM CYLINDER.

Oct 06, 2008 | 1996 Pontiac Sunfire

1 Answer

Clutch problems


Best clutch to uae in the sunfire is the AC Delco replacement cluch kit. It can be bought at most parts stores, and it will come with the throwout bearing, preasure plate and new disk. If your not equipped with a car lift and engine supports craddle, it can be difficult.

May 28, 2008 | 1997 Pontiac Sunfire

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

130 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...