How do you remove the key ignition switch from a 1969 vw beetle?

Hello -

It is not clear from your question regarding if you want an owner's manual for a 1969 VW Beetle or if you want a service manual or both.

This is the link to a free downloadable PDF version of an owner's manual for a 1969 VW Beetle:
https://www.manualslib.com/manual/187844/Volkswagen-1969-Model.html#manual

You will need Adobe Acrobat Reader software (free.)

If you are seeking a service manual, it seems you may have to purchase a copy of the service manual through an auto parts store. I have no idea of the country where you reside, so I hesitate to provide you with some links for purchasing the service manual.

If you reside in the USA or Canada, your local public library system probably subscribes to a database of automobile service manuals which you can access online through the library website . . . at no charge. If you do reside in the USA or Canada and are unfamiliar with the auto service manuals database/s, I suggest you visit your local public library and ask one of the reference/information librarians to educate you about the auto repair manuals database and how to access them electronically from home. You will need a valid library borrower card for remote access.

Best wishes.

The ignition switch is in the column. To take it out, put your car key in the ignition and turn it. You will see a little hole where you can insert something like a jewler's pick and the ignition switch will come right out.

Call your vw dealer,they will tell you how to get a key.

Replace the retarded ignition switch,the electrical part of the switch only if possible.

turn the steering wheel counter clockwise (to your left) forcefully. while holding the steering wheel, insert the key in the ignition switch and try to turn it on, if the key wont move, try to **** the steering wheel repeatedly while try to turn on the engine every ****.

replace your ignition switch it is located behind the ignition lock in the steering wheel

Removing:

• Switch off all electrical consumers, switch off ignition key and remove ignition key.
• Remove rear luggage compartment side panel trim (left or right).

• Remove 3 nuts, arrows, and remove housing.
• Remove bulb holder.

Installing:

• Install bulb holder.
• Insert housing into body opening.
• Tighten nuts.
• Install applicable rear luggage compartment side panel trim.

Rear Light Bulb Holder Removing And Installing:
Removing:

• Disconnect electrical connector.
• Depress retainers, arrows, and remove bulb holder.

Installing:

• Install in reverse order of removal.

And the Center Mounted Brake Lamp.
High mount Brake Light Removing And Installing:
The high mount brake light is installed in the rear shelf.
Removing:

• Switch off all electrical consumers, switch off ignition key and remove ignition key.
• Disconnect electrical connector from high mount brake light.
• Remove rear shelf
• Un-clip high-mount brake light from rear shelf, arrows.
• Install in reverse order of removal.

NOTE: The bulb holder base plate contains soldered- in light emitting diodes (LEDs) that are not replaceable. In the event of LED malfunction, replace complete bulb holder.
Additional

You don't have the proper key. The flip key assembly has a chip in it that lets the car keep running. Use old key assembly. To test put the old ket fob next to the ignition switch and see if it keeps running,

The plastic ignition switch is held in with a philips screw. You will need to remove the ignition lock cylinder to get to it. A easy way to check is to unplug the wires going into the back of the lock housing and plug in the new switch, without removing anything.

with the bolts removed try gently prying it apart at the centre often they still lock in aswell as use screws so although you have removed the screws its still clipped together it should separate with some gentle assistance