Bi-Xenons - 6000K D1S
High Beams - Osram Nightbreakers H7
Fogs - PIAA H11 Yellow Ion
Cornering Lights - Osram Nightbreakers H3
Front Park Lights - High-Powered LEDs with built-in resistors
Front Signal Lights - Sylvania Silverstar 7507A ST (Silver Bluish but lights up Amber)
Front Sidemarkers - InviSilver W5W (Silver but lights up Amber)
Rear Signal Lights - P21W Stealth Bulbs (Silver but lights up Amber)
Reverse Lights - Sylvania Silverstar 7506ST or Error-Free LEDs
License Plate Lights - C5W Error-Free High-Powered LEDs
Turn the engine off and approach the side of the porsch with the burn-out side-marker light. If you are replacing both, start at either side; the replacement procedure is the same.
Remove the screws from the plastic fender liner. Peel back the liner to access the area behind the fender.
Reach your hand inside to gain access to the side-marker
light's backing. Push the backing forward to release the side-marker
lens; it's held in place by small clips.
Grab the lens on the outer side and turn it over to access the back. Gently turn the bulb to release it from the plastic lens.
Pull the bulb straight out to remove it from the electrical
socket. Insert a new bulb, but do not touch the glass part of the bulb
with your hand.
Push the new bulb into the side-marker lens. Turn it
clockwise to install it. Push the side-marker lens back into place.
Apply gentle pressure to the lens to pop it back into its mount.
Replace the screws along the edge of the fender liner.