Question about 2004 Cadillac SRX

1 Answer

I just replace my ecm on cadillac srs 2004 and when i tend on the ingination is say (key disable remove)

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,190 Answers

THE ECM WILL HAVE TO BE PROGRAQMMED AND SO WILL THE PASS KEY 3 SYSTEM

Posted on Aug 23, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to removed and install The ECM


Your better off taking it to the dealer , after replacing it needs to be programmed or it will not run . Information from the old has to be up loaded to GM Tech 2 scan tool to load on new one ! Then you would need to pay for a subscription to GM'S service programming system to get software to program new ECM .
Program the ECM. Refer to Service Programming System (SPS) in Programming. If you encounter an ECM programming error, with a display message of "Starting Disabled, Remove Key" on the driver information center, with a diagnostic test code (DTC) of P1631, perform the "10-Minute Relearn Procedure" found in Programming Theft Deterrent System Components. Refer to Programming Theft Deterrent System Components . Additional information can be found in service bulletin number 05524 A. Turn OFF the ignition for at least 5 seconds after the programming event is complete. Perform the idle learn procedure. Refer to Idle Learn . Use the scan tool to clear all DTCs.
Of if you a few grand you could buy a J2534 programming tool an
J2534 Reprogramming Tool

May 06, 2015 | 2004 Cadillac CTS

2 Answers

2004 cadillac cts wont crank at all, i turn the key and try to start it but it doesn't crank or do anything just the dashboard light come on and the engine light flickers then it wont release the key


I had something similar happen on my 2004 CTS. The car would not crank, and I recall the security light was on the dash. The key could be turned off, but not quite far enough to be removed.
The key can be removed by sticking a small pin or screw driver in a hole under the steering column... maybe 2 inches from the actual steering wheel. I recall there is a small cover or plug in the hole that needs to be removed.
You can let it sit and occasionally try to start it. My did start once more.
I ended up having it towed to the GM dealer and they replaced the ECM for about $500? That took care of it for a couple years, until I recently sold it.

Mar 14, 2015 | 2004 Cadillac CTS

1 Answer

Will a 2003 ecm work to replace in a 2004 Cadillac CTS?


No... All ecm (s) are make model, year, and vin specific. They must be flashed with the correct information which includes engine, accessories , sensor, etc for the specific car... The car will not start.

Feb 24, 2015 | 2004 Cadillac CTS

2 Answers

What is the main fuses on a 2005 Cadillac CTS? This is the picture of our problem


That symbol means that the car has been locked down by something. More than likely it's the security system.

Feb 21, 2015 | 2005 Cadillac CTS

2 Answers

My key is stuck in the ignition of my 2006 cadillac cts


2005 CTS 3.6 Dead battery, key stuck, service anti theft and nothing happens when you turn key, Ttried everything, ECM reset, key memory reset, charged battery to 12.7 volts, locked door w remote and opened w key, anyway you get the idea. After 3 days of online reading and trying, THIS IS WHAT WORKED, 1. put key into on position 2. removed sarter relay from front fuse panel 3. jumped 1st pin closest to fender and passenger seat with pin that is closest to motor and front fender. I used a paper clip and just made contact long enough for car to start. ran car for five minutes and took key out and everything went back to normal. then I took car to advance auto parts to have engine light reset. if car does not go back to normal you have ECM (car computer) failure. video on YouTube under "no crank, no start"

Jul 09, 2011 | 2004 Cadillac CTS

2 Answers

How do u disable a 94 cadillac deville anti theft system


U can bypass it (called the VATS system) but not fully disable it, what is done mimics the key code to fool the VATS module into sending a OK to start signal to the fuel injection computer (called the ECM). go to the web link below for instructions on the bypass.

http://vats.likeabigdog.com/

Oct 29, 2010 | 1994 Cadillac DeVille

1 Answer

My dad owns a 2003 CTS. While driving the car he gets the displayed message "starting disabled remove key" and the car shuts off. He puts the car in NEUTRAL and WITHOUT removing the key, starts the car...


STARTING DISABLED REMOVE KEY
Refer to Theft Systems Description and Operation in Theft Deterrent

STARTING DISABLED REMOVE KEY
The radio illuminates the STARTING DISABLED REMOVE KEY message when the VTD system has disabled the starting system. The radio receives a message from the theft deterrent control module via the serial data circuit requesting illumination.

Your best bet ,take it to Cadillac dealer and have it checked . Could have DTC'S - diagnostic trouble codes
DTC B1015
DTC B1016
DTC B3031
DTC B3055
DTC B3060
DTC B3090
DTC B3935
DTC B3976
DTC P1629
DTC P1630
DTC P1631

The theft deterrent module or the insturment cluster or the ECM is not seeing correct info.
The vehicle theft deterrent (VTD) system functions are provided by the theft deterrent control module. When an ignition key is inserted into the ignition lock cylinder and the ignition is switched ON, the transponder embedded in the head of the key is energized by the exciter coils surrounding the ignition lock cylinder. The energized transponder transmits a signal that contains its unique value, which is received by the theft deterrent control module. The theft deterrent control module then compares this value to a value stored in memory, learned key code. If the value is correct the theft deterrent control module sends a random generated number to the transponder, this is called a challenge. Both the transponder and the theft deterrent control module perform a calculation on the challenge, if the calculations match the theft deterrent control module sends the fuel continue password via the serial data circuit to the Engine control module (ECM). If either the transponders unique value or the calculation to the challenge is incorrect the theft deterrent control module will send the fuel disable password to the ECM via the serial data circuit. The components of the VTD system are as follows:
• Theft deterrent control module
• Engine control module (ECM)
• Ignition key (Transponder)
• Ignition lock cylinder
• Security indicator

Aug 08, 2017 | 2004 Cadillac CTS

2 Answers

Starting disable remove key own a 04 cts,i wont encourage anyone to get these cars since i got it its nthing but problems, i tried everyting nthing can start the key i tried the 30 min realarm the security...


try this
PASSKEY LOCKOUT RESET GM CARS 1999 UP
1) Put the key in the ignition and turn to the "ON" position. Leave it that way for 10 minutes. After 10 minutes turn the key and take it out. Repeat this process (2) more times (3 times, 30 minutes total) This should reset the passlock system to recognize your key.

Aug 07, 2009 | 2004 Cadillac CTS

1 Answer

Starting disabled remove key


VEHICLE ANTI THEFT SYSTEM HAVING PROBLEMS

Apr 14, 2009 | 2004 Cadillac SRX

1 Answer

2004 honda accord .ingination will not accept key


do you have the org key is there something in the lock mabey a lock smith if it needs a new ignition lock its not cheap to replace from honda

Dec 21, 2008 | 2004 Honda Accord

Not finding what you are looking for?
2004 Cadillac SRX Logo

Related Topics:

431 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...