Question about Toyota 4Runner

Open Question

My 2004 toyota 4runner beeps every 30 seconds when the ignition is off.

Posted by on

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: changing spark plugs in a 2004 toyota 4runner

check www.4x4wire.com i was just there looking for the same thing and found step by step directions on how to do it

Posted on Apr 19, 2009

  • 73 Answers

SOURCE: how do i replace rotors on a 4runner

remove the 2 bolts holding the front caliper on then just remove the rotor

Posted on Sep 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 TOYOTA 4RUNNER WILL NOT START CRANKS BUT NO SPARK


well if u got spark all u need now is fuel! when you turn key do u hear fuel pump working for the 3 seconds? do u smell fuel at engine intake?

Mar 25, 2013 | 2004 Toyota 4Runner

1 Answer

What could cause my 1992 toyota 4runner to suddenly stall and stop running?


Take your mass air flow sensor off and clean the thin wires inside of it with a non-chlronated brake cleaner.Then reset the computer by disconnecting the ground cable on the battery for 30 seconds.

Jan 20, 2012 | 1992 Toyota 4Runner

1 Answer

What type of oil should be used in a 2004 Toyota V6 4runner, natural or synthetic and what weight?


Any good API (American Petroleum Institute) approved 10w-30 0r 10w-40 oil is factory recommended. The question of Synthetic or not is a matter of personal prefs. If the rig has high mileage I might lean towards one of the synthetic blends instead of full synthetic. Syns are good, but if vehicle hasn't been using it since new, adding it may alter wear pattern of moving parts and start using oil. A blend is the best of both worlds.

Mar 08, 2011 | 2004 Toyota 4Runner

1 Answer

I need to know how to program a remote alarm control for a toyota 4runner 2000


f
1. Start with the following conditions: you are in the vehicle

a. Key is out of the ignition
b. Drive door is open ( all other doors are closed)
c. Driver door is unlocked (other door locks don't matter)

2. Insert the key into the ignition (don't turn it) and pull it out.

3. Perform these steps within 40 seconds:

a. Cycle the power locks 5 times. Use an even pace and try
to go relatively fast.

b. Close, then open the drivers door.

4. Perform these steps within 40 seconds:

a. Cycle the power locks 5 times (same as before).
b. Turn the ignition to ON then back to OFF.
c. Turn the ignition to ON then back to OFF.
d. Remove the key from the ignition.

5. Within 3 seconds, the power door locks should cycle (automatically)
indicating successful entry into programming mode. Return to step 1
if the locks do not cycle at this point.

6. Perform these steps within 40 seconds:

a. Press the LOCK and UNLOCK buttons on the transmitter
simultaneously for 1 second.

b. Immediately after letting go of the lock and unlock buttons,
press the lock button by itself and hold for 2 seconds.
Within 3 seconds, the door locks should cycle ( LOCK then
UNLOCK) once-- indicating successful programming. If
the door locks don't cycle, or cycle twice. Repeat steps
6a and 6b--this remote has not been accepted.

c. Repeat steps 6a and 6b for EACH transmitter that will
operate the vehicle. Including any old transmitters.

7. Close the driver door.

Also can check this procedure: http://www.toyota-4runner.org/60925-post2.html

Hope this help.

Mar 22, 2010 | 1997 Toyota 4Runner

2 Answers

Toyota 2003 4Runner: The check engine light and the vsc trac and vsc off light came on.


Check engine light. You will need a OBD II reader to retrieve the code.
Please let me know what you found.

Feb 07, 2010 | 2004 Toyota 4Runner

1 Answer

1997 3.4l 4runner misses at idle when first start


The coil packs on these engines will show signs of Arc tracing. Its a white shadow or line that runs along the rubber boot. if you see this. Suspect that coil of grounding and causing a misfire. Misfires usually occur after an electrical part is hot, the rough idle for the first 30 seconds sounds like another issue altogether, especially if it goes away after 30 seconds. Misfires from coils dont usually go away,,,,, they just get worse. Good luck . I also use this forum for my Toyota truck issues, I own one with the 3.4. heres the link http://www.tacomaterritory.com/forum/

Aug 24, 2009 | 1997 Toyota 4Runner

1 Answer

Maintenance light on dash how do you reset it had oil changed but they did not reset the light


Courtesy of www.synthetic-direct.ca

  • Turn the ignition key to the OFF position with the odometer reading shown.
  • Turn the ignition key to the ON position while holding down the trip meter reset button.
  • Hold down the button until the light goes off.
  • Before the light goes off, it illuminates for 3 seconds, flashes for 2 seconds, and illuminates for 1 second. If the system fails to reset, the light will remain flashing
Hope this answers your question. Best of luck.
Greg

Jul 22, 2009 | 2004 Toyota 4Runner

1 Answer

Maintenance light flashing


h) Engine Oil Replacement Reminder
Light (for vehicles sold in U.S.A.)
This light reminds you when to replace
the engine oil.
This light will come on when the ignition
key is turned to “ON” and will go off after
about a few seconds.
When you drive for about 8000 km (5000
miles) after the engine oil replacement,
this light illuminates for about 3 seconds
and then flashes for about 12 seconds
with the ignition key turned to “ON” position.
If you continue driving without the
engine oil replacement, and if the driving
range exceeds 12000 km (7500 miles), the
light will come on after the ignition key is
turned to “ON” position. The light will remain
on thereafter.
If the light is flashing, we recommend that
you replace the engine oil at an early
opportunity depending on the driving and
road condition. If the light comes on, replace
it as soon as possible.
You need to reset the light after the engine
oil replacement. Reset the light by
following the procedure below:
1. Turn the ignition key to the “OFF” position
with the odometer reading shown.
(For details, see “Odometer and two
trip meters” on page 136 in this Section.)
2. Turn the ignition key to the “ON” position
while holding down the trip meter
reset button.
Hold down the button until the light goes
off. Before the light goes off, it illuminates
for 3 seconds, flashes for 2 seconds and
illuminates for 1 second.
If the system fails to reset, the light will
remain flashing.


I copied this from page 143 of the owners manual for the 2004 4Runner

Jun 04, 2009 | 2004 Toyota 4Runner

1 Answer

Remote Start on 2008 Toyota 4Runner will not start truck


Is it a Toyota remote start, or an aftermarket remote start? If it is a Toyota remote start, make sure the hood and doors are all closed. press lock twice, then press lock a 3rd time and hold it for 3 or 4 seconds. It then should beep once, and a few seconds later start up. OR the lights will flass once, twice, or etc. Usually this means there's something wrong and the number of flashes is a diagnostic code of sorts. If this is the case, take it in to your dealer for further assistance. This part should be covered under the 3/36000 warranty.

If it is an aftermarket system, it will probably be a similar situation. It may be a misadjusted hood pinswitch, or even some blatent mistake the installer made installing it.

Mar 31, 2009 | 2008 Toyota 4Runner

4 Answers

Repair manual


Haynes - only covers till 2002

Chiltons - only till 2000

Your best bet is a Factory Service Manual for $19.95 download. Covers 2003-2009.

Thanks for using FixYa - a FixYa rating is appreciated!!



Feb 13, 2009 | 2004 Toyota 4Runner

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

30 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...