Question about 2005 Chevrolet Equinox

Open Question

Where is the sunroof control module located on a 2005 chevy equinox sunroof wont close

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
djicenova
  • 319 Answers

SOURCE: where and how to change cabin filter chevy equinox

cabin air filter is in the airbox behind the glove compartment,
unclip the glovebox, look behind it for a small access door, undo the latches, and voila! theres your cabin air filter! (if equipped, some model equinoxes dont have it!)

Posted on Apr 01, 2009

Ad
  • 79 Answers

SOURCE: 2005 chevy equinox temp gauge showing hot fan

check the coolant temp sensor

Posted on Mar 22, 2009

  • 69 Answers

SOURCE: MY SUNROOF WONT CLOSE

Check the owner's manual. There should be a section showing how to manually close the sunroof. You will use an allen wrench to turn the gears manually, I just don't know exactly what size or where the hole is located. It is typically located right behind the sunroof with a plug covering the hole in the headliner.

Posted on May 27, 2009

polarcycle
  • 1392 Answers

SOURCE: sunroof will not close

If the motor is stuck, you can probably hold the switch to the forward position, and smack the roof. This may allow the motor to start working. I don't think there is any way to do it manually.

Posted on Jun 15, 2009

  • 1 Answer

SOURCE: 2006 Chevy Equinox Sunroof Leak

Same problem on 06 Chevy equinox lt, Dealer said sunroof needed to get adjusted, its raining right now in San Diego and now the car wont start. water is in the same places, under the dash and floor mats. there is a bulletin posted for these cars about water leaking through several places, copy and paste the numbers along with the sign onto Google and its the first post. its a water leak guide for GM dealerships on the Equinox. hope it helps. #08-08-57-001A

Posted on Dec 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 04 Pontiac G6 4 door sedan the sun shade opens up no problem but when I try to open the glass the first one lifts up but that's it the other 3 pieces dont


Power Sunroof System Components
The power sunroof system consists of the following components:
• One tilting glass sunroof panel--For sunroof vent functions
• Three sliding glass sunroof panels, which allow the sunroof to open in sections
• Power sunshade panel--An adaptable panel which is rolled out or rolled in and stored by the sunshade motor/actuator in order to cover or uncover the sunroof glass panels
• Power sunroof switch--A rotary style switch controlling sunroof switch signal inputs to the sunroof motor/actuator
• Power sunshade switch--A momentary press style switch controlling sunshade switch signal inputs to the sunshade motor/actuator
• Power sunroof motor/actuator--Comprised of both the sunroof motor/actuator and the sunroof electronic control module, it is sometimes referred to as the sunroof control module/motor assembly.
• Power sunshade motor/actuator--Comprised of both the sunshade motor/actuator and the sunshade electronic control module, it is sometimes referred to as the sunroof slave module.
Sunroof Motor/Actuator and Sunroof Switch
The sunroof motor/actuator assembly is located at the rear of the passenger compartment, above the rear view window, between the headliner and the roof structure. The sunroof motor/actuator assembly also contains the sunroof electronic control module and the two components are serviced together as a unit.
Battery positive voltage is supplied to the motor/actuator at all times through the 25-amp LAMELLA ROOF fuse located in the rear fuse block. Whenever the ignition is turned to RUN or ACCESSORY, or when the retained accessory power (RAP) system is active, the motor/actuator is also supplied battery positive voltage through the accessory voltage circuit and the 10-amp ROOF/HEAT SEAT fuse which is located in the body control module (BCM). The sunroof motor/actuator is grounded through splice S403 to body ground G302.
The sunroof motor/actuator supplies voltage to the sunroof switch through three internal resistors and three hard wire circuits. The 3 hard wire circuits are:
• Sunroof switch data 1 signal circuit
• Sunroof switch data 2 signal circuit
• Sunroof switch data 3 signal circuit
The sunroof switch, which is also grounded to G302, is a rotary style switch. When the switch control lever is turned in a rotational direction, the appropriate switch contacts and signal circuits for the selected mode are simultaneously opened and/or closed to ground in order to provide the appropriate combination of voltage signals to the sunroof motor/actuator. The sunroof motor/actuator interprets the signals, and then applies battery positive voltage and ground to the appropriate circuits of the integral power sunroof motor in order to move the sunroof glass panels. At the same time, the sunroof motor/actuator sends a serial data message, via the keyword 2000 serial data circuit, to the sunshade motor/actuator to open the sunshade panel in conjunction with the sunroof glass. As the sunroof glass panels slide rearward to the open position, the sunshade motor/actuator simultaneously rolls in the adaptable sunshade panel.
The sunroof switch is mounted in a bezel which is located above the rearview mirror.


Circuit/System Description
The sunroof system is controlled by the sunroof switch and the sunroof control module/motor assembly, which is also known as the motor/actuator assembly.
The sunroof control module is supplied battery positive voltage at all times through the 15A SUNROOF fuse located in the rear fuse block. Whenever the ignition is turned to RUN or ACCESSORY, or when the retained accessory power (RAP) system is active, the module is also supplied voltage through the accessory voltage circuit and the 10-amp ROOF/HEAT SEAT fuse located in the body control module (BCM). The sunroof control module is grounded through the ground circuit at G302.
The sunroof control module supplies voltage to the contacts of the sunroof switch through the sunroof switch close signal circuit and the sunroof switch open signal circuit. The sunroof control module also supplies ground to the switch contacts through the sunroof switch low reference circuit. When the switch is operated, the contacts and signal circuit for the selected mode are closed to ground, the voltage is pulled low in the module, and the appropriate signal is recognized by the control module. The control module then internally applies battery positive voltage and ground to the appropriate circuits of the reversible power sunroof motor in order to move the sunroof glass panel to the open, close, or vent


Do you know how to do electrical testing ?
Circuit/System Testing
Ignition OFF, disconnect the harness connector at the sunroof control module.
Ignition OFF, test for less than 1.0 ohm of resistance between the ground circuit terminal 1 and ground.
? If greater than the specified range, test the ground circuit for an open/high resistance.
Ignition ON, verify that a test lamp illuminates between the ignition circuit terminal 3 and ground.
? If the test lamp does not illuminate, test the ignition circuit for a short to ground or an open/high resistance.
Verify that a test lamp illuminates between the B+ circuit terminal 6 and ground.
? If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
Connect the harness connector at the sunroof control module.
Ignition OFF, disconnect the harness connector at the sunroof switch.
Ignition OFF, test for less than 1.0 ohm of resistance between the low reference circuit terminal B and ground.
? If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, test or replace the sunroof control module.
Ignition ON, test for B+ between the signal circuit terminal C and ground.
? If not the specified value, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, test or replace the sunroof control module.
Test for B+ between the signal circuit terminal A and ground.
? If not the specified value, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, test or replace the sunroof control module.
If all circuits test normal, test or replace the sunroof switch.

Oct 13, 2017 | Pontiac Cars & Trucks

1 Answer

2005 equinox sunroof control module location?


Sunroof Control Module (CF5)
Under the headliner, at the right rear of the sunroof module assembly

Jun 07, 2017 | Cars & Trucks

2 Answers

Where is the ecm module located on a 2005 chevy equinox


You know where the battery box is, correct?
power train control module 1-ap2cgkv0253u0vxn2pgvni5t-4-0.jpg

power train control module 2-ap2cgkv0253u0vxn2pgvni5t-4-2.jpg

Mar 26, 2017 | Cars & Trucks

1 Answer

2005 chef Equinox brake light wiring diagram


http://bbbind.com/free_tsb.html free wiring diagrams !
Stop Lamps
The 15A BRAKE fuse located in the fuse block - underhood, supplies battery positive voltage to the normally open stop lamp switch. When the driver presses the brake pedal, the switch contacts close and battery positive voltage is supplied to both left and right stop lamp assemblies, the center high mounted stop lamp (CHMSL), the powertrain control module (PCM), and the throttle actuator control (TAC) module. The stop lamps are grounded at G401 and G403. The CHMSL is grounded at G301.

Jul 23, 2016 | 2005 Chevrolet Equinox LT

1 Answer

How to manually close my 2005 chevy equinox sunroof


there is no access to do this. only way to close it would be to disengage the sunroof from the tracks and motor very difficult to
do best to bring it to experienced tech

Dec 03, 2014 | 2005 Chevrolet Equinox

1 Answer

My friends got an equinox is getting partial power while his vechile is off but his altenaor isnt bad. What can be the problem?


CHEVROLET EQUINOX 2005 Safety Report #10128539 CHEVROLET EQUINOX 2005 car safety problem was reported on July 11, 2005.CHEVROLET EQUINOX 2005, manufactured by GENERAL MOTORS CORP. had a problem with POWER TRAIN:AUTOMATIC TRANSMISSION . PURCHASED 2005 CHEVY EQUINOX ON MAY 26 2005 HAVE HAD IT AT THE DEALER 5 TIMES IN THE PAST 47 DAYS 1ST THE SUNROOF STOPPED WORKING, THEN THE TRANSAXLE OVERHEATING LIGHT CAME ON GOT THOSE "REPAIRED" DIDN'T GET OFF THE DEALERS LOT AND THE LIGHT CAME ON AGAIN THEY CHANGED SENSOR BROUGHT IT BACK THE NEXT DAY AND WAS TOLD THEY FOUND A CHAFFED WIRE IN THE MAIN HARNESS YESTERDAY I HAD IT TOWED IN AFTER ENGINE LIGHT AND TRACTION CONTROL LIGHT CAME ON FELT LIKE WHEELS DIDN'T WANT TO TURN AND ON HILLS HAD NO POWER TO CLIMB I LIVE IN THE MOUNTAINS OF PA WILL NEVER BUY ANOTHER CHEVY.Mileage was 2400 miles.Problem was reported in ALBRIGHTSVILLE, PA.
CHEVROLET EQUINOX 2005 Safety Report #10128539

Dec 17, 2010 | 2005 Chevrolet Equinox

3 Answers

2006 Chevy Equinox Sunroof Leak


Same problem on 06 Chevy equinox lt, Dealer said sunroof needed to get adjusted, its raining right now in San Diego and now the car wont start. water is in the same places, under the dash and floor mats. there is a bulletin posted for these cars about water leaking through several places, copy and paste the numbers along with the sign onto Google and its the first post. its a water leak guide for GM dealerships on the Equinox. hope it helps. #08-08-57-001A

Jul 30, 2009 | 2005 Chevrolet Equinox

2 Answers

2005 Chevy Equinox sunroof problems


Some customers may comment that the sunroof will no longer respond to the control switch while in a vented, partially opened, or fully opened position.
Cause A software issue with the sunroof control module may cause the sunroof control module to incorrectly indicate a "closed" position, which may result in no power to the sunroof motor.
Correction Verify the customer concern. If a condition is present, replace the sunroof control module with a new sunroof control module, P/N 15847643. Refer to the Service Procedure in this bulletin.
Service Procedure
  1. Verify the customer concern by opening and closing the sunroof. • If the sunroof will not open , check the power windows. - If the power windows are also inoperative, check the fuse. If the fuse has opened, refer to Corporate Bulletin Number 05-08-64-004 to install 30A circuit breaker. - If the power windows are fully functional, refer to "Power Sunroof Inoperative" diagnostics (SI Document ID# 1392967) in the Body section of the 2005 Chevrolet Equinox or Saturn VUE Service Manual. • If the sunroof will open (or is already open), but will not close , proceed to Step 2.
  2. Replace the sunroof control module. Refer to "Sunroof Control Module Replacement" procedure in the Body section of the 2005 Chevrolet Equinox Service Manual (SI Document ID# 1196049) or Saturn VUE Service Manual (SI Document ID# 1710479).
  3. Open and close the sunroof in order to confirm that the customer concern has been resolved.
Parts Information Part Number
Description
Qty
15847643
Sunroof Control Module
1

Jun 20, 2009 | 2005 Chevrolet Equinox

Not finding what you are looking for?
2005 Chevrolet Equinox Logo

Related Topics:

354 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8514 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...